6.5. A mass-spring system oscillates freely with a period of 2.6 seconds. After a viscous damper is attached, the resulting mass - spring damper system is observed to oscillate with a period of 3.0 seconds. Determine the damping factor for the system. The mass-spring-damper system is displaced and released from rest. Using the plot of the response of the system, estimate the damping factor from the measured response. x(t) 0. ac) 0.4 0.2 of -0.2 -04 -0. 10

6.5. A mass-spring system oscillates freely with a period of 2.6 seconds. After a viscous damper is attached, the resulting mass - spring damper system is observed to oscillate with a period of 3.0 seconds. Determine the damping factor for the system. The mass-spring-damper system is displaced and released from rest. Using the plot of the response of the system, estimate the damping factor from the measured response. x(t) 0. ac) 0.4 0.2 of -0.2 -04 -0. 10

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

elapse before the amplitude of the free vibration 2.22 A one-degree-of-freedom system has an undamped natural frequency of 20 Hz and a criti- cal damping ratio of 0.005. It is released with no initial velocity at 60 mm from the static equilib- rium position. Approximately how much time will does not exceed 10 mm?
A linear harmonic oscillator having a mass of 3.0kg is set into motion with viscous damping. if the frequency is 12HZ and if two successive amplitudes a full cycle apart are measured to be 4.65mm and 4.30mm, compute the viscous damping coefficient. Note: Give your answer to 3 decimal places x (t) Other Parameters: Logarithmic Decrement (6): Answer: x2 X, -In1 X2 21 C 8 = In =5wn Td = 5wn %3D Xn+1 a2m Damping Ratio (5): 5 = %3D t [s] 2vkm Cc 2man Frequency of damped vibration (wa): wa = Undamped Forced Vibration: Fo/k Frequency Ratio (r): r - p-xsin wt Next page ous page Type here to search
3. A 100-pound weight is suspended from a vertical spring whose module is 100 pounds per foot. The weight is pulled downward 9 inches from its equilibrium position and released. Viscous fluid exerts 20 Ibs of force when the plunger moves through it at 0.5 ft/sec; 3.a What is the damping condition? Write the equation which describes the motion of the weights. Show graph. 3.b displacement 3.c velocity 3.d acceleration
A spring mass system with a natural frequency fn = 20 Hz is attached to a vibration table. Thetable is set to vibrate at 16 Hz, with a maximum acceleration 0.25 g. Answer the followingquestions. Justify your answers d. What is the maximum acceleration of the mass assuming the packaging can be modeled asa viscous damper with a damping ratio of 0.2?e. Is the motion of the mass in phase or out of phase with the motion of the table?
A linear harmonic oscillator having a mass of 5.4kg is set into motion with viscous damping. if the frequency is 7Hz and if two successive amplitudes a full cycle apart are measured to be 4.65mm and 4.30mm, compute the viscous damping coefficient. Note: Give your answer to 3 decimal places Other Parameters: x (t) Logarithmic Decrement (6): Answer: x2 2nC 2n C 2T 8 = In1 = In1 = 5 wnTd = 5 wn %3D X3 X2 Xn+1 uz Pm Damping Ratio (5): 5 = %3D t [s] (2T)2+8 Cc 2vkm 2mwn Wn Frequency of damped vibration (wa): wa = Undamped Forced Vibration: Fo/k x sin ot Frequency Ratio (r): r = Next page jous page E//learnonline.gmit.ie/mod/quiz/attempt.php?attempt3D167036&cmid%3D155306&page%3D2... P Type here to search 3| 5
An electric motor of mass 25 kg is supported on a three-spring system. Thesprings are arranged in parallel, with the three stiffnesses being 10 kN/m,5 kN/m and 25 kN/m respectively. Viscous damping is present within the systemand has a magnitude of 0.4 kNs/m.i) Produce a sketch of the system and state its equation of motion.ii) Determine the damping ratio and comment on its value.iii) Determine the amplitude of vibration of the motor 5 cycles afterit is released from an initial displacement of 15 mm.
A mass of 5 kg is suspended on a spring and set oscillating. It is observed that the amplitude reduces to 5% of its initial value after 2 oscillations. It takes 0.5 seconds to complete two oscillations. Calculate the following: the damping ratio the natural frequncey the actual frequency spring stiffness the critical damping coefficient the actual damping coefficient
Electric motor, dashpot, and spring system. The total mass of the system is 21.5 kg. The motor runs at 500 RPM. The spring has a stiffness of 6400 N/m and the dashpot offers a resistance of 500 N at 4.0 m/sec. The unbalanced mass of 0.65 kg rotates at a 0.04m radius. Calculate damping factor, the amplitude of vibration, phase angle, resonant speed, resonant exerted by the spring and dashpot. amplitude, and force
The period ra of damped linear oscillation for a certain 0.7 kg mass is 0.25 s. If the stiffness of the supporting linear spring is 780 N/m, calculate the damping coefficient c. Insert your answer for c in N. s/m correct up to at least a third decimal place.
Problem 6: An object of mass 2 kg is attached to a spring of stiffness 200 N/m on a horizontal frictionless surface. Then it is extending by 10 cm and then let free to oscillate. 1- How long will it take to make one complete oscillation? 2- Determine the amplitude and give an expression for the displacement as a function of time. 3- Calculate its displacement, velocity, acceleration and force acting on it after sec. 4- Calculate its velocity by the time it is extended by 0.5 cm.
a damper, the frequency of oscillation is found to the stiffness of the spring is 1 kN/m. By introducing coefficient of the damper? be 90% of the original value. What is the damping In a spring-mass system, the mass is 0.1 kg and the stiffness of the spring is 1 kN/m. By introducing be 90% of the original value. What is the damping (a) 1.2 Ns/m (b) 3.4 Ns/m (c) 8.7 Ns/m (d) 12.0 Ns/m
Subject: mom and vibrations A solid shaft having diameter , length and modulus of rigidity ⁄ is attached to a circular disc which has mass moment of inertia . If this system is allowed to vibrate in a viscous medium, and the amplitudes of vibratory motion on one side of the mean position for consecutive cycles are found to be respectively; (iii) The torsional stiffness of the solid shaft (iv) The torsional damping coefficient of the system (iv) The time period for damped vibration