A thick walled cylinder with an inner diameter 44 mm and an outer diameter 70 mm is made from a material with a yield stress of 170 MPa. The cylinder has open ends and is subjected to an internal pressure. At what pressure will the cylinder initially yield? Give your answer in MPa to 2 decimal points.

A thick walled cylinder with an inner diameter 44 mm and an outer diameter 70 mm is made from a material with a yield stress of 170 MPa. The cylinder has open ends and is subjected to an internal pressure. At what pressure will the cylinder initially yield? Give your answer in MPa to 2 decimal points.

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

What is the stress in a rectangular rod that is 20 mm by 30 mm in cross-section if is supporting a load of 1000 N? Express your answer in N/m2, Mpa, and psi.
Determine the maximum normal stress (in Mpa) in bar ABCD if the cross-sectional area of the bar is A = 556 mm2 and P= 36.79 kN. Round off the final answer to four decimal places.
Question 5 Determine the outer diameter (mm) of a tubular rod subjected to an axial force of 22 kN if it developed a stress of 40 MPa. Take note that the inner diameter is 4/6 of the outer diameter.
A thin cylinder of inner radius 500mm and thickness 10mm is subjected to an internal pressure of 5 MPa. The average circumferential (hoop) stress in MPa is
The figure shows 16-mm diameter bolts used to hold two steel plates by fitting inside a cylindrical spacers. Thenormal stress must not to exceed 230 MPa in the bolts and 160 MPa in the spacer. Determine the outer diameterof the spacer.
A knuckle joint is used to connect two circular rods. The tensile force applied is 50 kN. The tensile stress in the rod and the shear stress in the pin are 25.46 MPa and 35.37 MPa, respectively. Determine the required diameter of the rod and the pin in mm.
A metal block of cross-section area A and length L is subject to a tensile stress of S. The block elongates by a length of 0.002L. Another block made from the same metal is subject to the same tensile stress. If this block has a cross-section area of 2A and a length of 2L, determine the elongation of the block.
Calculate the stress in the steel from the given figure. Use P1=300 kN and P2=45 kN. Answer in MPa
Find the thickness of a metal needed of the semi-spherical end of cylinder vessel 0.70 meter in diameter to an internal pressure of 2.70 N/mm2. The material is mild steel and tensile is 69 N/mm2
Determine the outer diameter (mm) of a tubular rod subjected to an axial force of 53 kN if it developed a stress of 52 MPa. Take note that the inner diameter is 2/6 of the outer diameter. Hiiii i am having a hard time. It is kinda urgent tysm i appreciate u sm
Pls answer thank you! Determine the safe wall thickness of a 26 inches steel tank with internal pressure of 8 Mpa. The allowable stress of material is at 93.33 Mpa. The factor of safety is 3.
A circular rod is stretched by a force of 3kN. Solve the diameter of the rod if the stress is not to exceed 153MPa.