11 Given the following well design: a) Calculate total hole volume with the entire drill string in the hole. bbls b) Calculate total hole volume with the entire drill string out of the hole. bbls CSG Specification: (13 3/8" CSG (12.5" ID) and 7" Liner (6" ID)) Drill Pipe Specification: (4.5" DP (3.5" ID))

11 Given the following well design: a) Calculate total hole volume with the entire drill string in the hole. bbls b) Calculate total hole volume with the entire drill string out of the hole. bbls CSG Specification: (13 3/8" CSG (12.5" ID) and 7" Liner (6" ID)) Drill Pipe Specification: (4.5" DP (3.5" ID))

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

Questions Q) A drilling operation is to be performed with a 12.7 mm diameter twist drill in a steel workpart. The hole is a blind hole at a depth of 60 mm and the point angle is 118°. The cutting speed is 25 m/min and the feed is 0.30 mm/rev. Determine (a) the cutting time to complete the drilling operation, and (b) metal removal rate during the operation, after the drill bit reaches full diameter?
A technician needs to drill a hole through a wall for a 1⁄2-inch fuel line. Thereshould be a 1⁄32-inch clearance on each side of the tube. What should be thediameter of the drill?
Hydraulic Toolbox 3
29f50 What will the weight indicator reading be when you run a closed ended string of 4 1/2 inch OD, 15.60 lbft drill pipe dry to a depth of 5,100 feet? (Disnegard block weight) Mud weight in the hole is 9.4 bigal 45,057 lbs down force 45,000 lbs down force 45,050 lbs down force 45.055 lbs down force 45,052 lbs down force
27 What is desinine dsi designing the oPtimum drilling fluid?
Submit your question to our 24/7 subject matter experts with Masters and PhDs and get a solution in as fast as 30 minutes* Provide clear and step by step solution with illustration Design a square base plate to support 12 mm thick pipe column with an inside diameter of 400 mm. The base plate minimum dimension is 500 mm. To design plate thickness, convert the circular perimeter of the pipe into an equivalent square with an area equal to the original circle. The loads are PDL = 700 kN and PLL =320 kN. Assume that the pipe is to rest on a very wide slab. Use A-36 steel and concrete fc’ = 25MPa and ASD.
A split-barrel sampler is driven 24 inches in 6 in. increments. The SPT blow counts recorded were 2-3-4-6. Determine the measure SPT resistance value based on the blow counts. Oa 35 Ob7 Oc 15 Oa 10
Define the Pressuremeter Test (PMT) ?
Upvote for correct solution
1- In drilling a 9 5/8" hole, the used weight is 3000 lb/inch of bit diameter. If 75% of drill collars should be in compression, find the necessary number of joints of drill collar needed. Drill collars used have 6 " OD and 2 ½" ID and 134 kg/Mt. nominal weight. Air is used as a drilling fluid.
Define Vane Shear Test (VST)
6 - show complete solution