q4: A long solenoid has a radius of 4 cm and has 800turns/m. If the current in the solenoid is increasing atthe rate of 22.3 A/s, what is the magnitude of theinduced electric field at a point 2.2 cm from the axis ofthe solenoid?O a. 334.50 µV/mO b. 200.70 µV/mΟ c. 1792.03 μν /mΟ d.246.42 μν /mO e. 813.95 µV/m

A long solenoid has a radius of 4 cm and has 800 urns/m. If the current in the solenoid is increasing at he rate of 22.3 A/s, what is the magnitude of the nduced electric field at a point 2.2 cm from the axis of he solenoid? O a. 334.50 µV/m O b. 200.70 µV/m O c. 1792.03 µV/m O d. 246.42 µV/m O e. 813.95 µV/m

A long solenoid has a radius of 4 cm and has 800 urns/m. If the current in the solenoid is increasing at he rate of 22.3 A/s, what is the magnitude of the nduced electric field at a point 2.2 cm from the axis of he solenoid? O a. 334.50 µV/m O b. 200.70 µV/m O c. 1792.03 µV/m O d. 246.42 µV/m O e. 813.95 µV/m

University Physics Volume 2

18th Edition

ISBN:9781938168161

Author:OpenStax

Publisher:OpenStax

Chapter16: Electromagnetic Waves

Section: Chapter Questions

Problem 54P: An incandescent light bulb emits only 2.6 W of its power as visible light. What is the rms electric...

See similar textbooks

Similar questions

28.37 A closed curve encircles several conductors. The line integral $B.di around this curve is 3.83 x 10 4T m. (a) What is the net cur- rent in the conductors? (b) If you were to integrate around the curve in the opposite direction, what would be the value of the line integral? Explain.
A long, straight wire carries a 13.0 A current. An electronis fired parallel to this wire with a velocity of 250 km/s in the samedirection as the current, 2.00 cm from the wire What should be the magnitude and direction of a uniform electric field that will allow the electron to continue to travel parallel to the wire?
Pr3. A long, cylindrical wire has the cross-section of an annulus, i.e. region between two concentric circles, see the shaded area in figure a). The outer radius of the wire is 2R, the inner diameter is R. Current I flows along the wire (perpendicularly into the page) in uniform distribution between radii R and 2R. a) b) ×I R R P 2R 2R a) Find and plot the magnitude of the magnetic field as a function of distance r from the symmetry axis of the wire. b) Suppose now that the cavity of radius R is not coaxial with the outer surface of the wire, as seen in figure b). Find the magnetic field at point P located in the center of the cavity. The current distribution in the wire is assumed to be uniform, the value of current is I.
6.0 A current flows through a 5.0 m thin and straightconductor wire. What is the magnitude of themagnetic field (in unit of nT) at a distance above4.0 m from the midpoint of the wire.(Take µ0 =4πx10−7 T.m/A )
00:33 7.00 ,4GM KB/S 49% O wire -wire 2 de K.- l, - K.- l2- A current carrying wire(wire-1) with i1 = 10 Amperesis placed at the origin on the Y-Z plane. Another current carrying wire(wire-2) with i2 = 12 Amperesis placed l = 8 mdistance apart on the Y-axis. The point P2 is l1 = 6 mfrom the wire-1. P1 (0, 6, –6) P2 (0, 6,0) and the point P3 (0, 6, 7) are on the same line. The direction of the current is given in the figure. Step 1: Consider a wire-1 only. a) Calculate magnetic field at P x component Give your answer up to at least three significance digits. y component Give your answer up to at least three significance digits. z component Give your answer up to at least three significance digits. Calculate the magnetic field at P2 x component Give your answer up to at least three significance digits. y component Give your answer up to at least three significance digits. z component Give your answer up to at least three significance digits. Step 2:Consider both wires b)Now what is the…
If a current I=15 A is distributed uniformly over the conical surface of angle 0=60° as shown below, the value of the surface current density K at (r=4,8360°,p%330°) is a. 0.69 A/m O b.4.13 A/m Oc.2.76 A/m d.0.52 A/m e. 6.20 A/m f. 1.72 A/m
7. A sheet of copper foil 1 mm thick, 5 cm wide and 1.75 m long is connected to a voltage source as shown. There is a magnetic field B = 2.5 T into the page. Assume copper has conductivity σ = 5.96 x 107 mho/m and a charge carrier density n = 1028 electrons/m³. a) What is the current density J in the foil? b) What is the Hall voltage as measured by the voltmeter? c) Which point is at a higher potential, a or b? Voltmeter 20 V
The electric force on a current-carrying conductor of any given length is A. directly proportional to the strength of magnetic field and inversely proportional to the length of the conductorB. directly proportional to the strength of magnetic field and the length of the conductorC. inversely proportional to the strength of magnetic field and to the length of the conductorD. inversely proportional to the strength of magnetic field and directly proportional to the length of the conductor
MYMIVIVH uns w pui SIVIN IN WEHE saw piwa ISMIMIN 29. An electron is travelling at 100 km/s parallel to a long straight horizontal conductor a distance of 3.00 cm from the conductor. A current of 12.0 A runs through the wire as the electron travels parallel to it, in the same direction as the electron's velocity. Find the strength of the external electric field that will prevent the elec- tron from deviating from its original path. Express your answer in V/m.
Two infinitely long parallel wires are at a distance of 5.0 cm apart. If the wires carry a current of 7.7A, what is the exchanged force per meter between the wires ( in units of µN )? Select one: O A. 237.2 B. 278.7 С. 308.3 D. 189.7 O E. 136.4
a.Find H in rectangular components at P(3,4,2) If there is a current filament on the z axis carrying 5 mA in the az direction. b. Repeat if the filament is located at x = -1, y = 2. (c) c. Find H if both filaments are present.
Q3: 42. Find and graph the charge q(t) and the current i(t) in the LC-circuit in Fig. 151, assuming L 1 H, C = 1 F, v(t) = 1 - e-t if 0 T, and zero initial current and charge. v(t) Fig. 151. LC-circuit