A single-phase motor uses conductors made of 12 AWG copper. The motor is located 200 ft from its power source. If the full-load current draw of the motor is 12 A, calculate the voltage drop across the conductors when the motor is in operation. The motor operating temperature is 20 °C. BIU B EE ¶ ¶. Σ @

A single-phase motor uses conductors made of 12 AWG copper. The motor is located 200 ft from its power source. If the full-load current draw of the motor is 12 A, calculate the voltage drop across the conductors when the motor is in operation. The motor operating temperature is 20 °C. BIU B EE ¶ ¶. Σ @

Electricity for Refrigeration, Heating, and Air Conditioning (MindTap Course List)

10th Edition

ISBN:9781337399128

Author:Russell E. Smith

Publisher:Russell E. Smith

Chapter7: Alternating Current, Power Distribution, And Voltage Systems

Section: Chapter Questions

Problem 3RQ

See similar textbooks

Similar questions

3 Phase 50 Hz 25 Hp asynchronous motor 415 V triangle is working. It rotates at 1480 rpm/mın under full load. Stator phase effective resistance Rs=0.02 ohm stator phase leakage reactance Xs=0.25 ohm According to the stator terms, the effective phase resistance of the rotor is R2=0.06 ohm and the leakage phase reactance of the rotor is X2=0.2. The motor draws 750 W at idle. a- Calculate the current that the motor will draw as it will start directly in the first developmentb- Calculate the initial moment of development,c- Since the motor is running under full load, draw the equivalent circuit and draw the current drawn by the motor from the mains, d- Calculate the power and efficiency that the motor will draw under full load by calculating the losses, e- Full load torque of the motor, f- The maximum power that can be obtained from the engine g- Calculate the maximum torque, Could you please elaborate? Thanks for your effort
A short composite motor draw or pulls stream a current of 50 A at a voltage of 220 V it rotates at a speed of 1200 rpm Calculate the reverse electromotive force if the resistance of the product is 0.04 ohm the resistance of the series windings is 0.01 ohm and the resistance of the parallel windings is 125 ohm then Calculate the torque generated
3 Phase 50 Hz 25 Hp asynchronous motor 415 V triangle is working. It rotates at 1480 rpm/mın under full load. Stator phase effective resistance Rs=0.02 ohm stator phase leakage reactance Xs=0.25 ohm According to the stator terms, the effective phase resistance of the rotor is R2=0.06 ohm and the leakage phase reactance of the rotor is X2=0.2. The motor draws 750 W at idle. a- Calculate the current that the motor will draw as it will start directly in the first developmentb- Calculate the initial moment of development,c- Since the motor is running under full load, draw the equivalent circuit and draw the current drawn by the motor from the mains, d- Calculate the power and efficiency that the motor will draw under full load by calculating the losses, e- Full load torque of the motor, f- The maximum power that can be obtained from the engine g- Calculate the maximum torque, Can you please give all the answers? Thank you very much for your hard work.
What is the speed of a 100kW, 230V, three-phase, four-pole, 60Hz alternator? a. 450 rpm b. 900 rpm c. 1200 rpm d. 1800 rpm 2. A 6-pole, 3-phase, 60-cycle alternator has 12 slots per pole and four conductors per slot. The winding is 5/6 pitch. There are 2,500,000 maxwells (0.025 weber) entering the armature from each north pole, and this flux is sinusoidally distributed along the air gap. The armature coils are all connected in series. The winding is wye-connected. Determine the open circuit emf of the alternator
There are 160 double wound slots in a 3-phase, 50 Hz., 600 rpm, star connected alternator. Coil span is 15 slots and there are 3 turns per coil. Flux per pole is 0.1120 WB. Calculate (1) emf per conductor (2) emf per coil.
The current, power factor and input power to.a 3-phase ac motor is 8.07A, 0.65 and 5KW. Calculate the voltage through it. Select one: O a. None of these O b. 106V O c. 550V O d. 250V Next page
A 220V series generator has an armature resistance of 0.04Ω. If the generated emf is 230V and the drop across the series field winding is 9V, what is the ohmic resistance (in ohms) of the series field winding?
The voltage induced in 8 poles lamp wound generator is 120 V with armature resistance = 0.3 2. What will be the terminal voltage at a load = 3.6 A when the machine is rewound as a wave?
The power supplied to a three-phase induction motor is 20kW and the stator losses are 1000W. If the slip is 4 %, the rotor copper loss is (a) 1520 (b) 760 (c) 800 (d) 1600
3.4 The rotor power output of 3-phase induction motor is 15 k. The rotor copper losses at a slip of 4% will be (a) 600 W (c) 650 W (b) 625 W (d) 700 W
Q2/460V,25Hp,60Hz,four pole, three phase Y-connected wound rotor induction motor has the following impedances per phase refered to the stator cirguit R1=0.641 Q R2=0.332 Q X1=1.106 Q X2=0.464 02 Mechanical losses 100W and core losses is 1Kw for slip-2.2%, find Xm=26.3 Q 1) What is the maximum torque of this motor, At what speed and slip does it occur. 2) What is the starting torque of this motor. 3) When the rotor resistance is doubled, what is the speed at which the maximum torque now occurs. What is the new starting torque of the motor. 4) What is the value of resistance which must be added in rotor circuit to make starting torque equal to maximum torque.
There are 72 slots in a 3-phase, 8-pole, 50 Hz, star connected alternator. There are 2 conductors in each slot and all the conductors in a phase are connected in series. Coil span is 150° electrical and the flux per pole is 0.05 Weber sinusoidally distributed. Calculate the emf induced per phase.