A dam has a semicircular gate with diameter 4 m. The top of the gate is 8 m below the surface of water. Set-up the integral for the force against the gate. 19600 (10-y)√4-y² dy 10 19600 (10-y)√4-y² dy 9800 (10-y)√4-y² dy 19600 of ² (2-y)√4-y²dy

A dam has a semicircular gate with diameter 4 m. The top of the gate is 8 m below the surface of water. Set-up the integral for the force against the gate. 19600 (10-y)√4-y² dy 10 19600 (10-y)√4-y² dy 9800 (10-y)√4-y² dy 19600 of ² (2-y)√4-y²dy

Name: A dam has a semicircular gate with diameter 4 m The top of the gate i
Uploaded: 2024-03-20T06:51:10.000Z
Channel: Bartleby
Description: A dam has a semicircular gate with diameter 4 m The top of the gate is 8 m below the surface of water. Set-up the integral for the force against the gate..219600 0² (10-y)√√4-y² dy.1019600 of ² (10-y)√4-y² dy29800 (10-y)√4-y² dy19600of ²(2-y)√4-y²dy

University Physics Volume 1

18th Edition

ISBN:9781938168277

Author:William Moebs, Samuel J. Ling, Jeff Sanny

Publisher:William Moebs, Samuel J. Ling, Jeff Sanny

Chapter1: Units And Measurement

Section: Chapter Questions

Problem 63P: The average density of the Sun is on the order 103kg/m3 . (a) Estimate the diameter of the Sun. (b)...

See similar textbooks

Similar questions

Verigy that the SI of hpg is N/m2.
A container of water has a cross-sectional area of A=0.1m2 . A piston sits top of the water (see be following figure). There is a spout located 0.15 m from the bottom of tank, open to the atmosphere, and a stream of water exits the spout. The cross sectional area of the spat is As=7.0104m2 . (a) What is the velocity of the water as it leaves the spout? (b) If the opening of the spout is located 1.5 m above the grand, how far from be pout does water hit the floor? Ignore friction and dissipative forces.
Suppose you have a coffee with a circular cross-section and vertical sides (uniform radius). What is its inside radius if it holds 375 g of coffee filled to a depth of 7.50 cm? Assume coffee has the same density as water.
A certain hydraulic system is designed to exert a force 100 times as large as the put into it. (a) What must be the ratio of the area of the cylinder that is being controlled to area of the master cylinder? (b) What must be the ratio of their diameters? (c) By what factor is the distance through which the output force moves reduced relative to the distance through which input force moves? Assume no losses due to friction.
How many cubic meters of helium are required to lift a balloon with a 400-kg payload to a height of 8 000 m? Take He = 0.179 kg/m3. Assume the balloon maintains a constant volume and the density of air decreases with the altitude z according to the expression air = 0ez/8, where z is in meters and 0 = 1.20 kg/m3 is the density of air at sea level.
A 75.0-kg floats in freshwater 3.00% of his volume above water when his are empty, and 5.00% of his volume above water when his lungs are full. Calculate the volume of air inhales—called his lung capacity—in liters. (b) Does lung volume seem reasonable?
Check Your Understanding Figure 1.4 says the mass of the atmosphere is 1019kg . Assuming the density of the atmosphere is 1kg/m3 , estimate the height of Earth’s atmosphere. Do you think your answer is an underestimate or an overestimate? Explain why. How many piano tuners are there in New York City? How many leaves are on that tree? If you are studying photosynthesis or thinking of writing a smartphone app tot piano tuners, then the answers to these questions might be of great interest to you. Otherwise, you probably couldn’t care less what the answers are. However, these are exactly the soils of estimation problems that people in various tech industries have been asking potential employees to evaluate their quantitative reasoning skills. If building physical intuition and evaluating quantitative claims do not seem like sufficient reasons tot you to practice estimation problems, how about the fact that being good at them just might land you a high-paying job? For practice estimating relative lengths, areas, and volumes, check out this PhET (https://openstaxcollege.org/l/21lengthgame) simulation, titled “Estimation.”
Assume it takes 7.00 minutes to fill a 30.0-gal gasoline tank. (a) Calculate the rate at which the tank is filled in gallons per second. (b) Calculate the rate at which the tank is filled in cubic meters per second. (c) Determine the time interval, in hours, required to fill a 1.00-m3 volume at the same rate. (1 U.S. gal = 231 in.3)
The average density of the Sun is on the order 103kg/m3 . (a) Estimate the diameter of the Sun. (b) Given that the Sun subtends at an angle of about half a degree in the sky, estimate its distance from Earth.
A straightforward method of finding the density of an object is to measure its mass and then measure its volume by submerging it in a graduated cylinder. What is the density of a 240-g rock 89.0 cm3 of water? (Note that the accuracy and practical applications of this technique are more limited than a variety of others that are based on Archimedes' principle.)
How many cubic meters of helium are required to lift a light balloon with a 400-kg payload to a height of 8 000 m? Take Hc = 0.179 kg/m3. Assume the balloon maintains a constant volume and the density of air decreases with the altitude z according to the expression pair = 0e-z/8 000, where z is in meters and 0 = 1.20 kg/m3 is the density of air at sea level.
The basic function of an automobile's carburetor is to atomize the gasoline and mix it with air to promote rapid combustion. Assume that 40 cm? of gasoline is atomized into N spherical droplets. Each droplet has a radius of 2.0 x 10-5 m. Find the total surface area of these N spherical droplets.