A tennis ball is projected toward a smooth surface with speed v as shown. Determine the rebound angle e'and the final speed v'. The coefficient of restitution is 0.70. Assume e = 54°. e' Answers: v' = i V

Q: vard and extend the arms while placing an object into the trunk of a car. Assum driver lifts a 60-lb...

A: A=90°V=0H=10inD=25inFM=1Ld, CM=0.95 RWLORG = 5110H1-0.0075v-300.82+1.82D(1-0.0032 A)xFMxCM RWLORG = ...

Q: A pipe 800 m long connects two reservoirs whose level difference is 60 m. Find the discharge in pipe...

A: Length of pipe, L=800 mLevel difference between the two reservoirs, ∆z=60 mPipe diameter, d=0.5 mFri...

Q: PROBLEM 2 a. For the frame shown, determine the minimum bolt diameter at B if the shear stress in th...

A:

Q: The elastic potential energy of a spring Ve depends on the spring constant k of the spring and the e...

A: When spring stretches or compress it store energy. It is called potential energy  

Q: EX if the magnitude of the resultant force is to be goky directed a long the positive X-axis determi...

A:

Q: Wo Determine the magnitude and location of the maximum bending moment M fastttt it's urgent

A:

Q: A cylinder with a bore diameter of 1.5 in and a rod diameter of 0.625 in is to be used in a system w...

A:

Q: atural frequency in Hertz of an undamped mass-spring system with a m= 100 grams and k= 100 N/m

A: Given:m=100 grams =0.1 kgk=100 N/m

Q: 33인 113 Ib Hi = 0.23 20°

A:

Q: 4. For this series of 4 questions, two blocks, A and B, are connected using the cable and pulley sys...

A:

Q: Calculate the Mach number at the exit of the tube if the diverging duct has an inlet area and veloci...

A:

Q: A commercial refrigerator with refrigerant-134a as the working fluid is used to keep the refrigerate...

A:

Q: Q. 60. The figure shows a schematic layout of a hydraulic jack. The load to be raised weighs 20,000 ...

A:

Q: An air-standard Carnot cycle operates between temperatures of 300 and 1100 K. The minimum pressure i...

A:

Q: .33. Compute the distanced travelled ed in 3 decimal ploces

A: Need to find Distance travelled by Block B

Q: Problem 11. The problem below, consists of a rod with a circular cross-section embedded and bonded i...

A: (a) If the wall is replaced by spring, Material has length 'L' and radius 'R' elasticity ε  Young's ...

Q: A Contractor/foreman needs lumber to be used for wooden scaffoldings, the set of lumber can be purch...

A:

Q: An air-standard Carnot cycle operates in a piston- cylinder device between temperatures of 300 and 9...

A:

Q: You want to save an amount of P100,000 at the end of 10 years. You are given 8% interest compounded ...

A: Given Sum = P100000 To find Principal amount per month

Q: A shell and tube heat exchanger uses 600 tubes of 4 in B.W.G 20 (d, = 0.75 in and d; = 0.68 in) and ...

A: SHELL AND TUBE HEAT EXCHANGER A shell and tube heat exchanger is a class of hotness exchanger design...

Q: Calculate the polar radius of gyration of the area of the angle section about point A. Note that the...

A:

Q: Carbon dioxide with a dpecifuc weight of 0.114lb/ft3 and a dynamic viscosity of 3.34 x 10^-7lb*s/ft2...

A: Given data: w=0.114 lb/ft3μ=3.34×10-7 lb.s/ft2Q=200 ft3/min=3.333 ft3/s Need to determine the value ...

Q: 68. Water at a rate of 1 m'/s enters a small hydraulic turbine from the horizontal supply line, havi...

A:

Q: nes, how many space thermostats will the system have?

A:

Q: When several measured values agree with one another, the values are said to be   accurate   neithe...

A: Accuracy :- it refers to closeness of a measured value to standard value to a standard or known valu...

Q: A snowboarder starts from rest at the top of a double black diamond hill. As she rides down the slop...

A:

Q: On a certain stretch of a track, trains run at 60 miles per hour. How far back of a stopped train sh...

A:

Q: An incompressible fluid (kinematic viscosity =7.4x10-7 m2/s, specific gravity=0.88) is held between ...

A: Given:Kinematic viscosity of fluid, ϑ=7.4×10-7 m2/sspecific gravity of fluid=0.88velocity, v=0.5 m/s...

Q: An air-standard carnot cycle between temperatures of 450R and 1860R. the minimum pressure in the cyc...

A: Minimum Temperature in the cycle = T3 = T4 = 450 R = 250 KMaximum Temperature in the cycle =T1 = T2 ...

Q: A cylindrical specimen of a cold-worked brass has a ductility (%EL) of 21%. If its cold-worked radiu...

A:

Q: S6.2 Helium expands polytropically through a turbine at pV1.5 = C. Inlet is at 1000K and 1000 kPa. E...

A:

Q: An air-standard Carnot cycle operates in a piston-cylinder device between temperatures of 300 and 90...

A:

Q: 1. Use the METHOD OF SECTIONS to determine the forces in members AC, BC, and BD of the truss in Figu...

A:

Q: Compute the pressure difference between m and n, in pounds per square inch, when: a) Fluid A is bri...

A:

Q: Determine the relationship which governs the velocities of the three cylinders, and state the number...

A:

Q: The L bar is supported by a universal gasket at O and by the two wires as shown. The universal joint...

A: Draw the free-body diagram of the beam.  

Q: Consider pinned Member A subjected to a tensile load shown below. Determine the expression of the ar...

A:

Q: Using the Double Integration Method. for the given cross- section of the beam below, find the ff. wh...

A:

Q: A four-stroke, four-cylinder diesel engine running at 2000 rpm develops 60 kW. Brake thermal efficie...

A: Given data as per question N=2000 rpmcv=42 MJkgd=120mmρa=1.15 kgm3mm=0.8ηbt=30%BP=60kwLs=100 mm=2lcA...

Q: A small projectile is fired vertically downward into a fluid medium with an initial velocity of 65 m...

A:

Q: Calculate: (a) the maximum torque that can be applied to the shaft. (b) the minimum diameter of the ...

A: Given Dataσy=450MPaE=205GPaτy=σy2=225MPar=45mm

Q: Q: Salt in crude oil must be removed before the oil undergoes processing in a refinery. The crude bi...

A:

Q: A turbine (see the figure of Example IIIa.3.21) is located at an elevation H1 from the surface of a ...

A:

Q: In an ideal dual combustion cycle, what is the pressure at the beginning of  constant pressure combu...

A: We put the value of given pressure into pressure ratio formula, and calculated the value of pressure...

Q: o blocks A and B of the same mass 1.25 kg are released from rest on a 24° incline when they are S = ...

A: Given:mA=mB=1.25 kgθ=24°S=12.7 mμA=0.22μB=0.35

Q: A statistical significant result is A a result that is unlikely due to chance B. a result that is im...

A: Option A is correct

Q: 1.20 m wide is mounted on the vertical wall of an open rectangular tank filled with oil. The top of ...

A:

Q: Cars A and B are traveling in adjacent highway lanes and at t = 0 s have the position and velocity s...

A: Given data: At t = 0,Velocity of car A = vA = 11 km/hr = 3.056 m/sVelocity of car B= vB = 25 km/hr =...

Q: aft with a hollow cross section is subjected to torque of magnitude T = 5.5 kN-m. If the outer diame...

A: Given:T=5.5 kN.mdo=0.1 mt=10 mm

Q: A property of liquid that measure the resistances to the flow due to attractions between molecules i...

A:

Fluid Kinematics

The branch of science that deals with objects which are either in motion or stationary are studied under the branch of classical mechanics. Fluid mechanics is a subcategory of classical mechanics that deals with the behavior of fluids at rest (fluid statics) or in motion (posing some velocity). In fluid kinematics, studies focus on the associated motion of fluid particles or groups of particles, and its associated parameters like displacements, velocity, and acceleration without concerning about the forces that caused the motion. All the laws of classical mechanics are applied in the study of fluid kinematics.