A liquid (specific gravity =0.78, vapor pressure =3.2 kPa) flows through a contraction pipe at a rate of 0.06 m3 /s. For what range of diameters of section 2 will cavitation occur? Gage pressure and diameter at point 1 is 45kPa and 8 cm, respectively. Atmospheric pressure = 101.4 kPa. Neglect losses.

A liquid (specific gravity =0.78, vapor pressure =3.2 kPa) flows through a contraction pipe at a rate of 0.06 m3 /s. For what range of diameters of section 2 will cavitation occur? Gage pressure and diameter at point 1 is 45kPa and 8 cm, respectively. Atmospheric pressure = 101.4 kPa. Neglect losses.

Chemistry

10th Edition

ISBN:9781305957404

Author:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Publisher:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Chapter1: Chemical Foundations

Section: Chapter Questions

Problem 1RQ: Define and explain the differences between the following terms. a. law and theory b. theory and...

See similar textbooks

Similar questions

1-Make a rough estimate of the thermal conductivity of n-butane both as a liquid at 20 °C and as a gas at 5 bara and 200 °C. Take the viscosity of the gaseous n-butane as 0.012 mN m ?s.
The viscosity of methane at 20 °C and 1 atm pressure is 1.09x10-4 poise. Calculate the number of collisions per second in 1 mL of the gas at 0 °C and 0.1 atm pressure (assume the collision diameter to remain constant).
69 Gpa, = 0.35)is loaded by an axiel force of 3N, m24mm 12mm 15mm (al Delermine he avetuge ponnal stress ln sechon AB and BC of the chaft at locations away from thefillet Section AB, = Section BC, o rid (O)Determine the change of thee diameter in seien AD due to Polsson's effect. Section AB, Ad%= (c) Determine te hrbest nonnd stress al the filt consideing sTnss concentration. Athe fillet, o= (d) Determine the nommal and shear stresses on the oblique surface that has an inxline angle of Fwiththe nomal cross secbon of the shaft in section AB as shown. pwa the otlique
Calculate the persistency (S) of VX at 25oC ,VX: MW= 267.38; Po = 0.0007 torr @ 25oC
Helium gas is diffusing through a uniform tube 0.2 m long containing an equal amount of nitrogen gas at 298 K and constant pressure 1.00 atm. The partial pressure of helium gas at one end of the tube is 0.2 atm and 0.1 atm at the other end. The diffusivity of the gases is 0.703 x 10-4 m2/s. Calculate the diffusion flux of both helium and nitrogen at steady state. (R = 8.314 J K-1 mol-1 = 0.08206 L atm K-1 mol-1)
A poiseuille flow experiment was carried out to measure the viscosity of air at 298 k. the sample was allowed to flow through a 100 cm tube of internal diameter 1mm. The high pressure end was at 865 Torr and the low pressure end was at 760 Torr. The volume was measured at the latter pressure. In 59 seconds a volume of 90.2cm^3 passed through the tube. What is the viscosity (use the unit cp of air at this temperature?
A water molecule at 25ºC carries out an average displacement of 0.037 cm. after 10 seconds. At 120ºC and 1 atm. depression. Calculate its diffusion coefficient and its average displacement in 10 seconds.Data. The viscosity of water at 25ºC is 0.8937x10-2 g.s-1cm-1. Bring your collision area closer to that of a circle.
The viscosity of methane at 20°C and 1 atm pressure is 1.09x10-4 poise. Calculate a) the mean free path in cm, b) the average collision diameter in cm, c) the number of collisions per second in 1 ml of the gas at 0 °C and 0.1 atm pressure (assume the collision diameter to remain constant)
E.(upper) = Em Vm + EpVp Em Ep Vm Ep + VpEm The mechanical properties of aluminum may be improved by incorporating fine particles of aluminum oxide (Al,O,). Given that the moduli elasticity of these respectively, 69 GPa and 393 GPa, plot the modulus of elasticity versus the volume percent of Al,0, in Al from 0 to 100 vol.%, using both E (lower) = %3D of materials are, 55 350 50 300 45 40 250 Upper bound 35 upper- and lower-bound 200 30 Lower bound expressions. 150 25 20 15 100 20 40 60 80 Tungsten concentralion (vol%) Madulus of elaticty (GPa Modulus of elasticity (10 ps)
A Poiseuille flow experiment was carried out to measure the viscosity of air at 298 k. The sample was allowed to flow through a 100 cm tube of an internal diameter 1mm. The high-pressure end was at 865 Torr and the low-pressure end was at 760 Torr. The volume was measured at the latter pressure. In 59 seconds a volume of 90.2 cm3 passed through the tube. What is the viscosity (unit in cp) of air at this temperature?
The viscosity of methane at 20 °C and 1 atm pressure is 1.09x10-4 Calculate the average collision diameter in cm.
A poiseuille flow experiment was carried out to measure the viscosity of air at 298 K. The sample was allowed to flow through a 100 cm tube of internal diameter 1 mm. The high pressure end was at 865 torr and the low pressure end was at 760 torr. The volume was measured at the latter pressure. In 59 seconds a volume of 90.2 cm^3 passed through the tube. What is the viscosity in cp of air at this temperature