B = C = [1 1] Transform the system equations into the controllable canonical form.

Q: Find The Powers suppLied by all Soures by using Loop Anglygis M12R 1oov (+ 4A

A:

Q: QI Find the Power Supplied by all Sources."by using s Loop analysi 122 100 V 4A 52 3iX

A:

Q: A 500-turn coil is wound on an iron core. When a 120-V-rms 60-Hz voltage is applied to the coil, the…

A: The solution is given below

Q: The 3-phase balanced load star-connected has impedance per phase of Zy=8+j6 ohm. If the load…

A: It is given that: Zy=8+j6 ohmV=208 V

Q: In OP-AMP, input pin is denoted by a negative sign

A: In this question we will write which input pin in opamp is denoted by a negative sign..

Q: Describe the resulting waveforms when the capacitors (initially 20uF and then replaced with 100uF)…

A: The output waveforms are as shown below,

Q: PROBLEM: Given a unity feedback system that has the forward transfer function K(s + 2) (s2 – 4s +…

A:

Q: Vo Of the given circuit below. 32 V ID1 ID2 Ge Si o Vo 6.8 kohms 4 V O 39.3 V O 31.7 V O 31.3 V

A:

Q: 4. Determine Vo. (a) 42 VI OM O Vo I, 13 32 I 3Ω I,

A:

Q: Electrical Engineering In what connections the third harmonic is not exist?

A: In this question we will write about connection in which third harmonic is not present....

Q: Design a simple op-amp circuit which will--- Sinusoidal wave (2V p-p, 1kHz) to amplified Square wave…

A:

Q: 2.13 Let the BJT of Fig. P2.13 have B, = 120, V, = 100 V, and BR = 2. Vs(5 V) Vs(5 V) R2 Ic R2 10 kN…

A: The BJT circuit diagrams are shown below, Where,βF=120VA=100 VβR=2

Q: Assignment A' Derive the state table and the state diagram of this sequential circuit T. B' C' CLK

A: The solution is given below

Q: If 20 V be applied across AB shown in figure 7, calculate the power dissipated in resistor b.…

A:

Q: Solve for Vc of Figure 43. T21V R2 R1 32.1ko 3500kQ Vc Q1 Beta = 110 VE R3 1.2kQ Figure 43 O 20.26V…

A: In this question,   We need to determine the voltage VC  if the current gain beta = 110V Assume…

Q: HW2: Given the following system: y(n) = y(n – 1) - y(n – 2) + x(n) 1) Determine the response of the…

A: We need to find output for given system .

Q: 04) Determine the current Ih and Iz for the network of the figure below R1 1.3 K D1 D2 3.3 K R2 E=20…

A: In this question we will find current I1 and I2....

Q: Discuss how the Torque is developed in an Induction Motor

A: Gy

Q: In a given circuit below is connected to an AC signal with 240V peak in a 4:1 transformer. Sketch…

A: It is given that:

Q: If 20 V be applied across AB shown in figure 7, calculate the power dissipated in resistor f.…

A:

Q: Problem:- Given the system defined by the following equation, find the transfer function, T(s) =…

A: In this question we will find transfer function of given control system...

Q: Shown in Fig. P2.39 is a BJT realization of the logic function known as NOR. (a) Assuming L = 0 V…

A: The circuit is as shown below, For a suitable beta value, the circuit works as a NOR gate.

Q: 1.) Given points M(1, –2, –1), N(3, –3, 0), and P(-2, 3, –4), find |37p – 3TM| and ânm-

A:

Q: A stone is dropped from top of a tower 50 m high, at same time another stone is thrown upward from…

A: Total height of the tower h = 250 m Stone is thrown at velocity of 25 m sec from the foot of the…

Q: For the following circuit, answer the following R4 R1 5002 R2 2.0kQ R5 1.0kΩ R3 3.0k2

A:

Q: Homework X(z) = For the conditions in below - 1- 1.5z-1+0.5z-2 이리 > 1 • Iz| < 0.5 • 0.5 < |z| < 1…

A: Given

Q: Calculate the voltage gain of inverting OP AMP if R2 =94kohms and R1 = 4.7kohms O -10 O -20 O +10 O…

A:

Q: By using The ven in's theorem, find the current and voltage through the Sur resistor. 6 A 30V

A:

Q: c) Silicon when doped with i) Group V element ii) Group III element Describe in terms of no of…

A: c. i) Pure silicon is an intrinsic semiconductor. when it is doped with Group V element, it is…

Q: The coupling capacitor Cc must be large enough to in an RC coupling scheme. O a. Pass dc between the…

A: We are authorized to answer one question at a time, since you have not mentioned which question you…

Q: Problem :- Given the system defined by the following equation, find the transfer function, Tis) =…

A: Brief description : In the above given question they have mentioned state matrix representation of a…

Q: 8. The resistance of a conductor depends only on the cross sectional area of the conductor. True…

A: The resistance of a conductor is given by R=ρLA Where ρ is resistivity, L is length of conductor and…

Q: If a regulator has a consequence frequency of 2.2x10-2 failure/year, what will be the frequency if…

A: Given data is  Regulator consequence frequency =2.2×10-2 failure/year  Failures per month are…

Q: Q Point charges of 50nC each are located at A(1, 0, 0), B(-1, 0, 0), C(0, 1, 0), and D(0,-1, 0) in…

A: In this question we have given point charges at different points....We have to find out total force…

Q: Verify if each of the following circuits functions like an SR latch? What happens when S = R = 1 for…

A: Brief description : Flip flops are the bistable multivibrator circuits. Flip flops have only two…

Q: 2- Converging meniscus lens (n = 1.5) has a concave surface whose radius is – 20 cm and a convex…

A: Given: Reflective index, n=1.5Radii of curvature of the surface,R1=-20 cmR2=12 cm

Q: A single-phase half wave controlled rectifier, operating at 120 V rms and 60 Hz ac supply, has a…

A: Given a single phase half wave controlled rectifier has, Operating voltage, Vrms=120 V Peak voltage,…

Q: 6. Calculate the current through R-102, R-102, and R-202. What is the potential difference V- Va.…

A: To calculate current through R1, R2, and R3, Also calculate the potential difference between Vb and…

Q: following equations, find the system transfer functions: (a) d²y dt2 + 7y = 6r dr Ans. 6/ (s? + 3s…

A: According to Bartleby question answer rule I have to solve first three subpart of a question hence I…

Q: Pet the ciremlr shown, find the eurrent lowing throgh the 4A esistarwhen ica) & 2V ,(6) 12 V ,e>a 20…

A:

Q: 1. Fill the below table with the components used in building the circuit (Figure 1), and their…

A: The band stop filter is designed by using the combination of low pass and high pass filter. The…

Q: The content of a 16-bit memory location is 0101100110010111. What is the decimal value of the…

A:

Q: This is the very small amount of current flowing through on a reverse-biased diode large current O…

A:

Q: Problem: The sequence components of phase A currents are: la0 = 0.47 + j1.49 A la1 = 18.4 cis -…

A: Given sequence components of phase A currents :  Ia0=0.47+j1.49 A=1.562∠72.5° A Ia1=18.4∠-31.6°…

Q: For the following circuits, rank the following total current (highest to lowest) R I1 12 CR R. R.…

A:

Q: 10 V 2 k2 2 kaz 2k

A:

Q: For h() =eu) and x() - cos 2t Determine the value of each variable in the Fourier series…

A:

Q: In a fixed-bias configuration, the voltage level of VGS is equal to O a. Vs O b. none of these O .…

A: In this question,   We need to choose the correct options In a fixed bias, the level of VGS   is…

Q: RF carrier 10 kV at 1 MHz is amplitude modulated and modulation index is 0.6. Peak voltage of the…

A: Given an amplitude modulated signal with, Carrier voltage, Vc=10 kV Modulation index, μ=0.6

Q: Byusing The ven in's theorem, find the current and voltage through the sur resistur. 302 30V

A: In this question,   We need to determine the current in the 5 ohm resistance and voltage across the…

Compensation Techniques

The compensation techniques are the methods that are employed in the electrical control systems to enhance the performance of the system. The performance are generally affected by the factors like lag in the compensating devices, slow response of the system of the components like sensors used in the control system. The basic compensation technique involves lag compensation, lead compensation or the combination of the both.