2. A student doing this experiment was puzzled by the fact that while each of the individual solutions being used is dangerous, the mixture made by combining the two solutions is much less dangerous. Actually, the resulting mixture could be safely disposed of by pouring it into the drain and diluting with a large amount of running water. Describe the hazards of each of the solutions. Explain why the mixture is not as hazardous as the original solutions from a waste-disposal point of view.

2. A student doing this experiment was puzzled by the fact that while each of the individual solutions being used is dangerous, the mixture made by combining the two solutions is much less dangerous. Actually, the resulting mixture could be safely disposed of by pouring it into the drain and diluting with a large amount of running water. Describe the hazards of each of the solutions. Explain why the mixture is not as hazardous as the original solutions from a waste-disposal point of view.

Chemistry: The Molecular Science

5th Edition

ISBN:9781285199047

Author:John W. Moore, Conrad L. Stanitski

Publisher:John W. Moore, Conrad L. Stanitski

Chapter4: Energy And Chemical Reactions

Section: Chapter Questions

Problem 123QRT

See similar textbooks

Similar questions

4.3 Explain the difference between complete and incomplete combustion.
Is there a difference between a homogeneous mixture of hydrogen and oxygen in a 2:1 ratio and a sample of water vapor? Explain.
Golf balls are made up of rubber.What the properties of rubber to work properly.write an essay on its properties of 300 words and also give the source and reference from where you have collected the data.
Explain the laboratory rules for waste disposal.
-Explain the distillation test. -Explain the Bomb Calorimeter test. -Explain the viscosity test.
Peisalla lamacron Nar. ,202 Date Name Section galauvinstenos Pre-Laboratory Assignment 1. Read an authoritative source for a discussion of preparing and interpreting a graph, especially the extrapolation of a curve. 2. A student determined the calorimeter constant of the calorimeter, using the procedure described in this module. The student added 50.00 mL of cold water to 50.00 mL of heated, distilled water in a Styrofoam cup. The initial temperature of the cold water was 21.00 °C and of the hot water, 29.15 °C. The maximum temperature of the mixture was found to be 24.81 °C. Assume the density of water is 1.00 g mL¯1 and the specific heat is 4.184 J g¯K gniwollot bns of toh bine botollon ot ssb om (1) Determine the AT for the hot water and the cold water. mit At cold water = 24.8I- 21,00 = 3.81°COn आनी AT hot = 24.81- 29.15 = - 4.34°C 60.ES 2.0 0LES 8. 0.1 0.0 If 0.8 28.5S Calculate N 0.4 08.TT gabxim 02 4.34°C hot water 81 answer cold water 381°C dogesn boximnu sdt to anuiSTeqmad mom…
5. Two aqueous NaCl solutions of equal volume and concentration were kept in flasks and held at different temperatures. The two solutions were combined in a larger flask. Based on this information, which of the following predictions is correct?a. The average kinetic energy of the particles in the cooler solution will decrease as they collide with the particles from the warmer solution.b. The average kinetic energy of the particles in the cooler solution will increase as they collide with the particles from the warmer solution.c. The particles from the cooler solution and the particles from the warmer solution will reach thermal equilibrium through collisions, at which time theaverage kinetic energy of the particles in the mixture will be lower than theaverage kinetic energy that the particles had in the cooler solution.d. Theparticlesfromthecoolersolutionandtheparticlesfromthewarmersolution will reach thermal equilibrium through collisions, at which time the average kinetic energy of…
1.If your temperature changes from 20oC to 25oC—how much change is there in the mass of a 10.00 mL sample? 2.Volumetric glassware is produced in certain “classes.” What does this mean? Give at least two examples.
When calcium oxalate monohydrate is heated, anhydrous calcium oxalate and water are formed. Further decomposition of the calcium oxalate produces calcium carbonate and carbon monoxide. If the heating temperature is increased to well above 600 degrees celsius, calcium carbonate will decompose to calcium oxide and carbon dioxide. Write three reactions to depict the decomposition processess described here.
Use the information below to answer questions 1- 3. PCI,(g) 2 PCI;(g) + Cl2(8) PCI,(g) decomposes into PCI,(g) and Cl,(8) according to the equation above. A pure sample of PCI,(g) is placed in a rigid, evacuated 1.00 L container. The initial pressure of the PCI5(g) is 1.00 atm. The temperature is held constant until the PCI,(g) reaches equilibrium with its decomposition products. The figures below show the initial and equilibrium conditions of the system. PCI5 Potal = 1.00 atm PCI5, PCI3, and CI, Prstal = 1.40 atm Figure 1: Initial Figure 2: Equilibrium As the reaction progresses toward equilibrium, the rate of the forward reaction (A) increases until it becomes the same as the reverse reaction rate at equilibrium (B) stays constant before and after equilibrium is reached (C) decreases to become a constant nonzero rate at equilibrium (D) decreases to become zero at equilibrium If the decomposition reaction were to go to completion, the total pressure in the container would be (A) 1.4…
Decribe what the effect of overheating or unevenly heating copper sulfate hydrate in a chemistry experiment. How would this affect the interpretation of results?
Posttest Direction. Read the questions carefully. Write the letter of the correct answer. 1. Water exists in three states of matter and continuously moving through a cycle on Earth. At which stage in the water cycle does water transform from a gas to a liquid? a.evaporation c. precipitation b. condensation d. Sublimation 2. Carbon dioxide (CO2) forms when coal burns in the presence of oxygen. Which of the following is the BEST evidence that a chemical reaction occurs when the coal burns? a. Production of mechanical energy c. A new substance is produced b. Production of electricity d. Formation of precipitate 3.Which of these does NOT happen during a chemical change? a. New substances are formed with different chemical properties. b. Attractive force between atoms of molecule formed or break. c. The chemical properties of the substances before and after the reaction are the same d. Energy is always released or absorbed. 4. A granular substance is added to a liquid. Which of the…