4. A three-phase 500kV 60HZ, 700km, completely transposed line has the following positive- sequence impedance and admittance: z= 0.01+j0.32/km y-j3 x 10-S/km What are the impedance and admittance correction factors F1 and F2 for equivalent a circuit? Answer: (A) 0.9281+0.0023i; 1.0754-0.0025i (B) 0.9531+0.0035i;1.0384-0.0013i (C) 0.9281+0.0023i;1.0754+0.0025i (D) 0.9281+0.0023i;1.0384-0.0013i

4. A three-phase 500kV 60HZ, 700km, completely transposed line has the following positive- sequence impedance and admittance: z= 0.01+j0.32/km y-j3 x 10-S/km What are the impedance and admittance correction factors F1 and F2 for equivalent a circuit? Answer: (A) 0.9281+0.0023i; 1.0754-0.0025i (B) 0.9531+0.0035i;1.0384-0.0013i (C) 0.9281+0.0023i;1.0754+0.0025i (D) 0.9281+0.0023i;1.0384-0.0013i

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter2: Fundamentals

Section: Chapter Questions

Problem 2.14MCQ: The instantaneous power absorbed by the load in a single-phase ac circuit, for a general R LC load...

See similar textbooks

Similar questions

If a 3-phase short circuit occurs in one of the two circuit of transmission line at point F, and the shunt impedance of the short circuit is j0.1 pu. Determine the maximum time when a short circuit can still be cleared. So=0.8+j0.3 Xd'= 0.2, XL1=XL2= 0.6, XT1=0.12, Xr2= 0.1, L1 V= 1.0 T1 L2 F T2 .XL= 0.1 Хс- 0.1. S1 S2 SL= 0.6+j0.3
The VSWR on an 50-Ohm transmission line is 5. The distance between successive voltageminima is 80 cm while the distance from the load to the first minimum is 30 cm. What are thereflection coefficient and load impedance
A Three-phase transposed line is composed of one conductor per phase with flat horizontal spacing of D = 14 meters, as shown in the below figure. The conductors have a diameter of 2.6 cm and a GMR of 1.012 cm. Find the capacitance per phase per kilometer of the line. a C D D 2D Select one: O a 0.0088 microF/Km Ob. 0.0077 microF/Km Oc 1.455 microF/Km Od. None of these
Paragraph Styles The power factor must be close to in the transmission lines will be reduced To insure that losses D(Ctrl) -
2. A three-phase transmission line has parameters Xc-6 k 2, R-3.25 2 and X₁-25 92, and delivers 300 MW to a load with both ends of the line at 230 kV. Draw a pi equivalent per-phase circuit of the line. On a per-phase basis, calculate the active power delivered to the load, the reactive power of the line and the active power delivered by the source. Based on these calculations can the equivalent circuit be simplified further?
A 5 km long, 3-phase 34.5 kV line has a horizontal configuration of 4 ft. spacing. The conductor is 336.4 ACSR with GMR of 0.0244. What is the inductance of the line? * A. 7.63 mH B. 4.76 mH C. 5.33 mH D. 6.49 mH
What do you understand by means of power system? A 3-p, 50 Hz transmission [ line is 120 km long. It has a per phase series impedance of 0.05+j0.45 2 per km and a per phase shunt admittance of j3.4*10-6 S per km. It delivers 200 MW load at 220 kV with 80% power factor lagging. Find the voltage regulation and transmission efficiency.
The 13.2 kV 50-Hz generator feeds a load over a line with (Zload) impedance Zline. Load is 800n + j500n and impedance of the line is 20 + j300 a) If the generator is directly connected to the load as given in (a), what will be the line losses? b) If the generator is connected to the load using step-up and step-down transformers as given in (b), what will be the line losses? c) How much is the increase in efficiency compared to (a) from (b)? Zline 2. (a) 1:10 10:1 Zline Tr Tr2 (b) Zload Zload
Problem 4- A large 3-phase industrial load draws 3.6 MVA at 0.85 power factor lagging from through a three- phase 12.47/7.2 kV 3-wire overhead distribution line. The phase conductor is #1 ACSR “Robin". Taking 3.6 MVA and 12.47 kV as base values, determine (a) The base impedance in (N) (b) The reactive power drawn by the load (p.u.) (c) The total current (p.u.) drawn from the power supply
consider the following diagram of impedances in per unit of a common base a) get the YBUS admittance array and the ZBuz impedance array 213-j2 pu zt2-j0.15 zg2-j1.85 791-j0.9 211-0.1 1 212-j0.5pu 223-j0.5pu Va 1 p.u. Jv1-1p.u. 22-10 pu
[Ans. 0.174 HF) A three phase 50 Hz fully transposed line has conductors equilaterally spaced at 3 metres. The conductor diameter is 3 cm. Determine the capacitance to neutral per km per phase. (Gorakhpur Univ. Transmission of Electric Power 1975] [Ans. 0.0105 µFI - UI
A short single phase transmission line has a loop impedance of (0.2+j1.2) ohm. At what leading power factor the voltage regulation will be zero ?