Answered: 1.Explain the term “Atmospheric…

Engineering

Civil Engineering

1.Explain the term “Atmospheric pressure”. 2.Explain the basic components of air pollution problem

Engineering Fundamentals: An Introduction to Engineering (MindTap Course List)

5th Edition

ISBN:9781305084766

Author:Saeed Moaveni

Publisher:Saeed Moaveni

Chapter18: Mathematics In Engineering

Section: Chapter Questions

Problem 15P: A jet plane taking off creates a noise with a magnitude of approximately 125 dB. What is the...

See similar textbooks

Related questions

Q: 1. To test your understanding of this distinction, consider the following quantities listed below.…

Q: Explain the term “Atmospheric pressure”. Explain the basic components of air pollution problem

A: The pressure exerted by atmosphere on earth is called as atmospheric pressure. It is measured by…

Q: 2. A gas flows through a square conduit. At one point along the conduit, the conduit sides are 150…

A: Given:- The velocity at point 1 = 25 ft/s The conduit sides at point 1 = 150 mm The gas density at…

Q: The urban heat islands occur when cities replace natural land cover with pavement, buildings and…

A: Clay tiles- It is a type of building material. It is mainly used as a roofing material.

Q: (a.1) Find the probability that the elongation of a steel bar is above 0.1 inch. (a.2) Find the…

Q: (a) Which fluid has the lowest dynamic viscosity? (b) What is the dynamic viscosity of Fluid B in…

A: a: dynamic viscosity=shear stressshear rateslope of line give dynamic viscosityFluid B has least…

Q: Define by which curve the relation between amount of energy absorbed and test temperature is shown,…

A: Introduction : When the striker hits the specimen, it absorbs the energy and eventually yields. At…

Q: In the simplified depiction of an ice rink with an ice resurfacing machine operating (shown in…

A: The given figure is shown below:

Q: The BOD is the measure of what type of pollutant in water? Describe how to do a OBD on water sample.…

A: 1) BOD is the measures of organic waste matter in pollutant water. Amount of oxygen required to…

Q: Subject: ( Environmental Engineering 2 ) Question no 1 How to find BOD, COD and DO in surface water…

A: Introduction : Organic content of sewage : Nuisance potential of sewage is due to organic strength…

Q: a) Explain the term “Atmospheric pressure”. b) Explain the basic components of air pollution problem

A: (a) Atmospheric Pressure- The pressure exerted by atmosphere on earth is called atmospheric…

Q: 5. An object weighs 6.27 KN in water and 8 KN in an alcohol havig Gs = 0.84. Calculate a. Total…

Q: 3. It is interesting to note that due to the liquid water content, the clouds can actually weight a…

A: Given : Volume that cloud holds = 1km3 Liquid water content = 0.7 g/m3

Q: Although liquids and gasses behave in much the same way and share many similar characteristics,…

A: Differences between fluids and solids :- 1. The main difference between solids and fluids is that on…

Q: ) If the specific weight of a liquid is 55 lb/ft3, what is its density? b.) If the specific weight…

Q: Problem #3 (Evaporation): Evaporation from a lake can be obtained from the Penman equation. If the…

A: Given, Available energy at the Lake surface= 200 W/m2 Aerodynamic resistance= 30 s/m Air Specific…

Q: Define Buoyancy? Using your knowledge explain in detail why some materials like wood float while…

Q: Water flows through a pipe at a rate of 1300 cubic meters per month. Express this rate of flow in…

A: Conversion 1 m3 = 2113.376419 pt 1 month= 30.4167 days

Q: After aerating a water sample, you measured the dissolved oxygen (DO) and the DO meter showed a…

A: Given data : RPD = 11% =11/100 =0.11 Determining the saturation concentration oxygen = R1 After…

Q: 3. What makes the density of water from different sources differ? Explain your answer. At what…

A: It is asked that what makes density of water different from other sources.

Q: Which of the following is the largest mass flowrate? A) 13 pound-mass per day B) 5 grams per…

A: (A) Convert the given quantity from lb/day to g/min. 13 lb/day=13 lbday×454 g1 lb×1 day24×60…

Q: Environmental engineers and scientists are concerned about pharmaceuticals (such as antibiotics) in…

A: Given:- flows and antibiotic concentration=1.2m3 and 0.30 mg/L in River A 1.4 m3/s and 0.25 mg/L in…

Q: , calculate the air velocity.

A: A pitot static tube is used to measure air velocity.

Q: 4. Assuming that all groundwater runoff to the oceans comes from fresh groundwater, calculate the…

A: Residence time is the amount of material in the reservoir, divided by either the inflow or the…

Q: 1. Due to government water privatization, a bustling metropolitan city is now home to substantial…

A: Applying the continuity equation: Q1=Q2+Q3 ...(1) As the connection is parallel: Now from the…

Q: Problem 9.104 Figure 1 of 1 6 ft 8 ft Part A Determine the number of gallons of paint needed to…

A: It is given that :

Q: A city will have a supply system that will start operating in 2021. As shown in the figure below,…

Q: Specific gravity is calculated by the formula: S.G. = density of sample/density of water at a given…

A: Given data: t [°C] ρH2O [g/cm3] 4 1 20 0.99820 25 0.99705 It…

Q: illustrated. Based on these data what is the atmospheric pressure at the ocean surface?

Q: Explain the term “Atmospheric pressure”. b) Explain the basic components of air pollution problem…

A: The pressure exerted by atmosphere on the earth is called atmospheric pressure. It is measure by…

Q: 1. Where do you find the adverse effects of turbidity in environmental engineering? Mention two…

A: (1) Turbidity is an important indicator of the amount of suspended sediment in water, which can have…

Q: Which of the following is the largest volumetric flowrate? A)98 gal per hour b)77 centiliters per…

A: To compare the flowrate we will covert them into single unit m3/s. 98 gal/hr =98 × galhr= 98 ×…

Q: Q2: A- Find the population of a city in 20 years from the year 2010 using geometric method, also…

Q: What is the mass (g) of Air? (2 sig figs)

A: The molar mass of dry air is

Q: To what volume of water (in mL) corresponds a sample of 1100 kg/m3 density and 60 mg mass?

A: Given data- Density of water=1100 kg/m3 Mass =60 mg To find out- Volume of water in mL

Q: What are sources, sinks, and environmental factors affecting Dissolved Oxygen in bodies of water?

A: The main source of dissolved oxygen are: atmosphere and from plants in the water. The primary source…

Q: 1. An orifice is an opening with a closed perimeter through which fluid flows. Can you think of any…

Q: a. Hydropower Generation

A: Hi! Thank you for the question As per the honor code, We’ll answer the first question since the…

Q: 1. In water cycle, ______ brings H2O from water in a lake to vapor at atmosphere. A. evaporation;…

A: Answers:-1 In water cycle evapotranspiration brings H2O from, water in a lake to vapor at…

Q: 7. The movement of ships and boats in water is due to a) Water currents b) Jet propulsion c) Mass…

A: The movement of ships and boats in water is due to _______a) Water currentsb) Jet propulsionc) Mass…

Q: Define by which curve the relation between amount of energy absorbed and test temperature is shown,…

A: Solution: The interpretation of each curve is given below: Curve A - Energy absorbed increases…

Q: 2. The main elevator of the CN tower in Toronto rises about 350 m and for most of its run has a…

A: Given:- The rise in the height of the main elevator = 350 m The constant speed of the elevation =…

Q: An issue of a magazine contained the following statement. Dropping less than two inches per mile…

Q: Environmental Engineering If we approximate the atmosphere to be 79% nitrogen (N2) (by volume), and…

A: The ppm concentration of N2 in the air is 0.79x106.

Q: Engineering Hydrology involves the modelling, conceptualization and reproducing processes O True O…

A: Explanation : Engineering hydrology is a very important field that studies the precipitation…

Q: One of the National Academy of Engineering Grand Challenges for Engineering is Manage the Nitrogen…

A: Given data: Depth of soil in farm=9.5 inches. bucket holds 5 gallons number of buckets=200

Q: Q.2 Determine the energy loss if glycerin flows 30m through a 1m dia pipe with an average velocity…

A: Information Given :Diameter of Pipe d=1m.Velocity of Flow V=4m/sDensity of Glycrin…

Q: Q1: Fire hoses used in major structure fires have inside diameters of 6.40 cm. Suppose such a hose…

A: Given data: Flow rate (Q)=40 L/sDiameter of hose (DH)=6.40 cmDiameter of nozzle (DN)=1.2 inGauge…

Concept explainers

Total Energy Consumption

The term energy consumption signifies the consumption of electricity. Energy consumption as electricity is a primary demand for households, factories, industries, complexes, and commercial places. According to a report, the total U.S. energy consumption for 2018 was 101 BTU (British Thermal Units). It accounted for 17% of the total energy consumption of the world. The total energy demand for the U.S. as oil equivalent was estimated to be about 6804 kg of oil equivalent.

Question

1.Explain the term “Atmospheric pressure”.

2.Explain the basic components of air pollution problem

Civil Engineering

Subject= Enviromental Engineering 2

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1ans (1)

VIEW

Step 2 ans(2)

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

a) Explain the term “Atmospheric pressure”. b) Explain the basic components of air pollution problem
Q: Explain the term “Atmospheric pressure”. Explain the basic components of air pollution problem subject: Environmental Engineering-ll program: BE-Civil Engineering
Q#5. Explain the term “Atmospheric pressure”. Explain the basic components of air pollution problem
Hello, for some reason this question keeps getting rejected. If you could please tell me why that would be much appreciated. This is a hydrology question and all the info I have on it is here. Could someone help me with this problem please? Thank you Given the following data for two of the Great Lakes Volume (km3) Q (m3/sec) Lake Superior 12,086 2,181 Lake Erie 480 4,975 If both lakes are contaminated with a pollutant that is 3x above acceptable levels, how long would it take each lake to return to acceptable levels (assuming no additional contaminant input)? *Inflow and Outflow are considered the same.
Compute for the amount of increase in concentration of CO2 in ppm and metric tons. Year Atmospheric CO2 concentration Weight of CO2 (in billion metric tons) 1966 321 ppm 683 2014 400 ppm 852 amount of increase form 1966 to 2014 Choices for answer: A. 79 ppm and 168.27 x 1011 metric tons respectively B. 79 ppm and 1.6827 x 1011 metric tons respectively C. 79 ppm and 16.827 billion metric tons respectively D. 78 ppm and 16.827 billion metric tons respectively E. 80 ppm and 1.6827 x 1011 metric tons respectively
1. Discuss in detail how the amount of organic pollutants in a water sample affects its BOD Level. 2. Explain why an ideal amount of DO (Not very high and not very low) is needed, especially in a drinking water.
Define biochemical oxygen demand (BOD).
Articulate briefly the corporate environmental policies of AB-IBEV
Explain how Nitrogen Cycle relates to environmental and energy engineering and vice versa. Why are they important in environmental and energy engineering. Discuss the significance in terms of pollution/solution/system etc. and cite at least 2 specific examples/applications.
When considering geoengineering, what is the main difference between solar radiation management and carbon dioxide removal? a. solar radiation management is an extremely costly process, while CO2 removal is cost effective b. CO2 removal will be a continuous process while solar radiation management will require a large but singular effort c. CO2 removal is widely regarded as a reliable and realistic method, while solar radiation management is not d. solar radiation management only addresses temperatures while CO2 removal stabilizes all aspects of climate
How does the Land surface and near-surface contaminants can cause pollution of surface bodies of water (lakes, streams, etc.) via overland flow?
Subject: Environmental science Determine the average population growth rate ? Please help me urgent... Remember subject belongs to Environmental Engineering