94. In an a.c. series circuit, the inductive reac-tance is 20 92, the capacitive reactance is 602, the resistance is 30 2 and the current is 2A. The impedance of the circuit is(0)(iii)50 Ω12.592(ii) 25 Q(iv) 84Ω

Given: In a series AC circuit XL=20 ΩXC=60 ΩR=30 ΩI=2 A

94. In an a.c. series circuit, the inductive reac- tance is 202, the capacitive reactance is 60 22, the resistance is 30 22 and the current is 2 A. The impedance of the circuit is (i) 5022 (iii) 12:5Ω (ii) 25 Ω (iv) 8.492

94. In an a.c. series circuit, the inductive reac- tance is 202, the capacitive reactance is 60 22, the resistance is 30 22 and the current is 2 A. The impedance of the circuit is (i) 5022 (iii) 12:5Ω (ii) 25 Ω (iv) 8.492

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Related questions

Q: What is wrong with this circuit? V₁ 24 V R₁10 kn D₁ 1N4744A 15 V 4.790 VR₂2.5 k RL

A: The given circuit diagram is shown below:

Q: If F(s) = 3 s2

A: GIVEN: F(s)=3s2 FIND: f(t)

Q: 7. Calculate the a and ß when the emitter current of BJT is equal to 1 mA and the collector current…

A: Given: In a BJT IE=1 mAIC=0.995 mA

Q: What are the effective specifications of digital communication system? Is the higher the…

A: Components of digital communication system Transducer Encoder Decoder Modulator Demodulator

Q: For the given Darlington Pair Circuit, both transistors ß = 50 and the VBE = 0.7 V. To get the VCEQ…

Q: Vhen the positive terminal of a digital dc voltmeter is connected at the Vo terminal nd negative…

Q: Define which type of Mux best fits the function and use all the combinational logic that is…

A: For the given minterms we need to design it by using multiplexer circuit.

Q: 5. The total charge entering a terminal is given by q = 5t sin 4πt mC. Calculate the current at t =…

A: Given, Total charge entering a terminal is given by q=5tsin4πt mC Time, t=0.5 s

Q: then f(t) equals:

Q: . Calculate the minimum bilateral Nyquist bandwidth, FN, and baud, for a modulator 8-PSK with 20…

Q: What are the characteristics of an ideal operational amplifier?

A: The solution is provided in the following section.

Q: 5.a) A 4 pole, 3 phase induction motor operates from a 50 Hz supply. Calculate (a) Speed at which…

A: 5.a) For the 3- phase Induction motor, To find (a) Speed at which the magnetic field of the stator…

Q: Which of the following is a causal and stable system: Select one: O y(t) = tx(t) + 3 O y(t) =…

A: Given data, In option (i) function is given as txt+3 here xt is multiplied with t so it will be a…

Q: this is not incomplete, and please do not answer its functioning of parts answer should be on point…

A: It is asked to explain the isolated operation of wind farms.

Q: Compute the Fourier transform of x(n) = u(n) - u(n-8). [ 1 - e-j8 ] / [1 - e-j2® ] [1-e¹8 ] /…

Q: A single-phase half-controlled rectifier supplies a 220 V, 1200 RPM, 10 A rated DC motor from a 220…

A: Single-phase half-controlled rectifier: It converts AC input to DC output and controlled means that…

Q: Given the periodic signal x(t) with A= 4 and T = 2. The Fourier series coefficient ao of x(t) is…

A: The periodic signal repeat itself after fixed interval of time . The periodic signal are transform…

Q: Find the output waveform from the given circuit and input waveform. 2V KO 10 k V m 20

Q: 3.3 The active power of a 440-V, 3-phase lagging power factor load is measured by two-wattmeter…

Q: 1 Given Vi=4mV, determine the Zi, Zo, Vo, and Av. (Non-anonymous question) V₂0H Ζ΄ 1.5 ΚΩ Z; +15 V…

A: The given circuit diagram is shown below: It is given that: IDSS=8 mA=8×10-3 AVP=-2.8 Vrd=40…

Q: 2- A message signal given by m(t) = 3 cos (400 t+n/2) is sampled with the minimum sampling rate…

A: For the given sinusoidal message signal we need to calculate all the pulse code modulation…

Q: 3- Choose the correct answer: a. If the system requires lower system complexity, which system do you…

Q: Explain hybrid operation of wind farms

A: Hybrid operation of wind farms: Any combination of wind energy with another additional form of power…

Q: What is the magnitude of the force required to stretch a 10 cm-long spring, with spring of 100 N/m,…

A: here we have to find the force required to stretch the 10 cm long spring , with spring constant of…

Q: 1. The circuit shown below is a dc model of a residential power distribution circuit. Use the…

Q: Calculate the maximum bit rate for an FSK signal with a mark frequency of 102 kHz, 104 kHz space…

Q: f preceden

A: Given as,

Q: Determine the step respones of this first order system

Q: speed of rpm armature current of 200 A. The resistance of armature is 0.12 02. Calculate the speed…

Q: Using the discrete-time signals yı[n] and y₂[n] where: y1 [n] [-1 0 1 3 - 1 3 - 1] and y2[n] = [-2…

Q: The power radiated by an AM transmitter for 100% modulation is 900 W. Find the power radiated by the…

A: Given, For 100% modulation, μ1=1 Total radiated power, Pt1=900 W For 70.7 % modulation, μ2=0.707 The…

Q: For op-amp circuit shown in fig. 10.80, Determine the bandwidth with feedback when the gain…

A: For the circuit shown in the figure, Gain * BW = 2.6 x 108 Hz with feedback So if we are able to…

Q: Use a 0.05-µF capacitor to design a high-pass filter to have cutoff frequency of 100 krad/s. Draw a…

A: The required circuit can be designed with the help of capacitor and resistor. The capacitor will…

Q: equal to: 05 on The function F(s) = 58² +1 8(8²+5) has a final value

A: Given data, Function is given, Fs=5s2+1ss2+5

Q: V, is a 60Hz source with a peak voltage VP-120V is feeding a rectifier, assume ideal diode. The load…

A: Given circuit, Peak voltage, VP=120 V Load resistance, R = 10 kΩ Ripple voltage, Vr=2 V

Q: In order to connect a LED to one of the pins: O You need to define that LED as an OUTPUT in the…

A: An Arduino circuit with LED and a button, when we press the button the LED should be ON and when the…

Q: In order to connect a LED to one of the pins: O You need to define that LED as an OUTPUT in the…

A: As per Bartleby policy we can answer only three question(MCQ) at a time. As you have not mentioned…

Q: 1. The hot resistance of a 250V filament lamp is 625 2. Determine the current taken by the lamp and…

A: Given data, Voltage V = 250 V Resistance R=625 Ω

Q: Determine the maximum bit rate for an FSK signal with a mark frequency of 48 kHz, 52 kHz space…

Q: From the circuit shown in the figure, assume LED1 has a forward voltage of 2 volts and 20 Q forward…

A: For the given circuit diagram we need to calculate the value of current I1.

Q: A substation has two feeders, Sub Feeder-A have demand at a time is 35 KW and Sub Feeder-B have…

A: Given data, Individual demand is given, Demand on feeder A is 35 KW Demand on feeder B is 42 KW…

Q: xplain basic requirements of lightning arrestor

A: On the category of arrester under consideration, quality is dependent. A distribution arrester, for…

Q: Consider the following RLC circuit: 1): 2) [t vi(t) i(t) R L () I(0) V.(0) Assuming zero initial…

Q: A system that its output at a given time depends only on the input at the same time is said to be O…

A: Given statement: A system that its output at a given time depends only on the input at the same time…

Q: An information source consists of A, B, C, D and E, each symbol appear independently, and its…

Q: A controller is designed so that the nominal closed-loop transfer function has bandwidth 0.3 rad/s…

A: Given,Bandwidth of closed-loop transfer function is,BW=0.3 rad/secSlope at high frequencies…

Q: (a) For each of the signals given, determine mathematically whether the signal is even, odd, or…

A: Given data, (i) x[n]=6u[n-3] (iv) x[n]=6+.2n+.2-n (vi) x[n]=sinn-π6

Q: QUESTION 4 For an n-channel Junction Field-Effect Transistor (JFET), the gate-source cut-off…

Q: For the given circuit and input waveform determine the output waveform. a. b. C. d. 15 a b -10 20 20…

Q: When 7A current is flowing in electric circuit then the electric potential difference between B B…

Question

94. In an a.c. series circuit, the inductive reac-
tance is 20 92, the capacitive reactance is 60
2, the resistance is 30 2 and the current is 2
A. The impedance of the circuit is
(0)
(iii)
50 Ω
12.592
(ii) 25 Q
(iv) 84Ω

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Sinusoids and Phasors of Alternating Circuit

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

a capacitor and a resistor are connected in parellel to a 120 v 60 hz line the resistor has a resistance of 40 ohms and the capacitor has a capacitance of 132.6 uf what is the total current flow through the circuit. what is the impedence and the power factor and how many degrees out of phase are the current and voltage out phase with eachother.
A series circuit contains a 20 ohm resistor anda inductor with an inductance of 0.093H if the circuit has a fequencey of 60Hz what is the inductive reactance Xl and total impedance Z of the circuit?
12. A series RC circuit contains two resistors and two capacitors. The resistors are 68 N and 56 2. The capacitors have capacitive reactances of 66 2 and 33 2. The applied voltage is 240 V. What is the voltage drop on the 56 Q resistor? a. 39.83 V b. 49.91 V c. 84.70 V d. 102.85 V cronta apong nac.couq
33. In a series RC circuit, the resistor voltage is 124 V and the capacitor voltage is 167 V. What is the total voltage? a. 111 V b. 143 V c. 208 V d. 240 V
A resistor of 150 ohms, a coil with reactance 100 ohms and a capacitor with reactance 200 ohms are connected in series. What is the complex impedance R + jX?
A resistor, a capacitor, an inductor, and a mystery component are connected in parallel. The resistor has a resistance of 300Ω, the capacitor has a reactance of 250Ω, and the inductor has a reactance of 600Ω. The total impedance of the circuit is 59.52-j119.64Ω. What is the mystery component?
The term sin ( ø - 0)e-at of the resultant current in series R.L circuit transient is Subtransient part Steady state part O Transient and subtransient part O Transient part
What will be magnitude of the total circuit impedance of a series LR circuit excited by a 100 Hz ac source? The resistance is 40 ohm and the inductance is 4 mF.
A 206.0-2 resistor and a 2.80-µF capacitor are connected in series across the terminals of a sinusoidal emf with a frequency of 150 Hz. The inductance of the circuit is negligible. What is the impedance of the circuit?
QUESTION 6 A resistor, a capacitor, and an inductor are connected in series with a mystery component. The resistor has a resistance of 1000, the capacitor has a reactance of 5000, and the inductor has a reactance of 2000. The total impedance of the circuit is 100-j4000. What is the mystery component? O there is no mystery component O inductor O resistor O capacitor
An RL series circuit is connected to a 240 volt 60 hz line the capacitor has current of 1.25 amperes flowling though it. the Xc of the inductor is 22 ohms. the resistor has a resistance of 16ohms. how much voltage is dropped across the resistor?
A resistor, a capacitor, and an inductor are connected in series with a mystery component. The resistor has a resistance of 500Ω, the capacitor has a reactance of 100Ω, and the inductor has a reactance of 500Ω. The total impedance of the circuit is 700+j400Ω . What is the mystery component?