16. How much heat (in Joules) is required to raise the temperature of 50.0 g of brass from 20.0°C to 65.0°C? The specific heat of brass is 0.385 J/gᵒC. a. 385 J b. 1250 J c. 5840 J d. 436 J e. 866 J 17. What volume of a 0.1000 M hydroiodic acid solution is needed to neutralize 25.0 mL of a 0.350 M barium hydroxide solution? a. 175 mL b. 140 mL c. 140. mL C. d. 75 mL e. None of the above 18. What volume would 9.50 g of nitrogen gas occupy at 22.0°℃ and a pressure of 1.34 atm? a. 0.306 L b. 6.13 L c. 53.2 L d. 26.6 L e. 12.2 L

16. How much heat (in Joules) is required to raise the temperature of 50.0 g of brass from 20.0°C to 65.0°C? The specific heat of brass is 0.385 J/gᵒC. a. 385 J b. 1250 J c. 5840 J d. 436 J e. 866 J 17. What volume of a 0.1000 M hydroiodic acid solution is needed to neutralize 25.0 mL of a 0.350 M barium hydroxide solution? a. 175 mL b. 140 mL c. 140. mL C. d. 75 mL e. None of the above 18. What volume would 9.50 g of nitrogen gas occupy at 22.0°℃ and a pressure of 1.34 atm? a. 0.306 L b. 6.13 L c. 53.2 L d. 26.6 L e. 12.2 L

Introductory Chemistry: A Foundation

9th Edition

ISBN:9781337399425

Author:Steven S. Zumdahl, Donald J. DeCoste

Publisher:Steven S. Zumdahl, Donald J. DeCoste

Chapter15: Solutions

Section: Chapter Questions

Problem 20CR

See similar textbooks

Similar questions

Silver ions can be found in some of the city water piped into homes. The average concentration of silver ions in city water is 0.028 ppm. (a) How many milligrams of silver ions would you ingest daily if you drank eight glasses (eight oz/glass) of city water daily? (b) How many liters of city water are required to recover 1.00 g of silver chemically?
60. Suppose 325 in L of 0.150 M NaOH is needed for your experiment. How would you prepare this if all that is available is a 1.01 M NaOH solution?
The equation for a reaction by which a solution of sodium carbonate may be standardized is 2HC7H5O2+Na2CO32NaC7H5O2+H2O+CO2. A student determines that 5.038g of HC7H5O2 uses 51.89mL of sodium carbonate solution in the titration. Find the molarity of the sodium carbonate.
Solutions of hydrogen in palladium may be formed by exposing Pd metal to H2 gas. The concentration of hydrogen in the palladium depends on the pressure of H2 gas applied, but in a more complex fashion than can be described by Henry's law. Under certain conditions, 0.94 g of hydrogen gas is dissolved in 215 g of palladium metal (solution density = 10.8 g cm3). (a) Determine the molarity of this solution. (b) Determine the molality of this solution. (c) Determine the percent by mass of hydrogen atoms in this solution.