2 120 m 100 m 28 m Datum

Q: 3.1) Sketch the Hydraulic Grade Line (HGL) and the Energy Grade Line (EGL) considering all losses…

A: Given Datad1=0.12mL1=12md2=0.32mL2=13mf=0.017H1=10mQ=0.02m3/sk1A=0.7vw=10-6m2/sρ=1000kg/m3

Q: 15 cm 2 80 cm Water 1 h = ? Flow 30 сm Mercury

A:

Q: Question 1. The homogeneous gate shown in Figure consists of one quarter of a circular cylinder and…

A:

Q: Calculate the discharge through the pipe line shown in figure. Also find the pressure at point A and…

A: The density of water is 1000 kg/m3. The atmospheric pressure is 101325 Pa.

Q: * Q5// In the fig. shown find discharge (Q). note that :Pwater = 1 kg/m3; Pmerciry = 13.6 kg/m3…

A: density of water is 1000 kg/m3 and not 1 kg/m3 similarly ,density of mercury is 13600 kg/m3 and not…

Q: Determine the water depth, ha if the flowrate, Q is constant (steady-state). (1) 0.03 – m diameter…

A:

Q: The three-tanks system in figure are interconnected as shown. Compute the flowrate in each pipe,…

A: To find discharge in all pipes

Q: The figure shows a siphon which is used to draw water from a large open tank. If the absolute…

A:

Q: From the situation below, the water from a nozzle is being discharge down to the tank The tank has a…

A: According to the details provided in the question, we need to calculate diameter d

Q: Calculate the required pressure of the hydraulic pump to raise the fluid to the vertical high of 5 m…

A:

Q: Water is at 20°C is pumped from a lower reservoir to a higher reservoir by a pump at a rate of 100…

A:

Q: Consider the following system Find (i) Span (ii) Equivalent head of water at maximum level. (iii)…

A: (i) Calculate the span of water level.

Q: Q1) Using a system similar to that shown in figure, if air pressure p = 50 kPa., and the depth h₁ =…

A:

Q: Question 2. la0 mm diameter siphon draws water from the reservoir. Considering that the elevation…

A: Given diameter =4mm=0.004 m h(1)=1m h(2)=1 m

Q: Q2/ Water is flowing through the system. If P1 = 0.18 MPa gage, and mass flowrate is 15 kg/s.…

A: The velocity of flow at section 2 can be determined as, The velocity at section 1 can be determined…

Q: T= 20°C Consider the water reservoir with a siphon as shown in the figure. If d = 0.06 m, D = 0.25…

A:

Q: A vertical Venturi meter, 150 mm in diameter is connected to a 300-mm diameterpipe. The vertical…

A:

Q: 1. For the siphon given in the figure calculate a) The volume flow rate of water through the nozzle…

A:

Q: With the haze-pipe system in the figure, the ideal fluid (water) taken from the infinitely large…

A:

Q: Water flows steadily through the elbow, placed horizontally on the surface shown in figure.…

A:

Q: QUESTION 4 A pipeline connected to a reservoir discharges water 30 m below the free surface in the…

A:

Q: 4. A pipeline carrying oil of specific gravity 0.87, changes in diameter from 200 mm diameter at a…

A:

Q: Problem 1: Water is flowing in steady statę through the elbow shown in the figure. Assume the…

A: Given data as per question A1 = 2 m2 A2 = 1 m2 V1 = 10 m/s

Q: 4. The water tank is below a constant level at depth h rectangular hole a x b. We close the opening…

A: Depth of water, h=0.85 mSize of rectangular hole, a=0.4 m and b=0.7 m

Q: In the spillway fl ow of Fig. , the fl ow is assumeduniform and hydrostatic at sections 1 and 2. If…

A: For mass conservation                                     v2=v1h1h2=5v10.7=7.14 v1 Now applying the…

Q: 3.58 Water flows steadily through the large tanks shown. Determine the water depth, hạ- Negiect…

A: Let Q = Discharge  hB =Water depth in tank B =2m g =acceleration due to gravity =10m/s2 DA =Diameter…

Q: Question (2) As shown in the Figure below, If the discharge was 0.0035 m/s. Calculate the water…

A: Find the level in the water tank. Given data :-  Discharge - 0.0035 m^3/sec.

Q: In the pump test shown, the rate of flow is 0.16 m3/s of oil (S = 0.88) Calculate the horsepower…

A: For solution refer below images.

Q: Fluid flows through the venture tube shown below. Pressure at section 2 is equal to 101 kPa. If…

A: Given, that the pressure at the section 1 is 251 kPa and the pressure at the section 2 is 101 kPa.…

Q: 2. Shown is water flowing through a Venturi Meter. If the specific gravity of the gage fluid at the…

A:

Q: P = Patm 1 V = 7.3 m/ Flow h = 0.96 ft water 2 3 Density of water = 1000 kg/m³ Determine the…

A: P1=Patm=101.325 kPa v1=7.3 msech=.96 ft since 1 ft=.3048 mSo h=.96×.3048h=.2926 mρ=1000 kgm3

Q: A sample of soil is maintained in an apparatus as shown in Figure 1. Determine the elevation head,…

A:

Q: Problem 3: Water issues from a hole in a large tank, as shown in the attached figure.Assuming…

A: Given data,Height h1= 3 mHeight h2= 5 m

Q: Q2. The turbine shown in figure 2 develops 3000 kW when the water flowrate is 24 m /s. The head loss…

A:

Q: The pressure inside a horizontal domestic water pipe is 60 psi above atmospheric. If viscous effects…

A: Write the pressure inside a horizontal domestic pipe. P=60 psi Write the unit weight of the water.…

Q: Q2 / the diameter of a horizontal pipe which is 300 mm is suddenly enlarged to 600 mm .the rate of…

A:

Q: Q1. What is the level H if the flow rate through the system shown is 180 L/s through the 30-cm…

A:

Q: Calculate the dynamic force of the water on the fork, referring to a horizontal plane. waste load…

A:

Q: 17. The pressure head in a gas tank is 2.75 atmosphere. Compute the pressure head in meters of…

A: Solution ∵ P= δ g H( For water →δ =1000 kg/m3)( g = 9.81 m/s2)

Q: The pump shown in the figure below delivers a head of 200 ft to the water. Determine the power that…

A: The difference in the elevation of the two ponds,  Z2-Z1=150ft Pump deliver to the head of the…

Q: Water flows steadily through the elbow, placed horizontally on the surface shown in figure.…

A:

Q: Q3/ Water flows in Venture meter as shown in Fig. No. (5). Coefficient of velocity is (0.96) and…

A: A venturimeter, a type of flowmeter, is developed based on Bernoulli's Equation.  this instrument is…

Q: For the system of pipes shown, the flow of water in pipe (3) is 25 L/s. Find: The flow in pipes (1)…

A:

Q: A pipeline carrying oil of specific gravity 0.87, changes in diameter from 200 mm diameter at a…

A: Given, SG= 0.87 dA = 0.2 m dB = 0.5 m zA = 0 m zB = 4 m pA = 9.81 N/cm2 = 98100 N/m2 pB = 5.886…

Q: Water flows from a tank through 160 ft of 4 inches diameter pipe and the discharges into the air as…

A:

Q: D. The water is flowing through a tapering pipe having cross section areas 0.2 m2 and 0.1 m2 at…

A:

Q: 6. A fabricated assembly made from three different sizes of standard steel tubing is shown below.…

A: The equation based on the principle of conservation of mass is called the continuity equation. thus…

Q: Figure Q1 shows the sewage siphon which regulates the level of water in the large holding tank A.…

A:

Q: Q5:- Calculate the discharge of the system in fig.(4),neglecting all losses except through the…

A: There are two types of losses occur in pipe flow:- 1) major loss -these losses are due to viscous…

Q: A venturi meter with diameter at inlet D1, and throat diameter D2, is used for measuring the flow of…

A: