active band pass filter Why does the graphic appear like this in this case discuss it?

Q: Consider the following sampled signal x[n]. What is the cyclic frequency in the sampled signal if…

A:

Q: What are the circumstances in which a Kalman filter should be employed?

A: Kalman filter is designed in order to determine the future states of a given system by using the…

Q: Q3: Answer the following A/ What is the operation amplifier application withdrawing (only five)? B/…

A:

Q: Find the ß Rnction, frequency of B function, frequency escillation and R¢ E the circuit shown below?…

A:

Q: Show and explain in detail the Mathematical Equation of Phase Modulation (

A:

Q: Summarize the differences between passive filter and active filter in terms of gain, cost and…

A: You have asked multiple independent questions. We are authorized to answer one question at a time.…

Q: noise which may be created within a receiver

A: Power noise- When signal is transmitted then the amount of noise or unwanted signal added to the…

Q: using R = 1K, C=0.1uF. What voltage gain are we expecting from the RC filter at the oscillator's…

A: The op-amp is used in the inverting mode; therefore any signal that appears at the inverting…

Q: Define linear phase filters. Explain why we use linear phase filters.

A: In Linear phase filter the term linear phase signifies that   a filter whose phase response  is the…

Q: Choosing a discrete value that is near but not exactly at the analog signal level leads to Select…

A: There is nothing called PCM , PAM error  Sampling error is with respect to frequency sampling not…

Q: Q6/ A signal having bandwidth equal to 3.5 KHz is sampled, quantized and coded by a PCM system. The…

A: The sampling rate will be fs⩾2.fm=2×3.5 kHz= 7 kHzSignalling rate is v.fs=v.7 kbpsThe channel…

Q: in Active Band Pass Filter Discuss the meaning of the quality factor and how band-pass filters are…

A: The quality factor is also known as figure of merit. the quality factor of an active band pass…

Q: A linear delta modulator is designed to operate on speech signals limited to 4 kHz. The…

A: Given data:

Q: Draw the band pass filter using op-amp and its frequency response curve.

A: The ability of a Band Pass Filter, or any filter for that matter, to pass…

Q: 2. What is a filter? Why it is necessary? Explain with circuit diagram?

A: Filter is an electrical circuit used to remove unwanted frequency components from the given signal…

Q: The following saw tooth signal is use d as a reference signal to generate pulse modulation signal. 3…

A: According to the question, for the given reference signal as shown below a) Draw the circuit…

Q: b) Describe by drawing the low pass filter, high pass filter and band pass filter in terms of their…

A: 1. Low pass filter - The low pass filter only pass the low frequency signals. it allows signals from…

Q: Provide a sample problem with correct solution regarding percentage modulation involving frequency…

A: The sample problem is as follows.

Q: Discuss in detail the practical benefit of at least one of each type of passive filter (low, high,…

A: The low pass filter in detail: A straightforward uninvolved RC Low Pass Filter or LPF can be…

Q: Q2. Determine the Nyquist rate and Nyquist sampling interval for the signal, g(t) = sinc? 100t.

A: We need to find out sampling frequency.

Q: the filter specification and the output signal.

A:

Q: a) An operational amplifier has to be designed for an on-chip audio band pass IGMF filter. Explain…

A:

Q: Ques2: What is the Low pass filter? Drive an expression of gain of Active Low and draw its frequency…

A: The low pass filter is a type of filter that only allows low frequency signals from 0Hz to its…

Q: Discuss the meaning of the quality factor and how band-pass filters are classified.

A:

Q: Q1: Define filters and explain the types of filters, compare between active and passive filter?

A: Filter: It is a circuit that is used to select a particular frequency. It can blocks or pass the…

Q: What is active low pass filter?Explain it's impact and application in engineering problem.

A: Active low pass filter: It consists of active components like Op-Amps, transistors and FETs along…

Q: Draw block diagram /circuit diagram of the ff. FM circuits and discuss the operation.   c. RATIO…

A: According to the question, we need to Ratio detector

Q: Sketch the overall output waveform, Vo(t).

A: The output waveform is

Q: What is a spike in noise term

A: ANSWER  NOISE--->                                    Noise is a…

Q: Brief explanation of kalman filter

A: Kаlmаn filtering is аn аlgоrithm, thаt рrоvides estimаtes оf sоme unknоwn vаriаbles given the…

Q: Figure Q.4(c) shows a Schmitt Trigger circuit. Assuming that the output will saturate at ±Vsat = ±12…

A: We need to solve given problem . The given circuit is inverting Schmitt trigger circuit.

Q: What is band pass filter? Explain with the circuit diagram.

A: The band pass filter is a type of filter which allows the frequency in the specific range of the…

Q: Instrumentation What is the difference between CRO and DSO? Show their applications.

A: According to the given question, it is required to determine the difference between CRO and DSO…

Q: in adaptive filter what does the word adaptive refer to

A: Filters which can obtain desired characteristic for automated processing without changing other…

Q: Short answer please. What are the main disadvantages of designing the band reject filter, mentioned…

A: In the given circuit, the main disadvantage is that both the capacitor are of different sizes.…

Q: in Active Band Pass Filter briefly discuss Discuss the effect of increasing the order of the…

A: The detailed answer is solved below according to the given parameters and instructions in the…

Q: A lincar delta modulator is designed to operate on speech signals limited to 3.4 kHz. The…

A:

Q: Description and discussion of Discussed active band pass filter in the circuit below

A: Band Pass filter- The principal characteristic of a Band Pass Filter or any filter for that matter,…

Q: Question 5 (a) With the use of suitable diagrams explain why it is necessary to employ anti-aliasing…

A: anti aliasing filter uses

Q: Q5: Design an Armstrong indirect FM modulation to generate an FM signal with carrier frequency 97.3…

A:

Q: operation of filter

A:

Q: What will be the ratio of amplitudes of largest (maximum) signal to smallest (minimum) signal to…

A: The ratio of the amplitudes of maximum signal to the minimum signal to which the system is subjected…

Q: (a) Summarize the differences between passive filter and active filter in terms of gain, cost and…

A:

Q: - Calculate the first five sample values and sketch of the following discrete-time signals:

A:

Q: Discuss the disadvantages of increasing the order of the filter.

A: Order of filter :   the maximum number of delay elements used in the filter circuit is known as…

Q: empt QI. Design a second order active bandpass filter to pass signals within a bandwidth of 4 kHz…

A:

Q: Q1: In a delta modulation process, the step size is 0.05 v and sampling rate is four times the…

A: We need to find out the amplitude of message signal

Q: What is active filter? Write its four advantages compared to passive filter

A: It contain active components such as operational amplifiers, transistors within their circuit…