A siphon consisting of a 3 cm diameter tube is used to drain water from a tank. The outlet end of the tube is 2 m below the water surface in the tank and the peak point of the siphon is 1.4 m above the water surface. Estimate the pressure of fluid at the peak of siphon. a. 33.35 kPa b. 23.456 kPa C. -33.35 kPa d. -23.456 kPa

A siphon consisting of a 3 cm diameter tube is used to drain water from a tank. The outlet end of the tube is 2 m below the water surface in the tank and the peak point of the siphon is 1.4 m above the water surface. Estimate the pressure of fluid at the peak of siphon. a. 33.35 kPa b. 23.456 kPa C. -33.35 kPa d. -23.456 kPa

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

Please provide complete solution and diagram. An air compressor takes air and discharges it to 200 psi. If the volume flow of the discharge is 1.5 m3/sec, determine the capacity of the compressor in liters per sec. A. 9570.23 li/s C. 9680.24 li/sB. 8680.25 li/s D. 9750.24 li/s
A pump lifts water at the rate of 6 m3/s to a height of 120 m and the friction loss in the pipe is 10 m. What is the power in KW required if the pump efficiency is 90%? a.10257 b.7651.8 c.130 d.8502
Solve the ff. The discharge pressure of an air compressor is 5 times the suction pressure. If the volume flow at suction is 0.7m3/s and discharge volume flow of 0.2217m3/s, what is the compressor power(hp) if suction pressure is 100kpa. Ans. 191.72 A double acting air compressor has a cylinder dimension of 50cm x 60cm, 750rpm will have a volume displacement (m3/s) of: Ans. 2.945 A pump has a specific speed of 45 and 600rpm when it delivers 0.01m3/s. Find the head developed by the pump in ft. Ans. 926.07
An irrigation line carries water from a lake down into an arid valley 810 ft below the surface of the lake. The water discharge through a nozzle with jet velocity of 220ft/s, the diameter of the jet is 4 in. Find the power loss in friction expressed in hp. Show FBD. A.158.45 B.187 C.120 D.127
A pump lifts water at the rate of 6 m3/s to a height of 120 m and the friction loss in the pipe is 10 m. Compute the energy added by the pump. a.8502 b.130 c.10257 d.7651.8
Include a free body diagram A pump is installed in a pipe system, where at the suction side 1.0 m below the pump, an open manometer reads a vacuum of 20 cm of mercury. The pipe is 10 cm in diameter and the flow is 35 L/s of water. Find the total energy at the location of the manometer, relative to a datum, through the pump. A. 12.74 m B. -4.67 m C. 2.56 D. -2.72 m
A right cylindrical container 4 m. diameter is 3 m tall. A 50 mm diameter hole is provided at the bottom of the container to drain the water when necessary. If it is full of water, how long in hours does it take to empty the container from the instant the hole is opened? Coefficient of velocity and coefficient of contraction are both equal to 1.0. A.1.39 hoursC.1.13hoursB.1.26 hoursD.1.49hours
A jet of freshwater strikes a series of vanes of a turbine at 25° with the direction of motion and leaves it at 150° absolute with the direction of motion. The absolute inlet velocity of the jet is 25 m/s and the vanes move at a velocity of 10 m/s. Ignore friction across the vanes. Calculate:
Flow Speed in a Channel The speed of water flowing in achannel, such as a canal or river bed, is governed by theManning Equation,
Ex. 1.13] A pump draws water from reservoir A and lifts it to reservoir B as shown in the figure. The loss of head from A to 1 is three times the velocity head in the 15.24-cm pipe and loss of head from 2 to B is 20 times the velocity head in the 101.6-mm pipe. The pump discharge rate is 40 Ips. Determine the following: d) Pressure head at point 1 e) Pressure head at point 2 Given: Pump system shown Q = 40 Ips HA = 3 29 Zg = 36 m H = 20 29 %3D ZA = 6 m D; = 15.24 cm Dz = 101.6 mm Required: Pump We a) TDH b) Pump WP c) BP if pump efficiency is 78% d) Pressure head at point 1 e) Pressure head at point 2
A pump is installed in a pipe system, where at the suction side 1.0 m below the pump, an open manometer reads a vacuum of 20 cm of mercury. The pipe is 10 cm in diameter and the flow is 35 L/s of water. Find the total energy at the location of the manometer, relative to a datum, through the pump. A. 12.74m B. -4.67 m C. -2.72 m D. 2.56
7) A pump has the following characteristic: Volume flow rate 23 46 69 92 115 (m³/h) Head (m) 17 16 13.5 10.5 6.6 The is used to pump water from a lower tank to a higher tank through a total length of pump 800 m of 150 mm diameter pipe. The difference between the water levels in the two tanks is 8m. Neglecting all losses except friction and assuming that C; = 0.004, find the rate of flow between the two reservoirs. [Ans: = 60m/hr]