Answered: Calculate Zab, the equivalent impedance…

Engineering

Electrical Engineering

Calculate Zab, the equivalent impedance with respect to terminals a-bat 10 Hz. Give your answer in rectangular form

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter2: Fundamentals

Section: Chapter Questions

Problem 2.6P: (a) Transform v(t)=75cos(377t15) to phasor form. Comment on whether =377 appears in your answer. (b)...

See similar textbooks

Related questions

Q: Find the input impedance of a 100N transmission line of length 0.5A connected with a load 100 +…

A: Given: Characteristic impedance, Z0=100 Ω load impedance, ZL=100+j100 Ω Transmission line length,…

Q: Find the Pourier Series when the A=30, T=2ms =0,4 ms determine the voltage when the Frequency equl…

Q: A three – branch parallel circuit, with Z1 = 25 ∠ 15° Ω, Z2 = 15 ∠ 60° Ω, and Z3 =15 ∠ 90° Ω, has an…

A: Z1=25∠15°; Z2=15∠60°;…

Q: Find AVERAGE true power for an RLC circuit with given parameters. Z= 3277 ohms, R = 1000 ohms…

A: The solution is given below

Q: Load flow analysis is used to calculate ________________ a. Transmission losses b. voltage…

A: Load flow analysis is a mathematical analysis which use various computational method to analyze the…

Q: In series reactive power compensation, the series capacitors are not used to increase the…

A: In series reactive power compensation,

Q: Ouestion #6 The boged T netwalk is operoting in the Steady State with v= 2cost. , = Deteomine 9)…

A: In this question , we will find currents in steady state...

Q: For the admittance locus diagram shown below: find the value of each element in the circuit if w=377…

Q: Find the equivalent impedance Zab in rectangular form at terminals a-b. Zc N 10 Ω. ZL N Zab 10 N. b…

A: According to the question we have to find the value of Zab.

Q: The transmission line in Figure Q.1 (a) now is shorten to L=λ/4 and the input impedance Zin is set…

Q: Use a shorted stub to match the load impedance ZL = (25 + j40)N to the 50 Q transmission line.…

Q: Determine the Thevenin equivalent phasor voltage, VTA, with respect to terminals a – b. Give your…

Q: Solve for the admittance, Yab, of the circuit shown. (magnitude only)

Q: . Characteristic impedance of a transmission line is 502. Input impedance of the open circuited line…

A: Given, Characteristics impedance of transmission line, Zo=50 Ω Impedance of open circuit line,…

Q: determine the total equivalent impedance

A: The solution can be achieved as follows.

Q: For the circuit shown in figure 1, calculate the equivalent impedance of the network, assuming a…

Q: for the

Q: 1. Determine the equivalent impedance and the equivalent admittance. -jion jisn 12n

Q: used bridge circuit la| To measure unknown capacitive impedances while using a bridge circuit aii To…

A: Analog instruments are classified into 3 types Indicating instrument Integrating type instrument…

Q: Find the admittance Y_ab in the circuit seen in the figure. Express your answer in both polar and…

A: given here a electrical network and asked to find the Yab .

Q: 2. Explain why Phasor and impedance diagrams have the same angles. 2 II/L of Phacon shift if D 2000…

A: We are authorized to answer one question at a time, since you have not mentioned which question you…

Q: AC power suppye (1)3Dr(t).i(t)%3DV_I cosot.cos(of -0. power can be introduced as a function real…

A: The instantaneous power is the power at a given instant.…

Q: Obtain Zbus for the following system O.9225 1-25 10.25 (ALLare tu mpedances)

A: Obtain Zbus for the following system.

Q: Z = 40 + j20 Ω, Z, = 25 Ω Z = 2 + j, Z, = 50 – j30 Ω,

Q: Derive the equation for impedance and phase shift for series RLC circuit connected to the AC…

A: A series RLC circuit is formed by connecting a resistor, inductor, and capacitor in series across a…

Q: Determine the impedance seen by the source Vs

Q: uestion 2 Network admittance values are essential to find the with respect to currents Nodal…

A: Right Answer option Nodal Voltage

Q: A series RL circuit takes a current whose equation is i = 0.85 sin(754t - 60°) A when connected to a…

Q: The admittance (Y) of a circuit is the sum of the phasor current to the phasor voltage. True…

A: In this question, Check the given statment is true or false? The admittance (Y) of a circuit is…

Q: An impedance, such as Z₁ = 5 - j3 (22), is a phasor. True False

A: Given data, Impedance, Z1=5-j3 Ω

Q: Given the circuit below, find the new impedance if the frequency were halved. Round off to 4 decimal…

Q: The formula to determine the total impedance of two parallel impedances is the sum of the impedances…

A: In this question , some statement given about circuits...We have to find that they are true or…

Q: For the admittance locus diagram shown below: find the value of each element in the circuit if w=377…

A: Equivalent Circuit Diagram: For first branch:…

Q: A load impedance ZL Find two designs using open-circuited stubs. 100 + j80 2 is to be matched to a…

A: Single shunt stub tuner is used for the impedance matching. This is used while a short circuit and…

Q: g- The angular frequency for the waveform v(t) = 10 sin 2000t is: 1- 1000HZ, 2- 1000rad/s. 3- 2000…

Q: For the series RLC circuit shown here, calculate i) impedance, ii) total current, ii) phase angle,…

Q: given R 1508 , and L H, 1508 at w= 377 rad/s, what type of component, Zp, is needed in parallel to…

Q: Problem 02: A resistor which conductance of G = 50 mS is connected in parallel with an inductor…

Q: For the given circuit calculate the maximum power that can be transferred from the circuit to the…

Q: A three–branch parallel circuit, with Z1 = 25 ∠ 150 Ω, Z2 = 15 ∠ 600 Ω, and Z3 =15 ∠ 900 Ω, has an…

A: Fig: Given circuit Calculate current flowing through given loads…

Q: A load impedance ZL = 200 + J160Ω must be married on a 100Ω line using an open parallel estub tuner.…

A: A load impedance ZL=200+j160 Ω must be matched on a 100 Ω line using an open parallel stub. We need…

Q: 1. If the impedance of this box at 1600 rad/s is Z = 50 – j25, what would be the impedance at @ =…

Q: Problem 6 (AC Power Analysis) Find the complex power (S), apparent power (S), real power (P),…

A: In this question, In this circuit, find the complex power, apparent power S, real power P and…

Q: 2. Calculate inductive reactance (Xc) and total impedance (Z;)

Q: 16) Find (a) the total impedance, (b) total current and (c) the current flowin through each…

Q: B. Determine the phase angles by which between vl(t) and i1(t), then draw both signals in time and…

A: Given: v1t=4sin377t+25°v1t=0.5cos377t-20°

Q: transform the star-network into the delta equivalent and calculate total impedance Zab, Zac, Zbc, as…

Q: Question 9 Given: C, L When w = 100 rad/s, find the equivalent impedance Zab in rectangular form at…

Q: A TRANSMISSION LINE WHOSE CHARACTERISTIC IMPEDANCE (Zo=1002) iS CONNECTED TO A LOAD IMPEDANCE AT ITS…

A: Given ZL = 2150 -200 j ohm Zo = 1002 ohm Zc : Calibrated load impedance. By using the given…

Question

Given R = 600 ohm and 86 = mH and C = 0.00012 F

Find Zab

Given: R, L, C.
05 Calculate Zab, the equivalent impedance with respect to terminals a - b at 10 Hz. Give your
answer in rectangular form

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Sinusoids and Phasors of Alternating Circuit

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Let a 100V sinusoidal source be connected to a series combination of a 3 resistor, an 8 inductor, and a 4 capacitor. (a) Draw the circuit diagram. (b) Compute the series impedance. (C) Determine the current I delivered by the source. Is the current lagging or leading the source voltage? What is the power factor of this circuit?
Find a. Total admittance and impedance in polar form b. Sketch admittance and impedance diagram c. Find the value of C (in microfarad) & L (in henries) d. voltage E, and IR, IL, and IC in phasor form
Two impedances of Z = 100 +j50 Q and Z2 = 20 -j20 Q are connected in series. what is the magnitude of the equivalent impedance in 2? %3D %3D Your Answer: Answer
A certain impedance has a phasor voltage of V = 2521° across it and a phasor current of I = 3450° through it. Determine the value of the complex impedance in rectangular form.
P 269 W, Q = 150 VAR (capacitive). The power in the complex form is: %3D Select one: a. 150 + j269 VÀ b. None of these c. 150- j269 VA d. 269-j150 VÀ
a) total impedance [ZT] in polar form, b) value of C in microfarads, c) current [ I ] in phasor form, d) resistor voltage [VR] in phasor form
Convert the following to polar form and computethe product. Compare the result with that obtainedusing rectangular form.a. (50 + j10) (4 + j8)b. (j2 − 2) (4 + j5) (2 +j7)
A series circuit has 50 ohm resistance, 2.22 microfarad capacitance and inductance of 8 mH. Find the total impedance at 796 Hz frequency. a. 50-j150 b. 50+j50 c. 50-j50 d. 50+j130
for the R-th part. isn't R3 and R5 in series not parrallel? If not, explain why. If so, fix the solution. THank you.
Impedances Z1=5.83<-59 and Z2=8.94<63.43 are in series and carry and effective current of 5.0 A. Determine the REACTIVE POWER in VAr. Show your solutions.
Write a report to compare between Ac Through capacitance and AC through in inductance then: For the circuit shown beside, find the total impedance between a (and b and Circuit current (I j6N a 100 0 v 82 -j72 b
draw the thevenin equilvalent circuit and determine the load impedance for maximum power transfer. show the final circuit with appropriate resistors, capacitors, and/or inductors.