A liquid with density 1010 kg/m³ and viscosity 1.2 mPa.s drains from a building through a commercial steel pipe (I.D. 2.54 cm) to a pond as shown in the following Figure. The pipe is made of three segments as shown in the following Figure. (P1) 14m 21 m Segment A L-25 m 17 m Segment B L-40 m 6m Segment C L-7 m P3 Pond The pressures are measured at points P1, P2, P3, and P4. The pressure at the inlet (P1) is 141 kPa and Patm = 101 kPa. The speed of the liquid through Segment A is 0.40 m/s. What is the volumetric flow rate in litres/hr of the liquid through the pipe? 729.66 529.33 325.65 682.21

A liquid with density 1010 kg/m³ and viscosity 1.2 mPa.s drains from a building through a commercial steel pipe (I.D. 2.54 cm) to a pond as shown in the following Figure. The pipe is made of three segments as shown in the following Figure. (P1) 14m 21 m Segment A L-25 m 17 m Segment B L-40 m 6m Segment C L-7 m P3 Pond The pressures are measured at points P1, P2, P3, and P4. The pressure at the inlet (P1) is 141 kPa and Patm = 101 kPa. The speed of the liquid through Segment A is 0.40 m/s. What is the volumetric flow rate in litres/hr of the liquid through the pipe? 729.66 529.33 325.65 682.21

Chemistry: Principles and Reactions

8th Edition

ISBN:9781305079373

Author:William L. Masterton, Cecile N. Hurley

Publisher:William L. Masterton, Cecile N. Hurley

Chapter5: Gases

Section: Chapter Questions

Problem 1QAP

See similar textbooks

Similar questions

7. Unknown Pressure P Fluid of interest (Gas in most cases)- Po Ambient Fluid (Atmospheric pressure in most cases) Reference Fluid Density p (Liquid, e.g. water or mercury) Gage Pressure AP - P-Po - rgh In a manometer, the pressure p inside the apparatus is given as p = pex + pgh, where pex(po) is the external pressure, p is the mass density of the liquid in the tube, g = 9.806 m/s² is the acceleration of free fall, and h is the difference in heights of the liquid in the two sides of the tube. (The quantity pgh is the hydrostatic pressure exerted by a column of liquid. i) Suppose the liquid in the manometer is Hg, Pex is 760 torr, and the open side is 10.0 cm higher than the side connected to the sample. What is the pressure of the sample? The mass density of Hg at 25°C is 13.55 g/cm³. (Assume 25°C.)
3.43. A fluid of unknown density is used in two manometers-one sealed-end, the other across an orifice in a water pipeline. The readings shown here are obtained on a day when barometric pressure is 756 mm Hg. P = 0 H20 (a) (b) 7.23 m 26 cm What is the pressure drop (mm Hg) from point (a) to point (b)?
Temp. (°C) 150 135 120 105 90 75 60 45 30%A 15 B C D Heat (kJ) Created by E. Lee for Virtual Virginia (2021) Using this heating curve, complete the following statements: 1) The substance's melting or freezing point can be found between points [Select] and [Select] (Select the points alphabetically; for example, "X and Y" not "Y and X") and [Select] 2) Between points [Select] substance is in the liquid phase. (Select the points alphabetically; for example, "X and Y" not "Y and X") 3) At 50°C, the substance is a [Select] E " F the
Gas Pressure Conversions • A given P(atm) takes different column heights (h) of different liquids (p) to balance in a barometer: P(H,0) = p(H,O) gn h(H,0) P(atm) = p(Hg) g, h(Hg) 1 h oc %3D %3D ... Find mm(H,0) that measures 1 atm = 760 mmHg: %3D h(H,O) = h(Hg) x e(Ha= 760 mm(Hg) x 13.5_g/mL = [O,2le0 mm(H,O) %D %3D p(H2O) 1.0 g/mL A barometer with liquid twice as dense as water shows 1 atm as: 0.38 m 1.52 m 5.15 m 20.6 m Convert 3.11 x 10-5 atm into mTorr 1 atm =100 Torr 3.11 x 10-5 atm xloO Torr 1 atm 1 mTorr 10-3 Torr 23.0mTorr (AKA: µ) 1 in(Hg) = 25.t mm(Hg) Pa = 29.92 inHg 80.6 KPa Convert 23.8 inHg into kPa %3D 1 atm = 760 mmHg = (01325 25.4 mm(Hg)x 1 in(Hg) %3D 101325 Pa 760 mmHg 1o Pa 23.8 inHg x x 1 kPa =
14. From the following gases: N₂ (MM = 28.02) CO₂ (MM = 44.01) He (MM = 4.00) Kr (MM = 83.80) (a) Which gas will diffuse faster than CO (MM = 28.01)? (b) Which gas will diffuse at about the same rate as CO? (c) The rate of diffusion of CO is square root of three (√3) as the rate of diffusion of an unknown gas. Which gas satisfies this condition?
An open-end mercury manometer is to be used to measure the pressure in an apparatus containing a vapor that reacts with mercury. A 10-cm layer of silicon oil (SG = 0:92) is placed on top of the mercury in the arm attached to the apparatus. Atmospheric pressure is 765 mm Hg.(a) If the level of mercury in the open end is 365 mm below the mercury level in the other arm, what is the pressure (mm Hg) in the apparatus?(b) When the instrumentation specialist was deciding on a liquid to put in the manometer, she listed several properties the fluid should have and eventually selected silicon oil. What might the listed properties have been?
The gas nitrous oxide, N2O, is a dental anesthetic. a) Calculate the root-mean square velocity (ums ~ m/sec) of N,0(g) at a temperature of 27°C R = 8.31 (kg-m²) / (K-mol-sec2) Urms = [ Select ] m/sec 1 3RTK { MMkg b) Calculate the kinetic energy (KE ~ in joules) of a single molecule of dinitrogen monoxide with this root-mean square velocity (Urms)? KE = [ Select ] joules 2 KE = /2 mkg • Hrms
351145 TECHNO Define fundamental unit with an example. Why is the unit of force called a derived unit? ic a derived unit? Give its two examples. measurement Dats : D Graphite and iodine a y shine. Explain it with suitable yeasons. Graphite and are non-metals but the iodine are non- metals but REDMI NOTE 10 PRO KBYLWHARNA THAPA A chemical propertie39/99/2021 17:36
2 dN F (V )dV = N M 4 7 (- 2 ART MV 3/2y ? exp( 2 RT where dN, the number of particles having a velocity between v and v+dV, V velocity of molecules, M moleculer mass of gase, T temperature = |V ² † (V )dV =? 2-
1.6. Using dimensional analysis, convert 4.3 x 10-5 atmospheres to its corresponding CGS unit.
Given the equation V=√3RT/M,. What is the unit of v if R is in erg/mol•K, M is in g/mol and erg=g•cm²/s²?
A gaseous system A, with an initial temperature T1, is set to interact with a gaseous system B at an initial temperature T2. The molecules of A and B, both monoatomic, can interact with each other through a wall without mixing. It is known that T2 > T1. Considering this situation, answer the following question. Consider the statements below and type the sum of the numbers associated with the correct ones (write only the number): (1) System B necessarily has a higher initial energy than A (2) System A may have a higher initial energy than B (4) the molecules of system B have a greater average kinetic energy than those of system A (8) From a microscopic point of view, there can never be a collision between molecules in which a molecule of system A loses energy to a molecule of system B (16) The system with more molecules necessarily has the lowest energy