A 2.50 mL aliquot of a solution that contains 3.85 ppm Fe(III) is treated with an appropriate excess of KSCN and diluted to 100.0 mL. What is the absorbance of the resulting solution at 580 nm in a 0.50 cm cell? (Molar absorptivity of Fe (SCN)2+is 7.0 x 105L mol-1cm-1).   AW: K =39.098 S=32.08 C=12.011 N=14.007 Fe=55.845

Q: When I was a boy, I watched Uncle Wilbur measure the iron content of runoff from his banana ranch.…

A: Beer’s Law- The absorbance of solution is directly proportional to the concentration(c) and path…

Q: arefully weighed 280mg Calcium carbonate was used in the standardization of an EDTA solution.…

A: Millimoles of a component is calculated by - concentration (mol/L or M) × volume used (mL). While…

Q: Calculate the solubility of PLCCNy IN a 12M solution of CacCN), KSP FOR Pb (CN) = 4.8x10-51

A:

Q: A 50.00-mL aliquot of solution containing 0.358 of MgSO4 (FM 120.37) in 0.500 L required 38.08 mL of…

A: Solution - According to the question - Given - Total Moles of Mg2+ = moles of MgSO4 = mass/molar…

Q: A 3650-mg sample containing bromate and bromide was dissolved in sufficient water to give 250.0 mL.…

A:

Q: . Titration of Ca²+ and Mg²+ in a 50.00-mL hard water sample required 23.65 mL of 0.01205 M EDTA. A…

A: A question based on environmental pollution that is to be accomplished.

Q: The molar absorptivity of a compound at 500 nm wavelength is 252 M-1cm-1. Suppose one prepares a…

A: 1.)  We would use formula of Absorbance.        Note : As you have uploaded two questions, I'll…

Q: 5. A 0.1093-g sample of impure NażCO3 was analyzed by the Volhard method. After adding 50.00 mL of…

A: Given: Mass of impure sample = 0.1093 g Concentration of  of AgNO3 = 0.06911 M Volume of AgNO3 =…

Q: of parts per million calcium carbonate (100.0869 g/mol) in a 50.00  mL aliquot of milk sample. The…

A: Ppm is equal to mg/L   Millimoles = molarity*volume (in ml) Milligrams= molar mass * millimoles

Q: Amount of sodium salicylate in each tablet = % labelled amount =

A:

Q: A 2.5 x 10 M solution of a colored complex in a 1.00 - cm cell has an absorbance of 0.300. What is…

A: Interpretation -  To determine the absorptivity ( in L/mole-cm) when a 2.5 ×10-4 M solution of a…

Q: Why is 0,200 M Fe(NO3)3 in 0,1 M in HNO3 used as a blank solution instead of water, which has 0…

A: Given: Concentration of Fe(NO3)3=0.200 M Concentration of HNO3=0.1 M

Q: Report the %w/w KCl and NaBr in the sample.

A: %w/w=mass of solutemass of solution×100   this is the one of the method to calculate the…

Q: What mass of ZnS (Ksp = 2.5 x 10-22) will dissolve in 300. mL of 0.050 M Zn(NO3)2? Ignore the basic…

A: The mass of Zinc Sulfide has to be given, The balanced chemical equation is, Zns(s)⇔Zn2+(aq)+S2-(aq)…

Q: The amount of iron in a meteorite was determined by a redox titration using KMnO4 as the titrant. A…

A: Redox titration involves the determination of concentration of a given analyte by using the concept…

Q: Calculate Qsp for calcium fluoride (Ksp = 3.9 ×10–11) when 180.0 mL of a 7.95×10-3 M  solution of…

A: In a saturated solution, the molar solubility of salt is used to determine the solubility product.…

Q: A standard solution was put through appropriate dilu tions to give the concentrations of iron shown…

A:

Q: The Ksp for Ca(IO3)2 at 25°C = 7.1 x 10-7. What is the molar solubility of Ca(IO3)2 in a solution…

A: This is common ion effect where the simultaneous equilibrium will be followed So apply this concept…

Q: Calculate the hardness in terms of parts per million calcium carbonate (100.0869 g/mol) in a 50.00…

A: Given: Volume of milk sample = 50 mL Volume of EDTA solution = 10 mL Molarity of EDTA solution = 8 x…

Q: 0.500 g of an impure ammonium sulfate sample is dissolved in water and treated with an excess of…

A: The reaction that takes place is following: (NH4)2SO4 + 2NaOH --> NH4OH + Na2SO4. Ammonium…

Q: A mixture containing only KCl and NaBr is analyzed by the Mohr method. A 0.2125- g sample is…

A: Given, Total mass of sample = 0.2125 gVolume of AgNO3 required for titration = 25.63 mLConcentration…

Q: Salt MgCO3 Mg(OH)2 Theoretical Ksp 3.5 x 10-8 1.8 x 10-11 For the standardization of the HCI…

A: Dear student acc to bartleby guidelines I can solve only first three subparts of the posted…

Q: The following data were obtained from the spectrophotometric titration of Cu(II) and Ca(II) in an…

A: One mole of oxygen atoms contains 6.02214179×10236.02214179×1023 oxygen atoms. Also, one mole of…

Q: Salt Theoretical Ksp MGCO3 3.5 x 108 Mg(OH)2 1.8 x 10-11 For the standardization of the HCl titrant,…

A:

Q: Determine the concentration of [Fe(SCN)2+_std] if the standard solution was made using 18 mL of 0.2M…

A: The solution is given below -

Q: A 50.0 mL aliquot of solution contairing 0.450 g of MgSO4 (FM 120.37) in 0.500L required 37.6 mL of…

A: EDTA titration :-  It is a complexometric titrations . EDTA is short form of…

Q: 1. How much volume (mL)  is needed to standardize 0.05M of EDTA using 180mg of magnesium ribbon? MW:…

A:

Q: To measure the iron content of runoff from a ranch a 25.0 mL sample of run off was acidified with…

A: The Beer-Lambert’s law, the absorbance (A) is directly proportional to the concentration (c) of the…

Q: EDTA abstracts bismuth(III) from its thiourea complex: Bi1tu26 31 1 H2Y22 S BiY2 1 6tu 1 2H1 where…

A: The photometric titration curve involves the plot of the absorbance of a solution against the volume…

Q: The molar absorptivity of a compound at 500 nm wavelength is 252 M-1cm-1. Suppose one prepares a…

A: Given :- Wavelength =500nm              Molar Absorptinity = 252 M-1cm-1              Moles of…

Q: You wish to measure the iron content of the well water on the new property you are about to buy. You…

A: data for  reference standard Fe3+ solution V1 = 14ml.  V2 = 60ml. M1 =5.74×10−4 M   , M2 =? path…

Q: In a solution kept constant by buffering to pH= 8.0, 50.0 mL of 0.0050 M Ni2+ is 0,0100 İn titration…

A: The question is based on the concept of quantitative analysis. We have to calculate pNi at different…

Q: II. A saturated solution of Ca(lO3)2 was prepared by dissolving pure Ca(IO3)2 in D.I. water; after…

A: #(i): IO3-(aq) reacts with S2O32-(aq) according to the reaction below: IO3-(aq) + 6S2O32-(aq) +…

Q: A standard solution contains 100 ppm of Fe, which was found to have an absorbance of 0.151 au at 508…

A:

Q: A standard solution was put through appropriate dilutions to give the concentrations of iron shown…

A:

Q: a. What is the solubility of silver chromate in 0.0600 M silver nitrate solution with a Ksp = 1.0 x…

A: Subpart a: Ksp for Ag2CrO4 is given below, Molar solubility of silver chromate can be taken as s.…

Q: Calcium phosphate (Ca3(PO4)2; MM = 310.18 g/mol), a large component of human bones and teeth, has a…

A: As you have asked multiple questions. So we will only answer the first three parts. If you want any…

Q: What mass of ZnS (Ksp = 2.5 x 10-22) will dissolve in 325.0 mL of 0.050 M Zn(NO3)2? Ignore the basic…

A: Since Zn(NO3)2 is completely soluble in water as  Zn(NO3)2 -----> Zn2+ + 2 NO3-  Hence…

Q: A 370.00 mL solution of 0.00190 M AB5 is added to a 200.00 mL solution of 0.00165 M CD2. What is…

A: According to the mole concept, in terms of mass, the amount of substance in moles is equal to the…

Q: aliquot was then titrated with EDTA 0.0040 mol/L and the average volume spent was 15.01 mL. To…

A: Given: Mass of tablet=1.25g Volume of solution=1.0L Volume of aliquot = 10.0mL Molarity of…

Q: A 5.00 mL tap water sample was measured out with a volumetric pipette, and added to a 25 mL…

A:

Q: The un-ionized form of the weak acid HA does not absorb in the visible region. When it ionizes, its…

A: A question based on equilibrium concept, which is to be accomplished.

Q: Given the following data during the potentiometric titration of 75.00 mL unknown NaCl solution by…

A:

Q: The amount of iron in a meteorite was determined by a redox titration using KMnO4 as the titrant. A…

A:

Q: Construct a titration curve (E vs. Vtitrant) for the titration of 25.00 mL of 0.100 M Fe2+ with…

A: Answer : We have Fe+2 as initial solution and Ce+4 is as titrant As reduction potential of  Ce+4 is…

Q: Report the %w/w KCl and NaBr in the sample.

A: %w/w is used to calculate the concentration. formula, %w/w=mass of element in gramsmass of sample…

Q: ne formation constant for [Cu(CN)2] is 1.0 x 1016, what is the value of the dissociation constant…

A: Applying concept of chemical constants relationship between two chemical reaction.

Spectroanalytical Methods

Spectroanalytical methods measure the wavelength and intensity of radiations that are either emitted or absorbed by a molecular or atomic species. These methods are useful for evaluating the electronic or atomic arrangement of the molecules of a given analyte.