A water well is excavated, and has a cylindrical form. The water level in the well is 2 meters from the level ground. What is the absolute pressure experienced by a dipper at a depth of 1.5 meter in the water?

A water well is excavated, and has a cylindrical form. The water level in the well is 2 meters from the level ground. What is the absolute pressure experienced by a dipper at a depth of 1.5 meter in the water?

University Physics Volume 2

18th Edition

ISBN:9781938168161

Author:OpenStax

Publisher:OpenStax

Chapter2: The Kinetic Theory Of Gases

Section: Chapter Questions

Problem 85AP: The mean flee path for helium at a certain temperature and pressure is 2.10107 m. The radius of a...

See similar textbooks

Similar questions

The gage pressure of air in a pressurized water tank is measured simultaneously by both a pressure gage and a manometer. The differential height h of the mercury column is to be determined. Assumptions The air pressure in the tank is uniform (i.e., its variation with elevation is negligible due to its low density), and thus the pressure at the air-water interface is the same as the indicated gage pressure. 90 kPa SG= 0.72 75 cm Air Water 30 cm Mercury SG= 13.6
A planet's atmosphere contains a perfect gas with polytropic equa- tion, p = Ap, where p is the pressure, p is the density, y is the polytropic index and A is a constant. Assuming that the acceleration due to gravity, g, is practically constant with height: a) i) show that the expression of the ratio of the pressure, p (at a vertical height z from the surface in terms of the surface pressure), to Po (the surface height), and the surface temperature To is: ²₁ = (₁ - (^² = ²¹); (2) Р 1 Po where y is the adiabatic constant and the gas constant is R. g RT. -Z ii) Use the equation in 1) a) i) to find the numerical value of the temperature lapse dT/dz, given that g = 9.8 m/s², R = 287 Nm/kg K, and y 1.23. =
In a lab a ft long test tube contains gas (density equals 748.9 km/m3) and oil ( density equals to 950 kg/m3). the gas occupies the upper half of the tube while the oil occupies the lower half of the test tube. Compute for the pressure at the middle of the tube ( at the interface between oil and gas)
An object with a density p object the case where Pliquid < Pobject otherwise it floats partly or wholly submerged. when placed in a liquid with a density of p will sink in liquid A wooden block with original volume 32.0 cm³, had a hole with a volume of 2.0 cm³ drilled into it. This hole was then filled with lead. Hint: Consider this equation when answering the questions that follow: [(Density of wood) x (Volume of wooden block without lead)] + [(Density of lead) x (Volume of lead)] = Total mass of block a. Calculate the total mass of the wooden block containing the lead b. Calculate the new density of the wooden block containing the lead. c. Will this block sink or float when placed in water? Explain your answer. d. Consider the situation when the original wooden block (32 cm³ of pure wood) is drilled with a hole of a certain volume and filled completely with lead such that it results in a state where the block is just about to sink in water. What would the volume of this hole need to…
The volume flow rate of liquid refrigerant-134a at 10oF (ρ = 83.31 lbm/ft3) is to be measured with a horizontal Venturi meter with a diameter of 6 in at the inlet and 2 in at the If a differential pressure meter indicates a pressure drop of 7.5 psi, determine the flow rate of the refrigerant. Take the discharge coefficient of the Venturi meter to be 0.98.
A water well is excavated, and has a cylindrical form. The water level in the well is 2 meters from the level ground. What is the absolute degree pressure Celsius)experienced by a dipper at a depth of 1.5 Meeting in •Genera! meter in the water? (Assume water is at 4 degree celcius)
Additional Info: ∫ vdP is integral of volume with respect to Pressure ∫ pdV is integral of pressure with respect to Volume. Please give solutions to the given questions in the problem.
The capillary pressure of a rock was measured in the lab using water mercury system where the IFT is 35 dyne/cm and the measured contact angle is 10°. Convert a pressure of 600 kPa, obtained using mercury-water system, to a reservoir pressure if the IFT value of oil-water is 25 dyne/cm with 35 degrees contact angle. (kPa)
A water drop is observed to fall through a gas of density 0.001g/cm3 with a constant velocity of 980cm/s. What is the radius of the drop. The coefficient of viscosity of gas is 2*10 raise to power -4 poise.
For an elevation of water (Z = 10m). If piezometric head is 100m, then piezometric pressure is equal to %D
Consider the sealed containers (same fluid and on the same ground level) below with heights given in a and b values.Provided that b = 2a, answer the following items. If a = 2 in, and the density of the fluid is 60 lbm/ft^3, what is the pressure at point B in psia?
Poiseuille's Law gives the rate of flow, R, of a gas through a cylindrical pipe in terms of the radius of the pipe, r, for a fixed drop in pressure between the two ends of the pipe. (a) Find a formula for Poiseuille's Law, given that the rate of flow is proportional to the fourth power of the radius. Use k for the proportionality constant. R(r) = (b) If R = 350 cm³/sec in a pipe of radius 2 cm for a certain gas, find a formula for the rate of flow of that gas through a pipe of radius r. R(r) =