5) Which one of the following statements is true? The enthalpy change for a for a reaction is independent of the state of the reactants and products. Enthalpy is a state function. H is the value of q measured under conditions of constant volume. The enthalpy change of a reaction is the reciprocal of the AH of the reverse reaction. Page 2 of 8

5) Which one of the following statements is true? The enthalpy change for a for a reaction is independent of the state of the reactants and products. Enthalpy is a state function. H is the value of q measured under conditions of constant volume. The enthalpy change of a reaction is the reciprocal of the AH of the reverse reaction. Page 2 of 8

Chemistry for Engineering Students

4th Edition

ISBN:9781337398909

Author:Lawrence S. Brown, Tom Holme

Publisher:Lawrence S. Brown, Tom Holme

Chapter9: Energy And Chemistry

Section: Chapter Questions

Problem 9.101PAE

See similar textbooks

Similar questions

The heat of neutralization, Hneut, can be defined as the amount of heat released (or absorbed), q, per mole of acid (or base) neutralized. Hneut for nitric acid is -52 kJ/mol HNO3. At 27.3C, 50.00 mL of 0.743M HNO3 is neutralized by 1.00 M Sr(OH)2 in a coffee-cup calorimeter. (a) How many mL of Sr(OH)2 were used in the neutralization? (b) What is the final temperature of the resulting solution? (Use the assumptions in Question 11.)
How much heat is produced when loo mL of 0.250 M HCl (density, 1.00 g/mL) and 200 mL of 0.150 M NaOH (density, 1.00 g/mL) are mixed? HCl(aq)+NaO(aq)NaCl(aq)+H2O(l)H298=58kJ If both solutions are at the same temperature and the heat capacity of the products is 4.19 J/g C, how much will the temperature increase? What assumption did you make in your calculation?
9.41 Under what conditions does the enthalpy change equal the heat of a process?
Although the gas used in an oxyacetylene torch (Figure 5.7) is essentially pure acetylene, the heat produced by combustion of one mole of acetylene in such a torch is likely not equal to the enthalpy of combustion of acetylene listed in Table 5.2. Considering the conditions for which the tabulated data are reported, suggest an explanation.
Using the data in Appendix G, calculate the standard enthalpy change for each of the following reactions: (a) Si(s)+2F2(g)SiF4(g) (b) 2C(s)+2H2(g)+O2(g)CH3CO2H(l) (c) CH4(g)+N2(g)HCN(g)+NH3(g) ; (d) CS2(g)+3Cl2(g)CCl4(g)+S2Cl2(g)
When one mol of KOH is neutralized by sulfuric acid, q=56 kJ. (This is called the heat of neutralization.) At 23.7C, 25.0 mL of 0.475 M H2SO4 is neutralized by 0.613 M KOH in a coffee-cup calorimeter. Assume that the specific heat of all solutions is 4.18J/gC, that the density of all solutions is 1.00 g/mL, and that volumes are additive. (a) How many mL of KOH is required to neutralize H2SO4? (b) What is the final temperature of the solution?
When 2.50 g of methane burns in oxygen, 125 kJ of heat is produced. What is the enthalpy of combustion per mole of methane under these conditions?
9.73 Without looking up any numerical data or doing calculations, predict whether the enthalpy change for each of the following reactions should he positive, negative, or zero. (a) H2O(l)H2O(s) (b) N2(g)2N(g) (c) CH4(g)+2O2(g)CO2(g)+2H2O(l) (d) CO2(s)CO2(g)
Assume 200. mL of 0.400 M HCl is mixed with 200. mL of 0.400 M NaOH in a coffee-cup calorimeter The temperature of the solutions before mixing was 25.10 C; after mixing and allowing the reaction to occur, the temperature is 27.78 C. What is the enthalpy change when one mole of acid is neutralized? (Assume that the densities of all solutions are 1.00 g/mL and their specific heat capacities are 4.20 J/g K.)
How much heat is produced by combustion of 125 g of methanol under standard state conditions?
A 21.3-mL sample of 0.977 M NaOH is mixed with 29.5 mL of 0.918 M HCl in a coffee-cup calorimeter (see Section 6.6 of your text for a description of a coffee-cup calorimeter). The enthalpy of the reaction, written with the lowest whole-number coefficients, is 55.8 kJ. Both solutions are at 19.6C prior to mixing and reacting. What is the final temperature of the reaction mixture? When solving this problem, assume that no heat is lost from the calorimeter to the surroundings, the density of all solutions is 1.00 g/mL, the specific heat of all solutions is the same as that of water, and volumes are additive.
A 29.1-mL sample of 1.05 M KOH is mixed with 20.9 mL of 1.07 M HBr in a coffee-cup calorimeter (see Section 6.6 of your text for a description of a coffee-cup calorimeter). The enthalpy of the reaction, written with the lowest whole-number coefficients, is 55.8 kJ. Both solutions are at 21.8C prior to mixing and reacting. What is the final temperature of the reaction mixture? When solving this problem, assume that no heat is lost from the calorimeter to the surroundings, the density of all solutions is 1.00 g/mL, and volumes are additive.