can you please find solution for this question A regenerative system uses a Ø10 cm cylinder with a Ø6 cm rod. Thesystem operates at 25 Ipm and 7500 kPa. Find ther(a) Extension speed (m/s) and force (N) without regeneration.(b) Extension speed (m/s) and force (N) in regeneration(c) Retraction speed (m/s) and retraction force (N).

Answered: Image /qna-images/answer/0a464c4a-a1ea-4878-ac5b-113cb6d1807e.jpg

A regenerative system uses a Ø10 cm cylinder with a Ø6 cm rod. The system operates at 25 Ipm and 7500 kPa. Find the: (a) Extension speed (m/s) and force (N) without regeneration. (b) Extension speed (m/s) and force (N) in regeneration. (C) Retraction speed (m/s) and retraction force (N).

A regenerative system uses a Ø10 cm cylinder with a Ø6 cm rod. The system operates at 25 Ipm and 7500 kPa. Find the: (a) Extension speed (m/s) and force (N) without regeneration. (b) Extension speed (m/s) and force (N) in regeneration. (C) Retraction speed (m/s) and retraction force (N).

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

2. A supercharged, six-cylinder, 4-stroke cycle diesel engine of 10.5cm x 12.7cm dimension has a compression ratio of 15. When it is tested on a dynamometer with 54cm-arm at 2500 rpm, the scale reads 82 kg. For 6 minutes, 3 kg of fuel of 45,820 kJ/kg heating value are burned. Air metered to the cylinder is at 0.10 kg/s. The brake thermal efficiency is_____ _%.
Q4// An aircraft is flying at a speed of 480 m/s. This aircraft used the simple aircraft air conditioning cycle and has 10 TR capacity plant as shown in figure 4 below. The cabin pressure is 1.01 bar and the cabin air temperature is maintained at 27 °C. The atmospheric temperature and pressure are 5 °C and 0.9 bar respectively. The pressure ratio of the compressor is 4.5. The temperature of air is reduced by 200 °C in the heat exchanger. The pressure drop in the heat exchanger is neglected The compressor, cooling turbine and ram efficiencies are 87%, 89% and 90% respectively. Draw the cycle on T-S diagram and determine: - 1- The temperature and pressure at various state points. 2- Mass flow rate. 3- Compressor work. 4- COP.
An engine of 250 mm bore and 375 mm stroke work on otto cycle. The clearance volume (V2) is 0.00263 m3. The initial pressure and temperature are 1 bar and 50 C, if the maximum pressure (P3) is 25 bar, the network in the cycle in KJ/Kg will be: *
Q4: Why the stroke length of the racing cars' engines is always smaller than its bore diameter?
1 A four-stroke gas engine has a bore of 20 cm and stroke of 30 cm and runs at 300 rpm firing every cycle. If air-fuel ratio is 4:1 by volume and volumetric efficiency on NTP basis is 80%, determine the volume of gas used per minute. If the calorific value of the gas is 8 MJ/m3 at NTP and the brake thermal efficiency is 25% determine the brake power of the engine.
A reversible engine converts one-sixth of heat input into work. When temperature of sink is reduced by 70 degree Celsius, its efficiency is doubled. Fin temperature of source and sink.
Q4/1. in the steam turbine the common ? sources of the irreversibilities are * the good isolation of the steam turbine. O the power net of the steam turbine. O heat loss to the surrounding and pressure drop.
2. In a 30-minute trial of an oil engine running at 1750 rpm, the engine consumes 27.3 kg of fuel with a calorific value of 42,300 kJ/kg at a brake torque of 1640 N-m. There are 880 kg of jacketed cooling water system in the engine entering at 17 deg C and leaves at 77 deg C. There are 310 kg of air entering the intake manifold. The temperature of air at the intake manifold is 19 deg C and the temperature at the exhaust manifold is 586 deg C. Assuming mean specific heat capacity of exhaust gas to be 1.25 kJ/kg-K, determine the following D) Exhaust loss in kJ/min E) Radiation and Unaccounted Losses in kJ/min
02 2. A ix-cylinder, four-stroke cycle, marine oil engine-has cylinder dia méters of 610 mm and a piston troke of 1 25S0 mm. When the engine speod s 2 rev/s it uses 340 kg of fuel oil of calorific value 44 206-Lkg-in one hour. The cooling water amounts to 19200 kg/h, eniering at 15 C and leaving at 63 C The torque transitted at the engine coupling is 108 kN m and the indicaled mean effective pressure is 775 kN/m Determine: ta) the indicated power. ib) the brake power. (c) the percentage of the enerEY Hipplied kg ef fuel lost to the cooling water idi the brake thermal efficiency. jci the brake Hcan eflective pressure: i0 the mechanical efficiency. (g) the brake apecific fuel conumption.
2. In a 30-minute trial of an oil engine running at 1750 rpm, the engine consumes 27.3 kg of fuel with a calorific value of 42,300 kJ/kg at a brake torque of 1640 N-m. There are 880 kg of jacketed cooling water system in the engine entering at 17 deg C and leaves at 77 deg C. There are 310 kg of air entering the intake manifold. The temperature of air at the intake manifold is 19 deg C and the temperature at the exhaust manifold is 586 deg C. Assuming mean specific heat capacity of exhaust gas to be 1.25 kJ/kg-K, determine the following A) The brake horsepower in B) Energy chargeable to the engine in kJ/min C) Cooling loss in kJ/min D) Exhaust loss in kJ/min E) Radiation and kJ/min Unaccounted Losses in
A small civilian aircraft gasoline engine in an airplane, operating at 2.55 x 103 rev/min, takes in energy 7.95 x 103 J and exhausts 4.55 x 103 J for each revolution of the crankshaft. (a) How many liters of fuel does it consume in 1.00 h of operation if the heat of combustion of the fuel is equal to 4.03 x 107 J/L? L/h (b) What is the mechanical power output of the engine? Ignore friction and express the answer in horsepower. hp (c) What is the torque (in N. m) exerted by the crankshaft on the load? N. m (d) What power (in W) must the exhaust and cooling system transfer out of the engine? Need Help? Read It
A diesel engine in a power plant has an output of 2000 KW at 1000 rpm. It uses fuel oil having a heating value of 42,000 KJ/kg. If the efficiency of the engine is 39.61%. Calculate the sp. gr. of the fuel used and the fuel consumption in barrels per month.