11. If 23.45 mL of a 0.2345 M sodium phosphate solution is added to 56.00 mL of a 0.5643 M potassium sulfide solution, determine: a. the balanced conventional, total, and net ionic equations conventional: total: net: b. the molarity of all ions that remain in the solution at the end of the reaction.

11. If 23.45 mL of a 0.2345 M sodium phosphate solution is added to 56.00 mL of a 0.5643 M potassium sulfide solution, determine: a. the balanced conventional, total, and net ionic equations conventional: total: net: b. the molarity of all ions that remain in the solution at the end of the reaction.

Fundamentals Of Analytical Chemistry

9th Edition

ISBN:9781285640686

Author:Skoog

Publisher:Skoog

Chapter13: Titrations In Analytical Chemistry

Section: Chapter Questions

Problem 13.16QAP

See similar textbooks

Similar questions

Potassium hydrogen phthalate is a solid, monoprotic acid frequently used in the laboratory as a primary standard. It has the formula KHC8H4O4. This is often written in the short-hand notation as KHP. If 25.0mL of a potassium hydroxide solution are needed to neutralize 2.26g of KHP, what is the molarity of the potassium hydroxide solution? Potassium hydrogen phthalate sometimes called potassium biphthalate, as shown on this bottle is an acid that is convenient to store and use because it is a solid.
Calculate the enthalpy of solution ( H for the dissolution) per mole of CaCl2 (refer to exercise 25).
The equation for a reaction by which a solution of sodium carbonate may be standardized is 2HC7H5O2+Na2CO32NaC7H5O2+H2O+CO2. A student determines that 5.038g of HC7H5O2 uses 51.89mL of sodium carbonate solution in the titration. Find the molarity of the sodium carbonate.
A sample of solid calcium hydroxide, Ca(OH)2, is allowed to stand in water until a saturated solution is formed. A titration of 75.00 mL of this solution with 5.00102M HCl requires 36.6 mL of the acid to reach the end point. Ca(OH)2(aq)+2HCl(aq)CaCl2(aq)+2H2O(l) What is the molarity?
The hardness of water (hardness count) is usually expressed in parts per million (by mass) of CaCO3, which is equivalent to milligrams of CaCO3 per liter of water. What is the molar concentration of Ca2+ ions in a water sample with a hardness count of 175 mg CaCO3/L?
A researcher dissolved 1.382g of impure copper in nitric acid to produce a solution of Cu(NO3)2. The solution went through a series of steps in which Cu(NO3)2 was changed to Cu(OH)2, then to CuO, and then to a solution of CuCl2. This was treated with an excess of a soluble phosphate, precipitating all the copper in the original sample as pure Cu3(PO4)2. The precipitate was dried and weighed. Is mass was 2.637g. Find the percentage by mass of copper in the original sample.
What happens if you add a very small amount of solid salt (NaCl) to each beaker described below? Include a statement comparing the amount of solid eventually found in the beaker with the amount you added: a a beaker containing saturated NaCl solution, b a beaker with unsaturated NaCl solution, c a beaker containing supersaturated NaCl solution. A saturated sodium chloride solution.
Twenty-five milliliters of a solution (d=1.107g/mL)containing 15.25% by mass of sulfuric acid is added to 50.0 mL of 2.45 M barium chloride. (a) What is the expected precipitate? (b) How many grams of precipitate are obtained? (c) What is the chloride concentration after precipitation is complete?