a) The output power of a 24 GHz pulse radar is 30 dBm and the radar antenna gain is 20 dB. The received power should be at least 1 µW. Calculate the max range of the radar. The scattering coefficient of the target is 2 m².

a) The output power of a 24 GHz pulse radar is 30 dBm and the radar antenna gain is 20 dB. The received power should be at least 1 µW. Calculate the max range of the radar. The scattering coefficient of the target is 2 m².

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Related questions

Q: Determine the values of Ta, T, Tp, T, when the control system shown in Figure 10-28 is subject to a…

Q: Design a synchronous counter with the irregular binary count sequence shown in the state diagram in…

Q: The high voltage side of a particular transformer has 5516 turns while its low voltage side has 788…

A: In this question, We need to determine the primary side current of the transformer. Given…

Q: 27 an ac circuit has a frequency of 400 hz. A 16 ohm resistor, 0.0119 inductor and a 16.6 capacitor…

Q: da 6₂ www 63 gVz od₂ G₂ di L de 2 8 d3 ds find the no de equations (v=Ri

Q: Consider an LTI system depicted in figure below with the input sequence x[n] = (-0.5)" µ[n]. find…

Q: For the negative-feedback system the open-loop transfer function G(s) and feedback gain H(s) are X +…

Q: Is it less expensive to operate the electric heating unit in Question 12 on 240 V or 120 V?

A: It is less expensive to operate the electric heating unit in question 12 on 240V Or 120V?

Q: Problem D continued b. Determine Vout for the given input signal SIG Rx 20k Ry 5k Vcc o- Vcc/-Vcc…

A: Given, Circuit is Rx = 20k Ohm. Ry = 5k Ohm. Vcc = +10 V; The input wavesform is We need to draw…

Q: Find the magnitude of the response of the following system given below resulting from the sinusoidal…

Q: P5.50. Consider the circuit shown in P5.50Figure. Find the phasors VS, I, VL, VR, and VC. Compare…

A: Given data: Vs(t) = 10 cos(104t), R =100 Ω, L=50 mH, C= 0.2 μF, To find: We have to find Vs, i,…

Q: For the system of resistors shown in the figure below, find the electrical bill (or cost) that you…

Q: [13] Given the following pulse trains for A, B and C, draw the pulse trains for F₁ and F₂. B A F₁…

Q: 10. The ABCD constants of a lossless three-phase, 500-kV transmission line are A=D=0.86+j0,…

A: For a lossless three-phase, 500kV transmission line,The ABCD constants…

Q: A 60-HP synchronous motor is connected to 240 volts. The motor is to be operated at 90% PF. The…

A: The given problem requires us to determine the size of copper conductors with type THW2 insulation…

Q: The question I am having trouble with is: Design a 3 bit sequential circuit using D flip flops and…

A: We need to design a 3-bit sequential circuit using D-flipflops and one input 'X'. If X =0 => no…

Q: Question2. Consider the system given by following system equation y(t) = cos [x(t)] a) Determine if…

Q: P 10.9-1 Using a phasor diagram, determine V when V V₁ V₂ + V3 and V₁ = 3+j3, V₂ = 4+j2, and V3 = -3…

Q: C R₁ +++ Rf Vo For the op-amp filter circuit shown above, assume C₁ = 10nF, R₁ Find the passband…

Q: 4xya, + 2(x² + z²)a, + 4yza,

Q: a) A given PM signal is: PM (t) = 10 cos [90×10° πt+200 cos 2000 t] Determine the carrier frequency…

Q: A fuel injector of inductance 6 mH and resistance 2 2 requires a minimum current of 3 A before it…

A: At,t=0,It0=0A, In steady state, Inductor behaves as a short circuit. Now, the equivalent circuit…

Q: List the visual checks that should be made on a piece of portable electrical equipment before using…

A: We need to write list of visual checks that should be made on a piece of portable electrical…

Q: Capacitor banks and reactor banks are installed in the substations to increase the transmission line…

A: Step-1-> Capacitor banks and reactor banks are not installed in substations to increase the…

Q: R₁ ΤΩ E₁5 V 1 +1 R₂ 1+ E₂ 6 Ω +1 2 10 V 12 R3 www + ΖΩ What are the loop equations (in standard…

A: Given Circuit: To Determine: Loop equations for loop-1 & loop-2…

Q: In the given circuit, the amplitude of the input voltage is 160 Volts RMS and its phase is 35…

Q: 1. Two long solenoids are placed on the same axis as shown in the figure. The inner solenoid has…

Q: 2. The textbook describes a circuit for comparing two 4-bit numbers, A = a3ª2ª1ª0 and B = b3b2b₁b0.…

Q: Example 1 Amplitude of carrier signal is given 10 V, and free 20MUC This carrier is modulated by 16…

A: Given: Carrier signal has, amplitude Ac=10 V and frequency fc=20 MHz. Carrier signal is modulated…

Q: Given Diodes and Terminal Labels identify the terminal if its Anode/Cathode

A: For the given diodes symbol and actual component, the name of the terminal with respect to given…

Q: In the field below, enter the binary result of the following calculation. The numbers are given…

A: The signed number is represented by sign magnitude or r's complement number. The 1's complement…

Q: Q4. Find a) The Thevenin equivalent circuit between the terminals a and b. b) The maximum power…

Q: Compute the Fourier transform of following signal 1 + cos πt, t ≤ 1 { |t| > 1 x(t) = 0,

Q: 2k Vout

Q: using the node-voltage method to find the power supplied by the 60V voltage source in the figure…

A: In this question, We need to determine the power supplied by the 60V source. We know Power P= VI…

Q: Show the working principles of plotting the load angle. In addition, specify which region (cut,…

A: Here R1=9kΩ,R2=3kΩ,RC=2kΩ,RE=3kΩ,β=100.

Q: Bonus) Z-75-100 f=1.09 GHz C1 C L1 L=? R1 R=500 Find the values of C1 and L1 that cause the…

A: Given data R1=50 Ω Z=75+j0 Ω f=1.09 GHz To find out We have to determine the value of L1 and C1.

Q: Determine the quality factor for Maxwell's inductance-capacitance bridge given below when the bridge…

A: From given Maxwell's inductance-capacitance bridge

Q: Self inductance of an inductor with toroidal geometry is 231 nH. The total number of turns of this…

A: It is given that: L=231 mHN=16I=17 A

Q: Problem For the circuit shown below, Find: a) io b) i, c) i₂ d) v Note: 1. please provide 2. show…

A: given an electrical circuit

Q: 1. Label 3 currents and all resistor voltages. 2. Write 2 KVL equations and 1 KCL equation. 3. Write…

A: It is given that:

Q: 1- a) Compare the behavior of D latch and D flip-flop devices by completing the timing diagram given…

Q: a) The circuitry of a microprocessor is composed of conductive routes that are referred to as buses.…

Q: For a sinusoidal input of 20 Vpeak to the given circuit, what is the peak value of the * ?output…

A: Peak voltage is given as Vp=20 V. Given circuit diagram is,

Q: HOLE Ampet 4.2 tjon 2.2 2g (t) = 10 cosine 377t Amps.

Q: 2=R÷jX 1. What is the definition of impedance? How to calculate impedance for resistor, inductor and…

A: given that voltage applied V = 10 cos2t+30° V frequency ω = 2 radians

Q: 22 a capacitor and resistor are connected in parallel to a 120v,60 Hz line the resistor has a…

Q: V1, V2, and V3 are inputs, io is the current across the 25 ohm resistor, and V2 is the voltage…

A: Given Data: A DC circuit of, Consider the node voltages and branch currents as above. To Find:…

Q: a) Consider a light wave traveling through air and reflecting off of two nonmagnetic pieces of…

A: According to the question, a) Consider a light wave traveling through air and reflecting off of two…

Q: Self inductance of an inductor with toroidal geometry is 231 nH. The total number of turns of this…

A: Self inductance L = 231 nH. Total number of turns in inductor N = 16. Current flowing through toroid…

Concept explainers

Antenna Characteristics

The antenna is an important concept in the domain of electronics and communication engineering. An antenna forms an integral part of many commonly used devices such as wireless modems, routers, game controllers, mobile phones, bluetooth devices, and so on. In simple terms, any wireless communication makes use of antennas to serve the purpose. An antenna, also known by the term 'arial', is an electrical device that converts electrical signals into electromagnetic waves or electromagnetic waves into electrical signals. An antenna contains a transmission line usually made up of co-axial cable, it then receives the signals and converts them into electromagnetic waves, which are then transmitted via space into their required destination. A communication system essentially makes use of two antennas, a transmission antenna, which converts electrical signals into electromagnetic waves, and a receiving antenna, which receives the electromagnetic waves and converts them back into electrical signals.

Question

a) The output power of a 24 GHz pulse radar is 30 dBm and the radar antenna gain is 20
dB. The received power should be at least 1 µW. Calculate the max range of the radar.
The scattering coefficient of the target is 2 m².

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1: Explanation of radar equation and given data in question.

VIEW

Step 2: Putting the given values in radar equation and solve.

VIEW

Solution

VIEW

Step by step

Solved in 3 steps with 3 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

ATR works by measuring the changes that occur in an internally reflected IR beam when the beam comes into contact with a sample.. True False
b) Fill in blanks with a suitable answer 1. The bandwidth of an antenna can be broader by increased the... 2. Radiation pattem is . . dime nsional quantity 3. One steradian is equal to . . square degrees 4. The minimum value of the directivity of an antenna is. . 5. The radiation resistance of short dipole is given by... 6. Gain is equal to directivity in case of ... 7. Radiation resistance of antenna is.. .
Explain the working of Amplitude comparison type of 2D- monopulse radar.
The radiation resistance of an antenna is 55 Ohm and the loss resistance is 10 Ohm. Determine the antenna efficiency, power radiation and directivity of the Antenna Gain, 25 and Power input, 5W.
4) What are the advantages and disadvantages of planar array antenna array?
What are the applications of linear array antennas?
What is the principle of frequency reuse in the context of a cellular network? What is the difference between diffraction and scattering?
In an antenna array, the array factor depends on Tick all that apply. O Radiation pattern. O Relative excitation magnitude. Efficiency of each element O Relative excitation phase. Beamwidth. Number of elements Input resistance. O Operating frequency. O Spacing between elements O Directivity of elements
1- The HPBW of 22 antenna equal to......... 2- The side lobes appear in a loop antenna when 3- The conditions of the end-fire array antennas are and 4- The PLF-0.5. in the angle between the transmitted and received signal is 5- When no reflection from the antenna, the Return Loss (RL) equal to 6- In order to increase the radiation resistance of the loop antenna WWE is required.
For a superheterodyne receiver, the intermediate frequency is 15 MHz and the local oscillator frequency is 3.5 GHz. If the frequency of the received signal is greater than the local oscillator frequency, then the image frequency (in MHz) is........…...
Find the wavelengths of (a) a 450 MHz, (b) a 650 MHz, (c) an 8 MHz, and (d) a 850 KHz signal.?
PLEASE SHOW ALL WORK 2. Following plot is the radiation pattern of an antenna. Determine: a) Antenna gain in dBi and dBd b) Front to back ratio in dB. (Show calculation steps by marking on the diagram)