a sample of sodium carbonate Na2CO3 is being dried. after 1 hour of drying the mass of the sample was 0.337g. after an additional 30 minutes of drying the mass of the sample is 0.333g what is the percent change between the first and second measurement? if to be considered dry two consecutive measurements must have a percent change of less than or equal to plus or minus 1% is the sample dry?

a sample of sodium carbonate Na2CO3 is being dried. after 1 hour of drying the mass of the sample was 0.337g. after an additional 30 minutes of drying the mass of the sample is 0.333g what is the percent change between the first and second measurement? if to be considered dry two consecutive measurements must have a percent change of less than or equal to plus or minus 1% is the sample dry?

Chemistry: The Molecular Science

5th Edition

ISBN:9781285199047

Author:John W. Moore, Conrad L. Stanitski

Publisher:John W. Moore, Conrad L. Stanitski

Chapter13: The Chemistry Of Solutes And Solutions

Section: Chapter Questions

Problem 15QRT: Beakers (a), (b), and (c) are representations of tiny sections (not to scale) of mixtures made from...

See similar textbooks

Similar questions

Beakers (a), (b), and (c) are representations of tiny sections (not to scale) of mixtures made from pure benzene and pure water. Select which beaker gives proper representation of the result when the two pure substances are mixed.
A solution is prepared by mixing 20.0 mL of 0.1 00M Fe(NO3)3 with 20.0 mL of 0.00300M KSCN and 10.0 mL of DI water. Calculate the initial concentration of SCN^- in this solution? Give answer with correct amount of significant figures.
Choose the one correct or one incorrect statement regarding the technique of weighing by difference: the weighing beaker should be moved with a strip of paper used as a handle or strap preparing 4 samples requires only 4 weighings the balance should be tared after each sample is removed from the weighing beaker the weighing beaker must be clean but does not need to be dry the receiving flasks must be both clean and dry before weighing begins
An environmental study was performed to measure the transport of a DDT (a banned pesticide) throughout the globe. A lake in northern Canada was sampled to see if low levels of DDT were present there in spite of it not being administered within 1000 miles of that location. 1.000 L of the lake water was spiked with 100.0 uL of a 2.451 ug/L solution of tetrachlorobenzene, which acted as the internal standard. The entire 1.000 L spiked solution was concentrated onto an SPE column. After washing the SPE column with ~5 mL of pure water, the analyte and internal standard were eluted from the SPE column using ~5 mL of CH2Cl2 solvent. The eluted sample was evaporated under a stream of nitrogen to a final volume of 1.000 mL. 1 uL of this final solution was analyzed using GC-MS, and gave a signal of 24835 for DDT and 11597 for tetrachlorobenzene. To calculate the response factor, a standard solution was prepared consisting of 1.482 ug/L of DDT and 2.451 ug/L of tetrachlorobenzene.…
Is the concentration of the solution prepared in the question below only approximate because sodium hydroxide is not a primary standard? * Find the mass in grams of sodium hydroxide that will be required to prepare a solution with a concentration of 0.500 mol·dm⁻³ in a 250 cm³ volumetric flask. [Round the answer to three decimal places. Do not type in the unit. Use a decimal point.] *
An impure sample contains 1.01 g of impurities and 4.92 g of benzoic acid. The impure sample is dissolved in water, then heated. The solution is then cooled. How many grams of benzoic acid will recrystallize when the solution has cooled? Include the unit and two decimal places in your answer. The solubilities of the impurity and benzoic acid in hot water are found as an item in the Recrystallization Experiment folder. Solubility Data for Report Questions 10 Compound Cold Water solubility Hot Water Solubility Benzoic acid 0.42 g per 100 mL of water 5.79 g per 100 mL of water Impurity 0.61 g per 100 mL of water 4.62 g per 100 mL of water
A 25.0 ml aliquot of a well-shaken and filtered sample of river water is pipetted into an evaporating dish. The sample was heated to dryness. Determine the concentration of Total Dissolved Solids (TDS) in mg/L given the following data: Mass of evaporating dish = 25.5 g Mass of dried sample plus evaporating dish = 25.9729 g Note: Round off your answer to the nearest whole number.
You determine the acetic acid (HOAc) content of vinegar by titrating with a sodium hydroxide standard solution to a phenolphthalein (an indicator) end point. An approximately 5-mL sample of vinegar is weighed on an analytical balance in a weighing boat and this is found to be 5.0268 g. The standard deviation in making a single weighing is 0.2 mg. The sodium hydroxide must be accurately standardised (this means its concentration must be accurately determined) by titrating known mass of high-purity potassium hydrogen phthalate, and three such titrations give molar concentrations of 0.1167, 0.1163 and 0.1164 mol L-1. A volume of 36.78 mL of sodium hydroxide is used to titrate each sample. The standard deviation of the burette used is 0.02 mL. Calculate the percentage of acetic acid in the vinegar and its standard deviation.
A stock solution of analyte is made by dissolving 34.83 mg of copper (II) acetate hexahydrate(fw = 289.73 g/mol) in 25.00 mL of water. A second stock solution of internal standard is madeby dissolving 28.43 mg of germanium (I) acetate (fw = 190.74 g/mol) into 25.00 mL of water.These solutions are used to make a series of standards for ﬂame atomic absorption analysiscalibration. The standard solutions (each 10.00 mL total volume) should have the followingconcentrations of copper: 10.00; 25.00; 50.00; 100.0; and 200.0 μM. Each calibration solutionshould also contain 50.00 μM of germanium. What is the analyte stock solution concentration? What is the internal standard stocksolution concentration?Complete this table.
Will a ppt of PBCO3 (s) form if you mix 30 mL of 1.3 x 10-8 M Pb(NO3)2 (aq) with 120 mL of 5.7 x 10-6 M Na2CO3 (aq)? (Which of the following is entirely correct?) Q = 7.4 x 1014, no ppt %3D OQ = 7.4 x 10-14, ppt forms 2.5 x 10-9, ppt forms Q = 1.2 x 10-14, ppt forms %3D Q = 1.2 x 1014, no ppt
A pool cleaning solution is mixed from three different bottles of solution. The first bottle contains a solution that is 25% chlorine, the second bottle contains a solution that is 58% chlorine, and the other bottle contains a solution that is 44% chlorine. There is twice as much of the 25% chlorine solution as there is the 44% chlorine solution. The final mixture consists of 154 ounces of a solution that is 37.4% chlorine. How many ounces of the bottle that contained 25% chlorine were used in the final solution? (round your answer to the nearest tenth) record 7 O O O 79.3 ounces 39.7 ounces 59.5 ounces O 35.0 ounces 2 W S 3 E D $ 4 R F 5 F6 T G Search 6 B Y FB & 7 H U N F9 * 8 J 1 F10 M ( 9 K O ) O ( F12 L P Prt Sc : + [ = 1 Backspace 40 D 3:41 P 6/15/202 7
A binary mixture contains 56 wt. 6 propane C3H8 (MW = 44 g/mol) and the remainder is butane C4H10 (MW = 58 g/mol). Determine the mol 46 of propane in the mixture. Enter your answer as a percentage rounded to one decimal place, but do NOT include the percentage sign.