Answer in Sentence/Paragraph form. Maximum of 5 sentences each.   Lesson: Electronics: Half-Wave Rectifier with and without Filter 1. What is Peak Inverse Voltage of the Half-Wave Rectifier? 2. What is a rectifier? 3. What is the output frequency of bridge rectifier? 4. What are the ripples?

Q: 28. A full-wave bridge rectifier with a 120-V rms sinusoidal input has a load resistor of 1 kſN. a.…

A: As per the guidelines of Bartley we supposed to answer first three subpart only for solution of…

Q: 05- An earth station is receiving a signal from a space research satellite on a frequency of 6GHZ.…

A: We need to find out power density and received power and effective area of antenna

Q: The voltages of a balanced source are VAB = 120 cis 0° volts, VBC = 120 cis (– 120°) volts, and VCA…

A: Balance source: Balance source means that all three-phase magnitude is equal and the angle is…

Q: The initial values of in and iz in the circuit shown in Figure Q1(b) are +3A and -5A respectively.…

A:

Q: Problem: Five linear components of complex impedances Z1, Z2, Z3, Z4 and Z5 are connected as it is…

A: Given: Consider the following circuit: Here, To find: A) Find the average power that each…

Q: 38 +16 V Si Si ´ Si oVo 4.7 k2 -4 V Figure 3 Determine the voltage output Vo and the current I of…

A:

Q: EXAMPLE 1 Determine the magnitude of gm for a JFET with Ipss 8 mA and Vp = -4 Vat the following de…

A: In this question we will find transconductance of given JFET....

Q: 8.00 V o 40 ka ww 20 k2 20 ka 40 k2 10 kQ 8.01 V o Fig. 10 Refer to figure 10. Assuming ideal…

A:

Q: 7.5 kn 5 kn 10 Vo 2 kn 6VO- Determine I and Vout o Vout SITY

A: In this question,   We need to determine the output voltage and current i as shown the circuit.  We…

Q: Find the value of RL for maximum power transfer in the network and the maximum power that can be…

A: In this question,  We need to determine the resistance RL  and maximum power transfer to the load?…

Q: For a certain p-channel JFET, VGS(off) = 10.16 V. The value of VGS in for midpoint bias is

A: We need to find out value of VGS at mid point

Q: 03: With the help of Maxwell's equations prove that the intrinsic impedance is: jup o+jwe

A:

Q: (B)- Indicate whether the following statemenits are true or false and correct the false statements |…

A: In this question we will write about field diverter method , Eddy current loss, dc series motor....…

Q: 3. A six pole three-phase 440-volts 50Hz, induction motor develops an 8-Hp at 955 rpm, the power…

A:

Q: resistor R and an impedance coil Z are connected in series. The combination is supplied by a…

A:

Q: Question 17 In Frequency Division Multiplexing (FDMA) users are allocated a unique: O Code. Time…

A:

Q: anode of a diode is connected to one terminal of a 1-KΩ resistor.  The other terminal of the…

A: We need to find out current for given circuit

Q: What is the per unit impedance of a 50 MVA, 13.8 kV, 1% impedance transformer if the base is change…

A:

Q: Determine the DC Voltage for a bridge rectifier with a 115 Vrms, 60 Hertz primary transformer. The…

A: In this question,   We need to determine the DC Voltage for a bridge rectifier?  Load is RC filter…

Q: For the circuit shown below, use the superposition theorem and solve for the following: a. The…

A:

Q: Compose the mesh equations. 10 Q j10 O j10 2 ll ell 10 V [11] [12] :-10 2 sine sine

A:

Q: Compose the mesh equations. 10 Q j10 Ω j10 Ω ... ell A) 10 v [1] sine ) i5 v j5 V sine -j10 O [12]…

A: In this question,   We need to determine the current I1 and I2 as shown the circuit?

Q: Differentiate the two types of three-phase induction motor

A:

Q: To place a text on the plot using a mouse, the command used is MATLAB a) gtext O b) text O c)…

A: To place a text on the plot using a mouse, the command used is ......

Q: O Calculate the photon energy of violet, blue, green, orange and red lights.

A:

Q: The speed of a 2 pole SCRIM at no load is; Synchronous speed c. Constant speed d. Infinity а. b.…

A:

Q: 3 2 x[n] 1 1 -3 -2 -1 0 1 2 3 4 5 7 8.

A:

Q: 12 v (+ Transform the circuit such that the 3 k2 resistor is le unchanged and the final circuit…

A: In this question we will find current i using source transformation and power dissipation in 3 kilo…

Q: 10Ω ir iL VR Find i,, VR and Ig of the circuit given that the frequency of the voltage source is 10…

A: In this question,   We need to determine the current iL  and voltage VR  and current IR

Q: A 46KV 0.8 lagging power factor load is connected to the end of a short transmission line where the…

A:

Q: Determine the magnitude of gm for a JFET with Ipss =12 mA and Vp = -7 Vat the following de bias…

A: As per company guidelines, we are supposed to answer the first 3 subparts of the question. Kindly…

Q: A resistor of 6 ohms and an unknown impedance coil in series draws 12A from a 120V, 60 HZ line. if…

A:

Q: Solve the output FIND CURRENT FLOWING THROUGH Z1 FIND CURRENT FLOWING THROUGH Z2

A: The given circuit is as shown below with mesh currents and assumed current directions in each…

Q: VCc 24V R1 6on 600 01 R2 MP SA05 Vin -0 V -

A: Brief description : For the given BJT we need to calculate the value of all the DC parameters. Here…

Q: Are the voltages across the resistor, capacitor, and inductor are not in phase? Explain

A: In this question,   We need to explain which elements are not phase current with voltage?

Q: A satellite transmitter operates at 4 GHz with an antenna gain of 40 dBi. The receiver 40,000 km…

A: satellite transmitter is a communication satellite using radio wave it send signal to antenna of…

Q: A resistor R and an impedance coil Z are connected in series. The combination is supplied by a…

A: As per our company guidelines we are supposed to answer only first 3 subpart kindly repost the other…

Q: 5. Find VcCor), dvccot) /at, ¿ co), di cot) dt to32V 5 uF Iov 3MA joke

A: In this question,   We need to calculate the voltage Vc   and current I as shown the circuit at time…

Q: Find the z-transform of an–1.

A: In this question,   We need to Find the z-transform of an-1

Q: A transformer with a 240-V ac primary voltage and a 6:1 turns ratio has an output voltage of O 1,440…

A:

Q: -5 V Si O V Si 2.2 k2 6 -5 V Figure 2

A:

Q: 0 20 V 2.2 k2 '390 kΩ B= 140 Fo-100 kΩ V 1.2 kΩ

A: Voltage gain: It is the positive value and is the ratio of the output voltage and input voltage.

Q: Find tu oser ad sinusoidal for m of the expressión V 4) = 10 sin (300ot +100) - 5 sin (300ot -75) +…

A:

Q: Complete the table. Solve the currents of the circuit using mesh analysis.Note: If there are no…

A: In this question,   We need to determine the loop currents as shown the circuit

Q: four pole 2-Hp, 220-volts, 60-Hz, 3-Phase motorhas a delta connected stator and a Wye connected…

A: We are authorized to answer three subparts at a time, since you have not mentioned which part you…

Q: Solve the voltage V1 of the given circuit below. Si +32V 4.7ks Vo + V1 - V2 8k2 - 8V 8.6 V 14.52 V…

A:

Q: 4.2.Two generators, G1 and G2, have no-load frequencies of 61.5 Hz and 61.0 Hz, respectively.  They…

A: In this question we need to find a system frequency and  the power contribution of each generator…

Q: The analog signal ra (t) = e(240nl+) +e is sampled at F, = 300 Hz. What is the xpression for the…

A:

Q: 5 2 12 + 15 L0 O20L0° 10 L90° V. V V 3-j4

A: The solution is given below

Q: Reduce the biock diagram. H. R. G, G. G H, Q2

A:

Speed control of motor

Speed control by DC motor-speed controller is required to realize variable speed drive. Whenever a motor drives a particular load, it is called drive, and variable speed drive refers to a load requiring variable speed. All this is obtained by a DC motor speed controller.