2. Two insulated cylinders A and B with volumes VA = 2.0 m³ and Vs = 5.8 m³ contain chlorine gas at different pressures and temperatures. The cylinders are insulated (no heat is lost to or gained from the outside) and connected by a valve. Initially, the valve is) closed and the gas in the two cylinders has the following values: PA= 4.0x105 N/m², TA= 210 K, PB = 2.5x105 N/m², TB = 580 K. The valve is opened to allow the contents in the two cylinders to mix until the pressure equalizes. valve B a. Assuming there is no change in the temperatures of the containers themselves, determine the final temperature of the gas in the two cylinders. The atomic mass of chlorine gas is 35.4527 u. (1 u = 1.67377x10-27 kg) b. Determine the final pressure?

2. Two insulated cylinders A and B with volumes VA = 2.0 m³ and Vs = 5.8 m³ contain chlorine gas at different pressures and temperatures. The cylinders are insulated (no heat is lost to or gained from the outside) and connected by a valve. Initially, the valve is) closed and the gas in the two cylinders has the following values: PA= 4.0x105 N/m², TA= 210 K, PB = 2.5x105 N/m², TB = 580 K. The valve is opened to allow the contents in the two cylinders to mix until the pressure equalizes. valve B a. Assuming there is no change in the temperatures of the containers themselves, determine the final temperature of the gas in the two cylinders. The atomic mass of chlorine gas is 35.4527 u. (1 u = 1.67377x10-27 kg) b. Determine the final pressure?

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

2. The gas expanding in the combustion space of a reciprocating engine has an initial pressure of 5o bar and an initial temperature of 1623 C. The initial volume is 50000 mm' and the gas expands through a volume ratio of 20 according to the law pV = constant. Calculate w and AU Take R = 270 J/Kg K and C, = 800 J/Kg K. Assume n = 1.38
N = 0 An insulated tank of volume 10+(10+N)/25 m and with a valve was filled with perfect tri- atomic gas at pressure 10 bar, where N is equal to the last two digitals in your student's ID number. Initially the valve was closed. A paddle wheel was mounted inside the tank and was run by 20 kW engine. The paddle wheel was turn on and at the same time the exit valve was opened. The gas temperature was constant though the whole process (due to very slow flow) and equal to 300 K. Calculate the time needed to decrease the pressure in the tank to 5 bar.
V. W. Th To %3D Room temperature T = 293 K V V. Vp The gas volume changes from Vp to Va at constant temperature T. The cartoon on the right shows a piston of gas undergoing this compression while submerged in a container of room temperature water, which acts as a reservoir. The initial state of this process is a piston containing 2 moles of a monatomic gas at Tc = 293 K (room temperature water) and volume V = a 1.0 m. The gas is compressed until V, = 0.2 m. During the compression, the heat bath of room temperature water maintains the temperature of the gas at T 293 K. Calculate the work done in joules by the gas during this process. Do not include units in your answer. Be careful to use the standard sign convention for work done by the gas. Write your numerical answer in normal form as described above in the instructions to this worksheet.
B2. The heat energy of 1605 kJ is supplied to saltwater in the steam generator to heat from 25°C to 104°C for the generation of water vapor, Take the density & specific heat of the solution as 1028 kg/m³ & 3 J/kg°K respectively. Determine the quantity of saltwater in the steam generator. I Solution: i) Change in Temperature (in K) ii) Mass of the saltwater (in kg) iii) Quantity (Volume) of salt water (in m³)
A reservoir contains 2.83 cubic meters of CO at 6895 kPa and 23.6 degrees CELSIUS. A cylindrical tank with h = 1.5D is filled from the reservoir to a pressure of 3497 kPa and a temperature of 12.4 degrees C, while the pressure and temperature in the reservoir decreases to 6205 kPa and 18.3 degrees C respectively. (ANSWER MUST BE EXACT TO CHOICES) a) the total mass of CO transferred to the tank in kg CHOICES 19.62 18.54 203 b) the total volume of the tank in cubic meter CHOICES 0.476 0.495 0.449 c) the diameter of the tank in mm CHOICES 671.8 725 755
2. The gas expanding in the combustion space of a reciprocating engine has an initial pressure of SO bar and an initial temperature of 1623*C. The initial volume is 50000 mm' and the gas expands through a volume ratio of 20 according to the law pV constant. Calculate w and AU Take R= 270 J/Kg K and C, = 800 J/Kg K. Assume n 1.38
A piston cylinder arrangement initially contains 7.0 kg of super-heated steam at 100 kPa and 250 C, now heat is removed until 0.62% condenses. 1) What is the amount of heat removed in (kJ)? O 11262 O10946 O11894 O12210 O'None of the above 2) What is the final volume (m min 10142735 K01/4.5108 KHA9847 O5.222 None cf the ebeve
2. Saturated liquid water at 250 kPa is contained in a piston-cylinder device as shown in the figure below. The total initial volume is 0.012m'. As the water is heated, the pressure inside the cylinder remains constant until the piston hits the stops. When the piston hits the stops the specific volume is 0.47443 m/kg. Heat transfer to the water continues until the pressure doubles. NOTE: If needed use the closest value in tables 3 to avoid interpolation. Use 5 decimal digits when using specific volume. a.) Plot the process in a P-v-diagram with respect to saturations lines. b.) Fill de table below c.) Determine the total mass P(kPa) T(°C) v(m'/kg) h(kJ/kg) Phase 2 3.
An oxygen tank has a volume of 4 cubic meters and is at 20 degrees C and 700 kPa. The valve is opened, and some oxygen is released until the pressure in the Tank drops to 500 kPa. If the temperature in the tank does not change during the process: The mass of oxygen that has been released from the tank is.... ..kg. Assume: Oxygen is an ideal gas and its ideal gas constant is 260 N.m/kg.K Where K is the degrees, Kelvin.
2) Two glass bulbs, one on the left with a volume of 2 liters and the other on the right with avolume of 6 liters, are connected to one another by a thin tube that is initially closed by astopcock. The bulb on the left has 0.1 moles of ideal gas, and the bulb on the right isevacuated. The system is in thermal equilibrium with the surroundings at 300K. When thestopcock is opened, the gas flows out to fill both bulbs. Calculate A for this process. If wewere to insert a propeller to extract work as the gas flows from left to right, what is themaximum amount of work that we could possibly extract?
5. A 0.5 cubic meter tank contains gas at a pressure of 6800 kPa gage, a temperature of 75 deg. Celsius and mass of 25 kg. A part of this gas was discharged and the temperature and pressure changed to 50 deg. Celsius and 4250 kPa respectively. Heat was applied and the temperature was back to 75 deg. Celsius. Find: (a) the final mass in the tank in kg 15.633 16.588 18.283 (b) the discharged mass in kg. 8.412 9.36 6.716 (c) the final pressure of the gas in kPa gage 4135.88 4215.56 O 4578.94
By choosing one of the 3 options given below, the water in the closed container in Find the temperature and show the process on T-v, P-v diagrams. 1. 2. 3. Seçenek Seçenek Seçenek V n (devir/dakika) su 700 800 900 mil Tork (N.m) 150 200 250 Pi, T1, V1 t (dakika) 20 15 10 V (volt) 140 130 120 I (amper) 10 15 20 P. (kPa) 800 600 400 TI 150 130 120 VI (litre) 10 15 20 Q: (kJ) 400 500 600