3. Assume the current from the AC source has the following equation. IR R=30 Ω 1 = 5√2 Sin 250t find the desired parameters of the circuit: a) Impedance of the circuit (Z) b) The voltage equation of the AC source (ve) c) The current equation of IR and I₁ d) The phasor diagram of the voltages and currents L X=30 Ω

3. Assume the current from the AC source has the following equation. IR R=30 Ω 1 = 5√2 Sin 250t find the desired parameters of the circuit: a) Impedance of the circuit (Z) b) The voltage equation of the AC source (ve) c) The current equation of IR and I₁ d) The phasor diagram of the voltages and currents L X=30 Ω

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter2: Fundamentals

Section: Chapter Questions

Problem 2.8P: Consider the circuit shown in Figure 2.23 in time domain. Convert the entire circuit into phasor...

See similar textbooks

Similar questions

Consider the circuit shown in Figure 2.23 in time domain. Convert the entire circuit into phasor domain.
Let a 100V sinusoidal source be connected to a series combination of a 3 resistor, an 8 inductor, and a 4 capacitor. (a) Draw the circuit diagram. (b) Compute the series impedance. (C) Determine the current I delivered by the source. Is the current lagging or leading the source voltage? What is the power factor of this circuit?
1) Two identical voltage waveforms of difference phase angles are shown in Figure B. Write down the expression of waveforms A and B clearly. HUS Voltage (V) 8 0 K/N B 7: ST ot
If an electrical circuit draws 100W + J100VAR from a sinusoidal source, then what would the circuit be? Explain why. a) a pure resistor circuit b) a series or parallel R-L circuit c) a series or parallel R-C circuit d) a series L-C circuit
Based on Figures la,1b and 1c and RLC elements, write a discussion on voltage-current relations and power factor.
Let's say V= 10 sin( 2r) is a refence sinusoid. Then its phasor diagram is drawn as shown in Figure 1. V (a) (b) (c) (d) Figure 1 a B
An rms voltage of 22.2 V with a frequencyof 1.00 kHz is applied to a 0.290-mH inductor. (a) What is the rmscurrent in this circuit? (b) By what factor does the current changeif the frequency of the voltage is doubled? (c) Calculate the current for a frequency of 2.00 kHz
an ac circuit has a frequency of 400 hz. a 16- ohms resistor, a 0.0119-h inductor, and a 16.6- uf capacitor are connected in series. If the voltage connected to the circuit is 440v. How many degrees are the voltage and current out of phase with each other?
5) Find the reactance the inductance and impedance of the circuit. Calculate the current of this circuit and the sketch waveform of current and voltage. V1 10 V 60 Hz R1 m 100kQ 12 Vrms 1000 Hz 0° 6) Find the reactance the inductance and impedance of the circuit. Calculate the currents of this circuit R www 502 L L1 106mH eee 10 mH
H.W 2 An AC circuit includes two sections AB and BC in series. The section AB consists of two branches in parallel. The first of these is formed of resistance of 60 2 in series with a capacitor of 50 mF, while the second consists of a resistance of 60 2 having an inductance of 250 mH. The section BC consists of a resistance of 100 N having an inductance of 300 mH. The frequency of the current is 50 Hz. The voltage across section AB is 500 V. What is the voltage across the section BC?
Use 3 decimal places and box the final answer. A 4-ohm resistor is in series with a 7.96-mH inductor connected across a 110-V 60-Hz source. Determine : a) the impedance b) the input current c) the voltage across the resistor and the inductor d) Draw the phasor diagram showing the current and the voltages. e) The power factor and the power input to the circuit.
Impedance of AC circuit and Admittance of AC circuitSHOW THE CIRCUIT USING ANY SOFTWARE OR YOU CAN DRAW IT MANUAALYY thNAKSS