All rigid bodies are .. elasticO partiallyO FullynonO none of the above

A rigid body is a solid body in which changes by deforming forces are zero. Or it may change but in…

Answered: All rigid bodies are .. elastic

Science

Physics

All rigid bodies are .. elastic

University Physics Volume 1

18th Edition

ISBN:9781938168277

Author:William Moebs, Samuel J. Ling, Jeff Sanny

Publisher:William Moebs, Samuel J. Ling, Jeff Sanny

Chapter7: Work And Kinetic Energy

Section: Chapter Questions

Problem 6CQ: Why is it more difficult to do sit-ups while on a slant board than on a horizontal surface? (See...

See similar textbooks

Related questions

Q: If the mass of the girder is 3 Mg, determine the tension developed in cables AB, BC, and BD for…

A: Find the tension in the cable AB FAB = 3000 x 9.81 = 29430 N FAB = 29.430 kN Find the tension in…

Q: A cantilever beam is subjected to an inclined force (P) as shown in Figure 1, the equilibrium normal…

Q: A tension force of 10 N is applied to a wire of cross-sectional area of 1x10 m², the wire stretched…

A: Given: A tension force, F = 103 N; Cross-sectional area, A =1×10-4 m2; The wire is stretched by 0.2%…

Q: Answer must be according the correct signifcant numbers.

A: Given that: Length of the strut is 5 m.

Q: A 5cm2cord has original length of 120cm is pulled by a 20N force. The change in length in the cord…

Q: A thin rectangular plate is uniformly, deformed, as shown. Determine the shear strain y, at P.…

A: Given values, a = 21in b = 29in c= 0.16in d = 0.28in We have to calculate shear strain for the…

Q: A 18 cm long tendon was found to stretch 5.4 mm by a force of 14.0 N. The tendon was approximately…

Q: A physics student in an elevator, places a 200.0 g mass on an electronic balance. The palance,…

A: lift is travelling upward with decreasing speed the elevator is travelling downward with increasing…

Q: shaft of bone 1.2 m long. If the strain is 1.3x (10) ^(-4) when the leg supports his weight, by how…

A: The amount of length led shortened is =strain ×length =1.3×10^(-4)×(1.2m)=1.56×10^(-4) m

Q: A 5cm^2 cord has original length of 120cm is pulled by a 20N force. The change in length in the cord…

Q: Find elasticity of y w.r.t x when 2x"y° =4Ae' where a,b, and A are Cons tant

A: Elasticity is defined as the ratio of percentage of y to percentage change of x. That is, it can be…

Q: The center of gravity, CG (X,Y) of the composite material below is at 4 ст __ - - 4 cm 4 ст 8 ст

A: Consider the rectangle as section 1 and the triangle as section 2. Write the area and centroid of…

Q: What are characterstic of rigid body?

A: A rigid body is a body whose form is perfectly definite and unchanging. The distances between…

Q: Write down the conditions that must be satisfied for an object or structure to be in equilibrium?

A: The two key conditions for a rigid-body equilibrium are to be stated.

Q: The simple truss is loaded by a system of forces as shown in the figure. The truss is supported by a…

A: Given: P=800 lb. Note: Use the section method to analyze the problem.

Q: A 45 cm x 45 cm square plate ABCD of uniform thickness is supported by three vertical strings. The…

A: We would consider the equilibrium of plate. ∑T=0∑τ=0

Q: Write Griffith’s expression for the fracture stress of a material under plane stress conditions.…

A: To find: Write Griffith’s expression for the fracture stress of a material under plane stress…

Q: A 300N child sits on the left side of a see-saw 1.5m from the center. Where should a 375N be placed…

A: Given, F1=300 N r1=1.5m F2=375 N Let r2 be the distance where 375 N is placed.

Q: The 3m long uniform plank is supported by a fulcrum at the midpoint. Where a 45kg student should…

A: Mass of person1 : m1 = 30 kg Mass of person2 : m2 = 40 kg Mass of person3 : m3 = 45 kg Position of…

Q: All rigid bodies are . elastic

A: Rigid body is actually when particles don't have any relative displacement between any two particles…

Q: when a bouncy ball strikes a surface, does the surface experience inelastic deformation, or does the…

A: Inelastic deformation is the change in shape due to inelastic collision.

Q: A steel ring of radius r and cross-section area A is shifted on to. a wooden disc of radius R (R >>…

Q: o is when a force causes compression and the object shrinks * O Inertia compressive stress, O…

A: Answer:- tensile stress Sigma is when a force causes compression and the object shrinks - tensile…

Q: A trapeze artist with swing weighs 800n; he is momentarily held to one side by his partner so that…

A: Let the tension in the string of the swing be T, the total weight of the trapeze artist with swing…

Q: When you bend a meterstick, one side is under tension and the other is under compression. Which side…

A: Bending of the stick is represented below.

Q: A uniform ladder is 1:

A: The questions are answered below

Q: What is translating rigid body?

A: To determine,What is translating rigid body.

Q: A taho vendor carries a 1.5 m long light plank over his shoulder. At the end of the plank are two…

A: SOlution: Given that Length of plank L = 1.5 m weight of buckets W1 = 40 N, W2 = 60 N

Q: steel is placed on a steel incline table that has a µs o applied horizontally to the table in order…

A: Given values:- Mass of steel,(m)=2 kg ----(1) Coefficient of static friction,(μs)=0.23 ----(2)…

Q: A perfectly balanced body, weighing 327 N, is supported by a 42 cm diameter water jet with constant…

Q: A 5.0-m weightless strut, hinged to a wall, is used to support an 650-N block as shown. The vertical…

A: The weightless strut is hinged to wall and supporting the 650 N block. Where FH = F Sinθ…

Q: he block does NOT slip while resting on the circular surface?

Q: Steel nails are rigid and unbending. Steel wool is soft and squishy. How would you account for this…

A: In case of steel nail, the composition of the material is rigid and uniform, because the density of…

Q: what is the compression in the boom?

A: Horizontal cable.... So T = 4500 N is along x axis F = 7500 N is along -y axis The resultant of…

Q: A 15-cm-long tendon was found to stretch 3.7 mm by a force of 13.4 N. The tendon was approximately…

A: Given data: The original length of the tendon is, L0= 15 cm=0.15 m The change in length of the…

Q: What is equal and opposite to the applied force on a sp equilibrium

A: What is equal and opposite to the applied force on a spring? Equilibrium spring constant…

Q: The point that identifies the fracture point of the material whose graph of stress as a function of…

A: Answer d) 5

Q: A vertebra is subjected to a sheering force of 500 M. Finel shear defo hmationy taking the rertebra…

Q: What and where is the neutral layer in a beam that supports a load?

Q: The pole in the figure is at a 90° bend in a power line and is therefore T. ubjected to more shear…

A: Young's modulus is the slope of the linear part of the stress-strain curve for a material under…

Q: In the linear region of the Strain vs. Stress diagram is called Elastic Modulus *

A: Elastic Modulus= Stress/Strain In linear region, stress is proportional to strain.

Q: A horizontal force of 1.3 N is applied to the top of a stack of pancakes 16 cm in diameter and 8.5…

A: Force, F = 1.3 NLength, L = 8.5 × 10-2 mShear deformation, ∆x = 2.4 × 10-2 mDiameter, d = 16 × 10-2…

Q: The boom of tge wall crane 4m long is held at right angle to the wall by a wire that is attached to…

Concept explainers

Mechanical Properties of Solids

There are three types of matter- solid, liquid and gas. Out of them, solids have a rigid shaped and size. The intermolecular forces of attractions in solids are greatest. Mechanical properties are the physical properties of a material which it shows, when it is provided with certain amount of force or load. These properties are to be kept in mind for various purposes. When a force is applied to an object, the object may or may not get deformed depending upon its elastic property. But every time the object develops a restoring force against the force applied. This is commonly known as stress. If the object changes its dimensions due to the force applied it develops strain ( which is the ratio of change in dimension to the original dimension).

Question

All rigid bodies are .. elastic
O partially
O Fully
non
O none of the above

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Step by step

Solved in 3 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

THIS SUBJECT IS DYNAMICS OF RIGID BODIESSHOW COMPLETE AND CLEAR SOLUTIO0N
Quèstion 12 All rigid bodies are.. elastic O partially O Fully non none of the above
For the loading shown, determine (a) the equation of the elastic curve for the " cantilever beam AB, (b) the deflection at the free end, (c) the slope at the free end. Given: L-15 ft; w=2 kips/ft, El-flexural rigidity-2x100 lb.in³
5N 10N What is total normal force working on the top book? 15N
25. Hungee Jumping Wyatt is tied to one end of a 40-m elasticized (bungee) cond. The other end of the cord is secured to a winch at the middle of a bridge. II Wyatt jumps off the bridge, for how long will he fall before the cord hegins to streich? (Use 49-s.)
Can the conservation of energy be used to solve problems involving elastic impact, which assumes that the body is rigid?
Find elasticitty of y w.r.t x when 2x"y° =4 Ae' where a,b, and A are cons tant
A bridge, constructed of 11 beams of equal length LLL and negligible mass, supports an object of mass MMM as shown. (Figure 1)Real bridges of this sort have steel rockers at the ends (check one out sometime), these assure that the support forces on the bridge are vertical even when it expands or contracts thermally. Throughout this problem, use g for the magnitude of the acceleration due to gravity. A bridge, constructed of 11 beams of equal length LLL and negligible mass, supports an object of mass MMM as shown. (Figure 1)Real bridges of this sort have steel rockers at the ends (check one out sometime), these assure that the support forces on the bridge are vertical even when it expands or contracts thermally. Throughout this problem, use g for the magnitude of the acceleration due to gravity. A bridge, constructed of 11 beams of equal length LLL and negligible mass, supports an object of mass MMM as shown. (Figure 1)Real bridges of this sort have steel rockers at the ends (check one…
Each bone in the chain of bones forming your spine is separated from its neighbors by disks of elastic tissue. What happens, then, when you jump heavily onto your feet from an elevated position? (
. Give two everyday examples of objects that are not in static equilibrium.
Your doctor's scale has arms on which weights slide to counter your weight, Fig. 9–35. These weights are much lighter than you are. How does this work? Weights FIGURE 9-35 Question 4.
(6) Explain why forces in muscles and joints are largest when their load is a long distance from the joint.