A small sphere (emissivity =0.503 radius=r1) is located at the center of a spherical abestos shell ( thickness =1.74 cm, outer radius= r2; thermal conductivity of abestos is 0.090 J/ (sm c degrees) The thickness of the shell is small compared to the inner and outer radii of the shell. The temperature of the small sphere is 695 degrees Celsius while the temperature of the inner surface of the shell is 352 degrees Celsius, both temperatures remaining constant. Assuming that r2/r1 =8.75 and ignoring any air inside the shell, find the temperature in degrees Celsius of the outer surface of the shell.

A small sphere (emissivity =0.503 radius=r1) is located at the center of a spherical abestos shell ( thickness =1.74 cm, outer radius= r2; thermal conductivity of abestos is 0.090 J/ (sm c degrees) The thickness of the shell is small compared to the inner and outer radii of the shell. The temperature of the small sphere is 695 degrees Celsius while the temperature of the inner surface of the shell is 352 degrees Celsius, both temperatures remaining constant. Assuming that r2/r1 =8.75 and ignoring any air inside the shell, find the temperature in degrees Celsius of the outer surface of the shell.

Principles of Heat Transfer (Activate Learning with these NEW titles from Engineering!)

8th Edition

ISBN:9781305387102

Author:Kreith, Frank; Manglik, Raj M.

Publisher:Kreith, Frank; Manglik, Raj M.

Chapter1: Basic Modes Of Heat Transfer

Section: Chapter Questions

Problem 1.30P

See similar textbooks

Similar questions

A long wire 0.7 mm in diameter with an emissivity of 0.9 is placed in a large quiescent air space at 270 K. If the wire is at 800 K, calculate the net rate of heat loss. Discuss your assumptions.
1.25 A spherical vessel, 0.3 m in diameter, is located in a large room whose walls are at 27°C (see sketch). If the vessel is used to store liquid oxygen at –183°C and both the surface of the storage vessel and the walls of the room are black, calculate the rate of heat transfer by radiation to the liquid oxygen in watts and in Btu/h.
1.11 Calculate the heat loss through a glass window 7-mm thick if the inner surface temperature is 20°C and the outer surface temperature is 17°C. Comment on the possible effect of radiation on your answer.
1.28 The sun has a radius of and approximates a blackbody with a surface temperature of about 5800 K. Calculate the total rate of radiation from the sun and the emitted radiation flux per square meter of surface area.
A small sphere (emissivity = 0.745, radius = r1) is located at the center of a spherical asbestos shell (thickness = 1.72 cm, outer radius = r2; thermal conductivity of asbestos is 0.090 J/(s m Co)). The thickness of the shell is small compared to the inner and outer radii of the shell. The temperature of the small sphere is 727 °C, while the temperature of the inner surface of the shell is 406 °C, both temperatures remaining constant. Assuming that r2/r1 = 6.54 and ignoring any air inside the shell, find the temperature in degrees Celsius of the outer surface of the shell.
Earth absorbs solar energy and radiates infrared energy. The intensity of the solar radiation incident on earth is J = 1350 Wm-2, also known as the solar constant. Assume earth’s surface (ground) temperature to be uniform at Ts, and that the ground and atmosphere are black (emissivity = 1) for infrared radiation. The radius of the earth is 6.378 x 106 m. The diagram shows the ground at the surface temperature Ts and the atmosphere, represented as a thin black layer, at temperature Ta . Suppose the atmosphere absorbs 100% of the infrared radiation emitted by the ground. Assume that the ground absorbs 47.5% of the incident solar energy, and that the atmosphere absorbs 17.5% of the incident solar energy (for a total of 65% absorbed by the planet). Calculate the "steady state” numerical values of the earth’s ground temperature Ts and the atmospheric temperature Ta taking into account the “greenhouse effect” of atmospheric infrared absorption and emission described above.
An electric hot plate is placed in a room which is maintained at a temperature of 297 K. The plate is maintained at a temperature of 403 K and has an emissivity of 0.8. If the plate surface resembles a circular disc of diameter 250 mm, electrical power consumed by the hot plate will be?
An electrical cable with 20 mm in diameter and emissivity equal to 0.85 is installed inside a conduit whose inner surface and air in the its interior is at 30oC. The electrical resistivity of the cable, ρe (µΩ.m), is a function of its temperature, given by ρe=a[1+b(T-T0)], where a=0.0171 µΩ.m, b=0.00396 K-1 and T0= 25oC. The natural convection heat transfer coefficient is expressed by the relation h=cD-0.25(T-Tꚙ)0.25where c=1.21 W/(m1.75.K1.25) and D is the cable diameter. Electrical resistance per unit of cable length is R’e=ρe/Ac (Ac is the cross-sectional area). (a) For steady state operating conditions, estimate the maximum current that can be dissipated in the wire so that its temperature does not exceed 65oC;
A spherical radiator has a radius of 3ft and emissivity of 0.5. If radiates 6000 Btu/hr of heat at 3000R, what is the temperature of a surface affected by its radiation?
A plate that is exposed to the outside environment at 30 ° C, gets airradiation of 2000 W / m2. The plate, which absorbs 80% of the irradiationand it has an emissivity of 0.5, it is always at a uniform temperature.An external air flow at 20 ° C and 15 W / m2-K go through the plate. Calculatethe temperature of the plate if it is in thermal equilibrium and insteady state conditions.
Define Emissivity of some materials at 300 K.
Liquefied natural gas (LNG) is transported around the globe using ships similar to thatshown in Figure QA3. This ship has four pressurised cylindrical steel tanks each ofradius of 20 m. The tanks are internally insulated with 30 cm of polyurethane foamwhich keeps the LNG at a constant -162 ºC. Take the effective sky temperature is 265K and the net radiative thermal energy exchange with the sky as 1x106 W. Calculate the surface temperature of the end (facing the sun) of a tank. Calculate the conductive heat transfer through the end (facing the sun)of a tank.