15. A residential AC power line voltage is 230 V. What are the average and peak-to-peak voltages?a. 207.0727 and 414.1454b. 207.0727 and 650.5385c. 230 and 260d. 325.2691 and 207.0727 15. A residential AC power linevoltage is 23O V. What are theaverage and peak-to-peakvoltages?O 207.0727 and 414.1454O 207.0727 and 650.5385230 and 260325.2691 and 207.0727O O O

Answered: Image /qna-images/answer/62d6511e-6887-4a65-a6a3-03ef8222fef6.jpg

Engineering

Electrical Engineering

15

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter2: Fundamentals

Section: Chapter Questions

Problem 2.7MCQ

See similar textbooks

Related questions

Q: Refer to circuit below: Vcc= 3.3 V Re = 1 kQ R333 K2 Cc R2 50ΚΩ Rc = 2 kQ Given VA = 00, B = 100, VT...

A: By dc analysis we will find out the emitter resistance then we will find out Gain .

Q: R1 An inductor with inductance L= 0.2 H and negligible resistance is connected to a battery, a switc...

Q: The single-phase half wave rectifier has R-L load with R= 5N nd L= 6.5mH. The input voltage V,=220V ...

A: Given R-L load with R=5ohms and L=6.5mH. The input voltage Vs = 220 V at 50 Hz

Q: If Zo = 50 2, Vo* = 10 V, and the length of the line is 1.252, estimate the reflection coefficient a...

A: given Z0= 50 ohm V+0= 10v Length of line = 1.25 Reflection coefficient at the load Cv = v/v = ZL-ZS/...

Q: Grien: - 100, si , vz ß = Reguire ment : Ca) Io (6) Ad, Ac *

A: Given the circuit, as shown below: Given : β=100 , VZ=10 V, β=100 , VZ=10 V We need to find : a) I...

Q: An a-c source delivor current to two lo ads À end B that cro con- nected in parallel. If the load A ...

A: In this question we need to find a resultant current and angle .

Q: Given a parallel RLC circuit comprised of the following element: 99.3-ohm resistor, ideal inductor w...

A: In this question we need calculate true power .

Q: 3. Determine V, and I,.

Q: 1. Determine the total resistance and the current along 3 ohms in downward direction. SOV +

Q: 3. Consider the integrating operational amplifier circuit. The input resistor is 90 ko, the feedback...

Q: A balanced three-phase source with grounded neutral has line-to-line voltages of 208 volts with ab-b...

A: In this question, A balanced three-phase source with grounded neutral line-to-line voltages =208 vo...

Q: 3Ω RL 10 V 82 (1)1.5A

Q: At a 115 kV substation, the PT ratio is 1000 and the CT ratio is 1200/5. The potential going into th...

Q: circuit. 54. There is very little resistance and a large amount of current flows in a(n) a. long - b...

Q: Ke -53. At a. high frequencies, the skin effect can have a great effect on the operation of the circ...

A: At _________ frequencies the skin effect can have a great effect on the Operation of the circuit ? A...

Q: 9.1-10 11- 12 D14.-15 16 Name: Section: Solve k, k and s in any two(2)methods with complete solution...

Q: 7. Calculate the total capacitance in the series circuit shown in Figure 12.25a 100 nF C2 C3 C2 330 ...

Q: The component sequence line currents of a three-phase 4-wire system are la0 = 25<-180, la1 = 26<50 a...

Q: A balanced three-phase source with grounded neutral has line-to-neutral voltages of 120 volts with a...

A: The circuit can be drawn as

Q: Parallel Circuit 2 Calculated Total Resistance: 894.899 N Measured Total Resistance: 894.88 2 Calcul...

A: The power (P) through can be resistor (R) can be calculated as P=I2R Watts.

Q: 10A 6 4 ww ww

Q: Sketch the root locus of the system whose open loop transfer function is G(s) =k/s(s+4)(s+6). Find t...

Q: Compute for the value of İLOAD and VLOAD for the circuit given below after getting the set of equati...

Q: Take the periodic input with period 4, and values in the range of indices 0, to 3 given as х 3D {1, ...

A: "According to the Company's policy we will provide solution of the first part the question as to the...

Q: A three-phase, 4-pole alternator runs at 1,800 RPM. Each phase covers two slots under each pole. The...

A: Per phase Emf induced of alternator = 4.44 frequency ×flux per pole ×turns per phase × dristribution...

Q: A 4Ω 2 A (1 kv

Q: Short Problem: A parallel R-L-C circuit consist of R= 5,3382, L= 85.7mH and C=10.7 pF. The applied v...

Q: A voltage of v = 120 sin(4000t – 40°) volts is applied II across a pure inductance of 2 mH. Find (a)...

Q: 17.17 If the Fourier transform of f(t) is 10 F(w) = (2 + jw)(5 + jw) determine the transforms of the...

Q: A. Determine the cut-off frequency for a low pass RC with R = 10-KO and C = 3.3-nF. B. Determine the...

Q: A balanced three-phase source with grounded neutral has line-to-neutral voltages of 132.7906 volts w...

A: The circuit diagram can be drawn as

Q: compute for the voltage across the load AB, when it is connected to the equivalent thevenin circuit...

Q: 3. Determine the charge that a 22 µF capacitor stores when the difference of potential across its pl...

A: In this question we will find charge across capacitor.....

Q: 2. A 110 V shunt motor has a field resistance of 55 ohms and armature resistance of 0.1 ohm. The mot...

Q: A resistance of 100n, an inductance of 75.0 mH, and a capacitor of 4.0 µF are onnected in series wit...

A: The solution can be achieved as follows.

Q: Compute the percent efficiency of the electrical system of the figure below. Note: Resistors absorbs...

A: Given circuit-

Q: Calculate the r.m.s. value of the sinusoidal current of the maximum value of 22.29.

Q: 40. A variable resistor with three terminals is called a a. potentiometer b. rheostat c. multiturn r...

A: We need to select correct option for variable resistor .

Q: current Source : 1A, All Resistors :1kohm %3D un A ww

Q: Q1: Consider the following waveform f (t) shown in Figure 1. Find the Fourier Transform (FT) using: ...

Q: Given: 10 ohm each

A: To solve this question we redraw the circuit as shown below.

Q: 10. Determine the voltage after 50µs after the switch is closed if the circuit is connected to a 30V...

A: Given Vs=30V t=50us Capacitor is initially uncharged

Q: 15 Hp 240 V 1100 rpm 4 pole dc shunt motor has a total of 758 conductors arranged in 2 parallel path...

Q: (c) A solid specimen of dielectric has a dielectric constant of 4.2, and tan o = A? at a frequency o...

A: Assuming A=0.05 f=50Hz E=60KV/cm

Q: A generator is rated 100 MW, 13.8 kV and 90% power. A wye-connected alternator was tested for its ef...

Q: Calculate the systems efficiency of a refrigerator given the following; Mining & Transport Efficienc...

A: The solution is given below. Given data are - Mining and transport efficiency n1=0.97 Coal plant co...

Q: 1. Given: Reg'd: RT RA A B A FRC

Q: Proposed an industrial application with a transfer function. Using the proposed transfer function: 1...

A: Assuming

Q: Given a series circuit comprised of the following element: 92.61-ohm resistor, practical inductor wi...

Q: 20. An inductor has a maximum current of 4 amperes, When power is interrupted, how much current will...

A: We need to find out the current for inductor at given time instant .

Concept explainers

Maximum power transfer theorem

A resistive load will consume maximum power from a network when the load resistance is equal to the resistance of the network as viewed from the open-circuit terminals, with all energy sources removed leaving only the internal resistances. Physicist Moritz von Jacobi introduced the maximum power transfer theorem in 1940. Therefore, this theorem is also known as Jacobi's law.

Question

15. A residential AC power line voltage is 230 V. What are the average and peak-to-peak voltages? a. 207.0727 and 414.1454 b. 207.0727 and 650.5385 c. 230 and 260 d. 325.2691 and 207.0727

15. A residential AC power line
voltage is 23O V. What are the
average and peak-to-peak
voltages?
O 207.0727 and 414.1454
O 207.0727 and 650.5385
230 and 260
325.2691 and 207.0727
O O O

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Section [Section Upload answer sheets Find the following parameters of an ac voltage given by the equation v-100sin370t.Find RMS value,form factor, peak factor, average value and frequency. E Submission
What is the main direct cause of reactive power in AC system?A. Resistance of transmission linesB. Inductance and capacitance in the loadsC. Ideal transformer connected in the systemD. Power produced by generator
The voltage regulation of an alternator having 0.75 leading p.f. load, no-load induced e.m.f. of 2400V and rated terminal voltage of 3000V is............... percent. *
8 = 0 Q1: What does happen if we change two currents? Q2: What does happen if we have a three-phase four poles machine? a Q3: What does happen if we have a two-phase two poles machine? Q4: What does happen if we apply a capacitance in phase b and then use same voltage for both phase. Dr. Ali K....p. . --
A 5-ohm resistor is connected in series with a 25 micro-farad capacitor. A source voltage of158 volts, 50 Hz supplies the combination. Determine the following:a. Circulating currentb. Voltage across the resistorc. Voltage across the capacitord. Real power supplied by the source
In a Three-phase alternator, a given field current produces an armature current of 250 A on short-circuit and a generated e.m.f. of 1500 V on open-circuit. Calculate the terminal p.d. when a load of 250 A at 6.6 kV and 0.8 p.f. lagging is switched off. Calculate also the regulation of the alternator at the given load. Subject: Electrical engineering
A 200 – ohm resistor, 130 millihenry inductor, and a 66 microfarad are placed in parallel across a 120 – V, 60 – Hz AC line. Calculate the following: a.) RESISTOR CURRENT b.) INDUCTOR CURRENT c.) CAPACITOR CURRENT d.) TOTAL CURRENT e.) PHASE ANGLE f.) TOTAL IMPEDANCE DRAW THE PHASOR DIAGRAM IF POSSIBLE AND ROUND OFF TO FOUR DECIMAL PLACES.
6.5% ans ex A so kvA. 2o00/20 V, So He single-phase transformar has impedance drof of8% and resistance drop of 4%. Caleulate. The Requlation of the Thams former at full- Load o8 P.s Legging. also find The Power factor at which Voltage requlation will Be Zero. Sols 0.5 leading. s alculate The % Noltege Requlation af atransformar in w hich the Percantage resistance drof is 1% and Percentage dre is 6% when The Power fador is 0.8 lagging ) > unity aMS 38 % ans 1 % (シ→ 0.8 leading . amS - 2.2%
A three-phase 3300V. 50 Hz star-connected alternator has an effective resistance of 0.5 ohm/phase. A field current to of 30A produces full-load current of 180A on short- circit and a line to line emf of 1000V on open circit Determine(i) the power angle of the alternator when it delivers full-load at 0.8p.f(lag) (ii)the SCR of the alternator D
Driving-point admittance The actual impedance of a load is 30 OHM. The per-unit impedance of the load is 0.5 pu when Base Voltage is 600 V and Base Power is of O 6000 VA O 8000 VA O2000 VA 4000 VA Jump to ncements MacBook Air DD DII F10 F9 F8 000 F7 F6
A 500 MVA synchronous machine has H, = 5.6 MJ/MVA and a 1200 MVA machine has H₂ = 2.0 MJ/MVA. The two machines operate in parallel in a power station. What is the equivalent. H constant for the two, relative to a 100 MVA base?
Consider two interconnected voltage sources connected by a line of impedance Z=jX, as shown in Figure 2.27. (a) Obtain expressions for P12 and Q12. (b) Determine the maximum power transfer and the condition for it to