A bucket weighing 10 newtons when empty is loaded with 90 newtons of sand and then lifted at 10 cm at a constant speed. Sand leaks out of a hole in a bucket at a uniform rate and one third of the sand is lost by the end of the lifting. Find the work done in the lifting process in Joules.

A bucket weighing 10 newtons when empty is loaded with 90 newtons of sand and then lifted at 10 cm at a constant speed. Sand leaks out of a hole in a bucket at a uniform rate and one third of the sand is lost by the end of the lifting. Find the work done in the lifting process in Joules.

Name: 5. A bucket weighing 10 newtons when empty is loaded with 90 newtons
Uploaded: 2024-03-20T06:57:25.000Z
Channel: Bartleby
Description: 5. A bucket weighing 10 newtons when empty is loaded with 90 newtons of sandand then lifted at 10 cm at a constant speed. Sand leaks out of a hole in a bucketat a uniform rate and one third of the sand is lost by the end of the lifting. Findthe work

Principles of Physics: A Calculus-Based Text

5th Edition

ISBN:9781133104261

Author:Raymond A. Serway, John W. Jewett

Publisher:Raymond A. Serway, John W. Jewett

Chapter7: Conservation Of Energy

Section: Chapter Questions

Problem 12P: A crate of mass 10.0 kg is pulled up a rough incline with an initial speed of 1.50 m/s. The pulling...

See similar textbooks

Similar questions

Check Your Understanding When the length of the spring in Example 8.3 changes from an initial value of 22.0 cm to a final value, the elastic potential energy it contributes changes by 0.0800 J. Find the final length.
Coal is lifted out of a mine a vertical distance of 50 m by an engine that supplies 500 W to a conveyer belt. How much coal per minute can be brought to the surface? Ignore the effects of friction.
In Chapter 7, the work-kinetic energy theorem, W = K, was introduced. This equation states that work done on a system appears as a change in kinetic energy. It is a special-case equation, valid if there are no changes in any other type of energy such as potential or internal. Give two or three examples in which work is done on a system but the change in energy of the system is not a change in kinetic energy.
What is the efficiency of a subject on a treadmill who puts out work at the rate of 100 W while consuming oxygen at the rate of 2.00 L/min? (Hint: See Table 7.5.)
Ignoring details associated with friction, extra forces exerted by arm and leg muscles, and other factors, we can consider a pole vault as the conversion of an athlete’s running kinetic energy to gravitational potential energy. If an athlete is to lift his body 4.8 m during a vault, what speed must he have when he plants his pole?
(a) Calculate the energy in kJ used by a 55.0-kg woman who does 50 deep knee bends in which her center of mass is lowered and raised 0.400 m. (She does work in both directions.) You may assume her efficiency is 20%. (b) What is the average power consumption rate in watts if she does this in 3.00 min?
If you run down some stairs and stop, what happens to your kinetic energy and your initial gravitational potential energy?
The force exerted by a diving board is conservative, provided the internal friction is negligible. Assuming friction is negligible, describe changes in the potential energy of a diving board as a swimmer dives from it, starting just before the swimmer steps on the board until just after his feet leave it.
A ball of clay falls freely to the hard floor. It does not bounce noticeably, and it very quickly comes to rest. What, then, has happened to the energy the ball had while it was falling? (a) It has been used up in producing the downward motion. (b) It has been transformed back into potential energy. (c) It has been transferred into the ball by heat. (d) It is in the ball and floor (and walls) as energy of invisible molecular motion. (e) Most of it went into sound.
Consider the following scenario. A car for which friction is not negligible accelerates from rest down a hill, running out of gasoline after a short distance. The driver lets the car coast farther down the hill, then up and over a small crest. He then coasts down that hill into a gas station, where he brakes to a stop and fills the tank with gasoline. Identify the forms of energy the car has, and how they are changed and transferred in this series of events. (See Figure 7.34.) Figure 7.34 A car experiencing non-negligible friction coasts down a hill, over a small crest then dill again, and comes to a stop at a gas station.
What does work on a shuffleboard puck as it slides to rest? Why is the board dusted, and how does this affect work?
The Flybar high-tech pogo stick is advertised as being capable of launching jumpers up to 6 ft. The ad says that the minimum weight of a jumper is 120 lb and the maximum weight is 250 lb. It also says that the pogo stick uses a patented system of elastometric rubber springs that provides up to 1200 lbs of thrust, something common helical spring sticks simply cannot achieve (rubber has 10 times the energy storing capability of steel). a. Use Figure P8.32 to estimate the maximum compression of the pogo sticks spring. Include the uncertainty in your estimate. b. What is the effective spring constant of the elastometric rubber springs? Comment on the claim that rubber has 10 times the energy-storing capability of steel. c. Check the ads claim that the maximum height a jumper can achieve is 6 ft.