B/ Find the diameter of the particles with specific gravity of 1.2 removed in a tank having a surface area of 240 m² and treating 6 million liters per day (MLD)? Assume temperature 260C and specific gravity of particles S.G = 2.65. 1 X T = 26°C, pw = 0.99681 × 103 kg/m³ and uw = 0.8746 × 10-3 kg m sec 15.00

B/ Find the diameter of the particles with specific gravity of 1.2 removed in a tank having a surface area of 240 m² and treating 6 million liters per day (MLD)? Assume temperature 260C and specific gravity of particles S.G = 2.65. 1 X T = 26°C, pw = 0.99681 × 103 kg/m³ and uw = 0.8746 × 10-3 kg m sec 15.00

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

Q.7(a) Complex forming agents can be used to determine hardness of water how? Explain with the help of following points. (i) Principle (ii) Chemical reactions (iii) Structure (iv) Calculations. (b) Calculate the quantity of lime and soda required for softening one million litre of the following sample of water. If the purities of lime and soda are 80% and 85% respectively. The impurities are Silica = 75 mg/lit. MgCl2 = 19 mg/lit. MgSO4 = 30 mg/lit. CaSO4 = 68 mg/lit. MgCO3 = 884 mg/lit. CaCO3 = 120 mg/lit. (c) Discuss different chemical methods which have been used for the synthesis of nanomaterial with special reference to temperature and solvent along with their advantages and disadvantages.
Question 4.5 A rock sample has a length of 20.32 cm and a diameter of 5 cm. The pressure profile inside the core sample is given below, where nitrogen of viscosity 0.0178 cP is flowing at a constant rate of 55 cm³/s. What is the permeability of the sample if the flow is in accordance with Darcy's law? 450 400 350 - 300 250 - P [psig] 200 150 100 - 50 1 3. 4 7 8 9. Distance from inlet [in] 6
2.28. A groundwater is being considered for use as a domestic supply. The water has a temperature 15°C and the following chemical analysis: CONSTITUENT Ca+2 Mg Nat Fe +2 Cd+ HCO3 SO4 CO3 NO3 CONCENTRATION. g/m³ 190 84 75 0.1 0.2 260 64 30 440 35 a. Use an anion-cation balance to determine if the sample analysis is reasonable. b. What is the hardness of the water? c. Determine the alkalinity of the water. d. Estimate the sample pH. e. Would the water be an acceptable domestic supply? Why or why not?
Calculate temporary and permanent hardness of a sample of water, which on analysis is found to contain the following: Ca(HCO3)2 = 16.2 mg/L; Mg(HCO3)2 = 7.3 mg/L; MgCl2 = 9.5 mg/L; CaSO4 = 13.6 mg/L.
. A sample of water contained the following salts in mg/litre.Ca(HCO3)2= 40.5,MgS04= 30 CaS04= 34Mg (HCO3)2= 36.5 CaCl2= 27.75Calculate the amount of lime and soda required to soften 20,000 litres of water
(b)Calculate the quantity of lime and soda required for softening one million litre of thefollowing sample of water. If the purities of lime and soda are 80% and 85%respectively. The impurities are Silica = 75 mg/lit. MgCl2 = 19 mg/lit. MgSO4 = 30mg/lit. CaSO4 = 68 mg/lit. MgCO3 = 884 mg/lit. CaCO3 = 120 mg/lit.(c) Discuss different chemical methods which have been used for the synthesis ofnanomaterial with special reference to temperature and solvent along with theiradvantages and disadvantages.(d) Doping can be used to increase conductivity of the substances, explain with examples.What are array and modules? Discuss their working.
Q. 4. 1 ppm CaC03 equivalent hardness is meant byA : 10 mg CaC03 equiv. Per litreB : 100 mg CaC03 equiv. Per litreC : 1 mg CaC03 equiv. Per litreD : 103 mg CaC03 equiv. Per litre
A. Find Liquid Limit B. Find Plastic Limit C. Plasticity Index D. Liquidity Index
The mean indoor airborne chloroform (CHCI) conc. in a room was detemined to be 0.4 ug/m3. Use the following data, T = 293 K, P = 1 atm, R = 82.05 x 10-6 atm- m3 /mol- K. Atomic weights: C = 12, H = 1, CI = 35.5. %3D %3D This concentration expressed in parts per billion (volume basis, ppbv) is equal to
R. Kommalapati, Ph. Solve the following Calculate the Molarity, and mg/l as CaCO3 for 200 mg/l H3P04 (i)
The following data is for 1 g sample of granular powder Volume of solid = 0.3 cm¹ / g Volume of interparticle pores = 0.1 cm³ / g Volume of spaces between particles = 1.6 cm³ / g Find true volume and bulk volume . Calculate porosity
The back fill material for a vibroflotation project has the following grain sizes. D10 D20 D50 D25 D75 0.11mm 0.20mm 1.3mm 0.60 1.60 35. Determine the suitability number. a. 19.3 b. 18.0 С. 17.8 d. 20.4 36. Calculate the sorting coefficient. а. 1.581 b. 2.798 C. 1.633 d. 3.546