A 12" water main is being installed along the shoulder of a rural road. The excavation for the water main will be 4 feet deep and 3.5 feet wide. The soil is estimated to have a swell factor of 0.80 and an angle of repose of 31 degrees. If the stockpile will start 2 feet from the edge of the excavation, and the distance from the edge of the trench to the limits of disturbance is 20 feet, what is the estimated clear space between the far toe and of the stockpile and the limits of disturbance?

A 12" water main is being installed along the shoulder of a rural road. The excavation for the water main will be 4 feet deep and 3.5 feet wide. The soil is estimated to have a swell factor of 0.80 and an angle of repose of 31 degrees. If the stockpile will start 2 feet from the edge of the excavation, and the distance from the edge of the trench to the limits of disturbance is 20 feet, what is the estimated clear space between the far toe and of the stockpile and the limits of disturbance?

Name: A 12" water main is being installed along theshoulder of a rural road
Uploaded: 2024-03-20T06:56:55.000Z
Channel: Bartleby
Description: A 12" water main is being installed along theshoulder of a rural road. The excavation for thewater main will be 4 feet deep and 3.5 feetwide. The soil is estimated to have a swell factorof0.80 and an angle of repose of 31 degrees. If thestockpile wi

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

After completing the ENGR 315 hands-on project Sparky decided to create a symbolic solution for the time it takes for water to drain from the bottle. Sparky will compare the times to a YouTube video of the hands-on project. Sparky’s bottle is 4 inches in diameter and contains three holes of equal size (not what was required by the hands-on experiment). The hole size of diameter (dhole) is in inches and the holes are L inches apart. There is Ltop inches was water above the top hole at the start of the experiment (as shown in the figure). Neglecting viscous effects (orifice coefficient) and considering the flow conditions to be quasi-steady (consistent with the hands-on experiment) create a symbolic solution for the time it takes for water to stop draining from the top hole. The density (ρ) and specific weight (γ) of the water are 1.94 slugs/ft3 and 62.4 lbf/ft3, respectively. The height of water above the first hole is h, which varies with time. The flow through each hole is the…
An engineering student has been given the assignment of designing a hydraulic holding system for a hay-baling system. The system has four cylinders with 120 mm diameter pistons with a stroke of 0.320 m. The lines connecting the system are 1 cm id (inside diameter). There are 15.5 m of lines in the system. For proper design, the reserve tank should hold a minimum of 50 percent more than the amount of hydraulic fluid in the system. If the diameter of the reserve tank is 30.48 cm, what is the shortest height it should be?
If the total ocean bottom depth is 5500 ft and the first layer depth is 13000 ft and the second layer depth is 15000 ft. The specific gravity of the rock in the first layer is 2.65 gm/cc while the second is 2.71 gm/c. Calculate the temperature, hydrostatic pressure, lithostatic pressure, and the effective pressure. Assume the temperature gradient is 1.25 °F/100 ft. What is optimum drilling mud density (Ib/ft') used if an oil well to be drilled to depth of 15000 ft in this formation?
The water of a 14’ × 48’ metal frame pool can drain from the pool through an opening at the side of the pool. The opening is about h = 1.05 m below the water level. The capacity of the pool is V = 3740 gallons, the pool can be drained in t = 10.2 mins. P0 is the pressure of the atmosphere. ρ is the density of the water. a. Write the Bernoulli’s equation of the water at the top of the pool in terms of P0, ρ, h. Assuming the opening is the origin. b. Write the Bernoulli’s equation of the water at the opening of the pool in terms of P0, ρ, h and v, where v is the speed at which the water leaves the opening. Assuming the opening is the origin. c. Express v2 in terms of g and h. d. Calculate the numerical value of v in meters per second. e. Express the flow rate of the water in terms of V and t. f. Express the cross-sectional area of the opening, A, in terms of V, v and t. g. Calculate the numerical value of A in cm2
A vertical sluice gate 3m wide and 2.5m deep contains water on both of its sides. On the upstream side, the water is 5m deep and on the downstream side it is 2m deep from the bottom of the sluice. What is the resultant pressure on the gate? Water 5m 111 2.5m Hinge 2.5m Water 2m
Find the wetted area if wetted perimeter is 16 m Hydraulic radius is 1.5 m
•) COMPUTE THE DEPTH OF THE bCEAN IF THE PRE SSURE SEABED AT 531.5 IN HG. THE AUERAGE SPECIFIC GORAVITY OF SEAWATER 1. 12.
Derive the formula that gives the pressure associated with the depth for the case where the spesific grauity varies throughout the depth 8(4) = 8surface t S. hs depth at the surface %3D a pasitive constant.
A glass tubing consist of 5 vertical stems which are 500 mm apart connected to a single horizontal tube. The tube is filled with water to a depth of 500 mm in the vertical stems. How fast should it be rotated about an axis through the middle stem to just zero the depth of water in that stem? Ans: o = 42.3 rpm %3D
A fluid is being pumped through a pipe. The density of fluid is 872 kg/m³. The viscosity is 2.8x102 Pa.s. The velocity in the pipe is 5.9 m/s. If the Reynolds number is 2100. a- What is the pipe cross-sectional area? b- If the pipe cross-sectional area increased 1.5 fold under same Reynold number, density and viscosity, what is the new velocity?
Gate ABC in Fig has a fi xed hinge line at B and is2 m wide into the paper. The gate will open at A to releasewater if the water depth is high enough. Compute the depthh for which the gate will begin to open.
A trough is 6 feet long and 11 foot high. The vertical cross-section of the trough parallel to an end is shaped like the graph of y=x8y=x8 from x=−1x=−1 to x=1x=1. The trough is full of water. Find the amount of work required to empty the trough by pumping the water over the top. Note: The weight of water is 62 pounds per cubic foot. Remember to add correct units!