Subject is Environmental EngineeringPlease solve this? Q#5.a) Explain the term "Atmospheric pressure".b) Explain the basic components of air pollution problem

The pressure exterted by atmosphere on earth is called atmospheric pressure. It is measured by…

Answered: a) Explain the term “Atmospheric…

Engineering

Civil Engineering

a) Explain the term “Atmospheric pressure". b) Explain the basic components of air pollution problem

Engineering Fundamentals: An Introduction to Engineering (MindTap Course List)

5th Edition

ISBN:9781305084766

Author:Saeed Moaveni

Publisher:Saeed Moaveni

Chapter11: Temperature And Temperature- Related Variables In Engineering

Section11.6: Additional Temperature-related Material Properties

Problem 2BYG

See similar textbooks

Related questions

Q: A 0.025-cubic meter metal block is tied to one end of a 3000-mm long square wooden plank with…

A: Given, The volume of metal block=0.025 m3 Dimensions of wooden plank=210mm×210mm×3000mm Weight of…

Q: Calculate dynamic viscosity of a cm/sec. liquid having specific gravity of 1.2 and kinematic…

Q: 2. A gas flows through a square conduit. At one point along the conduit, the conduit sides are 150…

A: Given:- The velocity at point 1 = 25 ft/s The conduit sides at point 1 = 150 mm The gas density at…

Q: Data on pollution and cost of medical care for elderly people were given in Exercise 5.17 and are…

A: Step-1

Q: The urban heat islands occur when cities replace natural land cover with pavement, buildings and…

A: Clay tiles- It is a type of building material. It is mainly used as a roofing material.

Q: 30. The amount of pollution, P, varies directly with the population, N, of people. Kansan City has a…

Q: Define the following terms in your own words: Smog Air pollution Criteria air pollutants Normal…

A: This is a question of Enviromental Engineering based on Air Pollution.

Q: Fluid Mechanics question: As shown in the image, an air space above a long tube is pressurized to 50…

A: Consider the unit weight of water is 9790 N/m3Consider a point 1 on the surface of reservoir and…

Q: How do atmosphere disperse highly concentrated streams of gaseous pollutants?

A: The earth is surrounded with gaseous layer in the environment . gases are released such as water…

Q: A car owner observed that when the air temperature of his car tire is at 25°C the gage reads 210…

Q: What are the reasons why Pump station water is metered.

A: Reasons for the metering of pump station can be various, it can be for monitoring purpose or can be…

Q: a) Explain the term “Atmospheric pressure”. b) Explain the basic components of air pollution problem

A: (a) Atmospheric Pressure- The pressure exerted by atmosphere on earth is called atmospheric…

Q: Watch a video about Airflow Visualization. Answer the following How does the air behaves at zero…

A: boundary layer

Q: What are the advantages and disadvantages of machine vision

A: Machine vision is the usage of a camera or multiple cameras to automatically analyze and inspect…

Q: Although liquids and gasses behave in much the same way and share many similar characteristics,…

A: Differences between fluids and solids :- 1. The main difference between solids and fluids is that on…

Q: Absolute pressure = Gauge pressure + Atmospheric pressureA pressure gauge in a refrigerator system…

A: Given: The gauge pressure is 119.6 psi. The atmospheric pressure is 14.7 psi.

Q: QUESTION 4 There is a wide range of biological treatment systems for the purification of wastewater…

A: From the given data

Q: The fuel gage for a gasoline tank in a car reads proportional to its bottom gage. The tank is 35 cm…

A: Pressure when tank is fully filled with gasoline PG=γgh PG=0.68×9.810.35m=2.34kpaPressure of water…

Q: , calculate the air velocity.

A: A pitot static tube is used to measure air velocity.

Q: Consider a hot boiled egg in a spacecraft that is filled with air at atmospheric pressure and…

A: The egg will cool FASTER when the spacecraft is on the ground since there is no gravity in the space…

Q: illustrated. Based on these data what is the atmospheric pressure at the ocean surface?

Q: PROBLEM 1: A closed tank whose bottom is 18 inches in diameter is filled with three liquids: 12…

Q: theoretical oxygen demand,

A: If the organic compounds and their concentrations present in water are exactly known,the oxygen…

Q: What pollutants have impact on air quality and how do they enter the atmosphere? Discuss briefly the…

Q: 1. Where do you find the adverse effects of turbidity in environmental engineering? Mention two…

A: (1) Turbidity is an important indicator of the amount of suspended sediment in water, which can have…

Q: Which of the following is the largest volumetric flowrate? A)98 gal per hour b)77 centiliters per…

A: To compare the flowrate we will covert them into single unit m3/s. 98 gal/hr =98 × galhr= 98 ×…

Q: determine the air flow rate , residence time, gravitational separation oval efficiency when the…

Q: Light from a chromatic light source strikes a surface. Seventy percent of the light is reflected and…

A: (1) It is required to determine the percentage of light transmitted. % Transmit=100-% Reflected+%…

Q: Calculate the partial pressure of oxygen in the air at 100 kPa if nitrogen has a partial pressure of…

A: Since the question number to be solved is not specified, the solution for Question a is as follows:…

Q: Explain the term “Atmospheric pressure”. Explain the basic components of air pollution problem

A: Given data in question which is to be discussed Atmospheric pressure Components of air pollution…

Q: To what volume of water (in mL) corresponds a sample of 1100 kg/m3 density and 60 mg mass?

A: Given data- Density of water=1100 kg/m3 Mass =60 mg To find out- Volume of water in mL

Q: 3. Find the total weight of a 10 ft' tank of oxygen if the oxygen is pressurized to 500 psia, the…

A: To determine Total weight?

Q: 2.19 Determine the change in the kinematic viscosity of air that is heated from 10°C to 70°C. Assume…

Q: What are sources, sinks, and environmental factors affecting Dissolved Oxygen in bodies of water?

A: The main source of dissolved oxygen are: atmosphere and from plants in the water. The primary source…

Q: How are industrial gasses extracted from the atmosphere? Choose 2 industrial gasses and explain its…

A: Industrial gases are the gaseous materials that are manufactured for use in industry. The principal…

Q: Which of the following statements is INCORRECT? O Evapotranspiration is a collective term for all…

A: 4th statement is incorrect

Q: I. A man takes 40 mg of a certain medicine. Each hour, the amount of medicine in the man's system…

Q: The fuel gage for a car’s gasoline tank reads proportional to the bottom gage pressure. If the tank…

A: Consider the figure,

Q: What’s the specific gravity of the fluid with density 3.09 slugs per cubic foot

A: Specific gravity:It is defined as the ratio of the density of the liquid to the density of water at…

Q: 2.116 A manufacturer is studying the effects of cook- ing temperature, cooking time, and type of…

A: Given data, number of different temperatures obtained = 3 Different cooking times = 4 different oils…

Q: Explain the physical meaning of each term in the equation of acceleration field and discuss the…

A: Solution: Material acceleration is that acceleration which follows a fluid particle. The derivation…

Q: Determine the number of gallons of paint needed to paint the outside surface of the water-supply…

A: Consider the figure shown below. The value of the perpendicular distance and the length of the…

Q: Define by which curve the relation between amount of energy absorbed and test temperature is shown,…

A: Solution: The interpretation of each curve is given below: Curve A - Energy absorbed increases…

Q: SUBJECT: ENGINEERING UTILITIES 2 1. What are your thoughts/insights on the use of pumps and…

A: A domestic hot water (DHW) system provides hot water to fixtures such as the sink, shower, tub, and…

Q: What is the ratio of the dynamic viscosity of air to that of water at standard pressure and a…

A: At 20 degree CelsiusDynamic viscosity of air : 1.8205×10-5 kg/ms Kinematic viscosity of air :…

Q: Show complete solutions with figures. A bottle consists of a cylinder 0.3 m in diameter and 0.4 m…

A: to determine the pressure of the trapped air in the bottle.

Q: Discuss briefly the effects of air pollution to human health, animals and plants.

A: Air particulate matter toxicants have distinct toxic effects on humans depending on how long they…

Q: Do research about the processes which are used to remove color from industrial wastewaters

A: Coloured wastewater is incredibly factor in organization because of the measure of colors or…

Concept explainers

Environmental Consequences of Fossil Fuel Use

Fossil fuels are organic materials found inside the earth's surface. They are mainly composed of dead remains of plants and animals. The primary component constituents of fossil fuels are carbon and hydrogen, which are usually burnt to produce energy. Fossil fuels are believed to be formed millions of years ago when dead remains of animals and plants were subjected to high heat and pressure.

Question

100%

Subject is Environmental Engineering Please solve this?

Q#5.
a) Explain the term "Atmospheric pressure".
b) Explain the basic components of air pollution problem

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1 ans (a)

VIEW

Step 2 ans (b)

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Environmental consequences of fossil fuel use

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

a) Explain the term “Atmospheric pressure”. b) Explain the basic components of air pollution problem
Q: Explain the term “Atmospheric pressure”. Explain the basic components of air pollution problem subject: Environmental Engineering-ll program: BE-Civil Engineering
Q#5. Explain the term “Atmospheric pressure”. Explain the basic components of air pollution problem
How high can vehicle exhaust gas (pollutant particles) climb in terms of altitude?
How many lb/sec of carbon dioxide are flowing through a 6” pipe when the pressure is 25.0 psi gage, the temperature 80°F, and the average velocity 8.00 ft/sec?
Question 14 In general, which of the following is the best long-term method of preventing the emis- sions of primary air pollutants? use of scrubbers and electrostatic precipitators to remove pollutants from industrial emissions B. use of taller smokestacks to release pollutants from industrial emissions higher into the atmosphere use of fossil fuels to fuel single-occupancy vehicles to reduce pollution from vehicle emissions D. use of air pollution reduction plans that promote the relocation of industrial facto- ries to less-populated areas
Describe briefly the ways water can be polluted.
The term degree of hydration refers to: A) The level of academic achievement needed to study water. B) The amount of water left in an underground aquifer C) The number of water molecules per formula unit in a hydrate D) A number placed on Gatorade bottles as a marketing ploy
The fuel gage for a gasoline tank in a car reads proportional to its bottom gage. The tank is 35 cm deep and accidentally contaminated with 3 cm of water. Specific gravity of gasoline is 0.68. If the tank is accidentally contaminated with 3 cm of water, how many cm of air remains on top of the tank when the gage reads "FULL"?
This question is for Jisha, Civil Engineering 2) Mr. X performs the laboratory test and determines that 12 mg/l of alum dose is required to treat the water. What is the quantity of alum required to treat 14 million liters of water per day at a treatment plant. Also determine the amount of carbon dioxide gas produced per liter of water during treatment.
2: answer five of the following: 0 [25 1-Why the second refrigerant is used? 2-How the solar energy is used to operate the absorption refrigeration systems? 3-What is the function of the compressor in the vapor compression refrigeration systems? And how can do this function in absorption refrigeration systems? 4- What are the available materials that can be used for manufacturing the ducts? 5- What is the function of expansion tank in piping systems? 6- What are the types of fans? And which of them used in A.C. applications.
Regarding the recovery techniques used to control air pollution, what is stated in: a) They are used in intermediate air quality standards and the cyclone is an example of equipment used. b) They are used in atmospheric emissions and the incinerator is an example of equipment used. c) They are used in atmospheric emissions and the electrostatic precipitator is an example of equipment. d) They are used in final air quality standards and the bag filter is an example of equipment