3-1 Discuss the effect of increasing the order of the filter on the frequency response of the filter.

Q: Draw the frequency response as a function of frequency.

A: The given function: I=VSR2+ωL-1ωc2VRVS=IRVS=VSR2+ωL-1ωc2RVS=RR2+ωL-1ωc2

Q: (a) State the difference between the signal in time domain and frequency domain. Explain your answer…

A: According to the Bartley guideline this is a multi part question so we have to do only first part of…

Q: 3. In an FM signal that modulating frequency is a 1.5-kHz sine wave. The carrier frequency is 1000…

A:

Q: What is Frequency Modulation? Draw the waveforms.

A:

Q: 3. -2 2 2 9.

A:

Q: Refer to the filter a. Determine the approximate cutoff frequencies and bandwidth of the filter.…

A: The given circuit is a cascaded low pass and high pass filter and the total response is same as pass…

Q: Gueshon:- Design bandfass filter Sketched as to fass freqpencies belween Seo 300 Hz cnd 10KH2 with…

A: active bandpass filterk=12R=20kohmf1=300 hzf2==10×103ohm

Q: What is the difference between time and frequency domain?

A:

Q: (a) The bandwidth of the nonperiodic signals contains continuous frequencies. A nonperiodic…

A: The bandwidth of the non-periodic signals contains continuous frequencies. A non-periodic composite…

Q: b) Find the bandwidth of a signal that can be decomposed into four sine waves with frequencies at 0…

A: For the above given signals we need to calculate its bandwidth by plotting frequency spectrum. By…

Q: In own understanding, explain how RC and RL works in a circuit?

A:

Q: Identify and draw the odd and even parts of the signal given below

A: Identify the given signal draw the odd and even parts of the signal given

Q: Find the relationship between input voltage which is considered a sinusoidal signal of frequency ω…

A:

Q: Vo Solve for the transfer function H (f) and calculate the cut-off frequency for the circuit Vs in…

A:

Q: 3- a. Calculate and sketch the frequency response of circuit shown in Fige Q3 and hence state the…

A: Note: In case of multiple questions, We are allowed to answer first question only. Please repost…

Q: A subcarrier of 50 kHz is amplitude-modulated by tones of 1.4, 4.1, and 11.4 kHz. The resulting AM…

A: We need to find out total number of frequency in modulated signal

Q: Draw the signal flow graph of the n electrical network. Is A IR R elle Ic C

A: As per company guidelines, I am allow to solve only one question of multi-part question.  Signal…

Q: IpuDis abes c(t) = 4 cos(2710000r) the carmer a. Find an expression n for Single Side Band modulated…

A: Here modulating signal and carrier signals are given and it is asked to find the power of SSBSC…

Q: 3. Explain the different types of Filters with their frequency response curves.

A: Filters are known as frequency selective circuits. Filters are used for getting the desired…

Q: 1. Compute the Band Width and Pow r of AM-DSB-SC ? 2 What is the application of AM-D. B-SC ? 3.…

A: The answers of the following questions are

Q: ☺ Determine the transfer, function G(s): vico) Using Mech Analysıs: eqt %3D

A: We need to find out transfer function from given mesh equation

Q: Consider the system- Y(n)= x(n)+ x(n-10) Compute and sketch its magnitude and phase response.

A: The solution is provided in the following section:

Q: Consider the series resonant circuit shown below. Compute the resonant frequency, bandwidth, and the…

A: In this question we will find resonant frequency , bandwidth and half power frequencies...

Q: determine the fundamental frequency. then sketch the time domain of the signal showing the…

A:

Q: 1 -5 The DC component of the signal is Choose... The period of the signal (in second) is Choose...…

A: The value of DC component of the signal is calculated by using ∫-T2T2x(t) For this signal…

Q: (a) State the difference between the signal in time domain and frequency domain. Explain your answer…

A: According to the Bartleby guidelines this is multipart question so we have to do only first part of…

Q: What kind of filter is used to select a single signal frequency from many signals

A: This problem is from filter .

Q: R1 c2 Us VI 1 Vpk 3.SAHE 21.50 OPAMP ST VIR TUAL R2 R4 2.70

A: The given figure is 2nd order butter-worth high pass filter.

Q: 3) Determine the fundamental period of the signal x[n] = 1 + ej4mn1 – ej2mnl5. %3D

A:

Q: Determine the resonant frequency for the network shown in Fig. RL V L ww

A: Inductor is passive element that store energy in magnetic field. Capacitor is an electrical…

Q: Q3. For the circuit shown a) Derive an expression for the resonant frequency. b) Show that the total…

A:

Q: 1. (a) For the discrete signal shown in Figure 1 below, sketch and label the following signals: (i)…

A:

Q: 3. Explain the different types of Filters with their frequency response curves

A: Filters are known as frequency selective circuits. Filters are used for getting the desired…

Q: ...The type of the filter in the circuit shown is

A:

Q: 2. Draw the spectrum if the signal shown on the first graph is sampled at a. 4kHz b. 7kHz c. What is…

A: While the analog signal is being transmitted, it is first sampled at some particular points and then…

Q: Derive an expression for the resonant frequency of the parallel circuit containing Z₁ = (R1 + ¡XL)…

A:

Q: Q3/ design HPF with R= 4KQand C=40nF then calculate cutoff frequency and draw the frequency response…

A:

Q: 5. Compare and contrast the windowing technique for filter design using a rectangular window versus…

A:

Q: 4 Measure the frequency response of G( ja), and plot it out in Excel:

A: We have to find the frequency response Gjω for the system  shown below and plot it out in Excel:

Q: 8. How do you use Wein's Bridge for frequency measurement? Derive the equation for the frequencu…

A:

Q: Plot both magnitude and phase

A: Given data: Hjω=jω4+1jω20+1

Q: Q3-A) Find the Power and sketch the frequency spectrum of the following signal v(t) = 2+ 6Cos(2n10t…

A:

Q: The spectrum of a certain signal is equal to: 100 X(f) = j2nf(j2nf + 10) Then the signal in time…

A: The given function is: Xf=100j2πfj2πf+10

Q: Q1/- For the shown waveform: 1- Write the equation of the signal e (t). 2- Plot the spectrum of the…

A:

Q: Find DFT values of x- [2 19 2] and plot amplitude and phase spectrum. Write axis labels.

A:

Q: ww- 3. Determine the center frequency and bandwidth of the bandpass filters in Fig. 3. Simulate the…

A: The modified s-domain circuit is shown in Figure 1. Figure 1

Q: 2. A bandpass filter has an upper cutoff frequency of 84.7 kHz and a bandwidth of 12.3 kHz. What is…

A: Write the given values. fH=84.7 kHzBW=12.3 kHz

Q: Determine peak value of frequency response of 2nd order system if damping ratio is 0.4.

A: Given values are =

Filter

A filter is a device or process which removes some of the unwanted features or components like frequencies from a signal in signal processing. The feature of filters is the complete or partial suppression of some part of the signal, and filtering is a class of signal processing. This most often means removing some frequency bands or some frequencies. In the frequency domain, the filters do not exclusively act, especially in the image processing field many other targets for filtering exist. Without having to act in the frequency domain, the correlations can be removed for certain frequency components and not for others. The filters are widely used in electronics and telecommunication, in television, radio, radar, audio recording, music synthesis, control systems, computer graphics, and image processing.