1. Mention the protocols over which the protocol is encapsulated, to which layer ARP belongs. 2. What is the Target's Hardware Address = a8:9f:ec:bb:78:f0 in the frame and what is the Destination Address = a8:9f:ec:bb:78:f0 in the ARP request packet? Why? 3. Mention the protocol over which the ICMP protocol is encapsulated. - Explain a little in the answers

1. Mention the protocols over which the protocol is encapsulated, to which layer ARP belongs. 2. What is the Target's Hardware Address = a8:9f:ec:bb:78:f0 in the frame and what is the Destination Address = a8:9f:ec:bb:78:f0 in the ARP request packet? Why? 3. Mention the protocol over which the ICMP protocol is encapsulated. - Explain a little in the answers

Systems Architecture

7th Edition

ISBN:9781305080195

Author:Stephen D. Burd

Publisher:Stephen D. Burd

Chapter9: Computer Networks

Section: Chapter Questions

Problem 3VE

See similar textbooks

Similar questions

What is the purpose of ARP (Address Resolution Protocol) in network protocols, and how does it work?
(a) Name and describe two key network layer functions. (b) Name the three components required to create a virtual circuit on the network layer. (c) Briefly describe four (4) services the transport layer provides. (e) List the steps that take place in the TCP three-way handshake. (f) One of the mechanisms found in transport layer protocols (such as our discussed RDT 2.0) is acknowledgements. What happens if an acknowledgement is corrupted? What mechanism addresses this?
Question Two a) Explain the ARP protocol to a friend. In that explanation, mention what layer it operates at and the kind of service it provides to the layer above it. b) Having ARP table entries time out after 10 to 15 minutes is an attempt at a reasonable compromise. Describe the problems that can occur if the timeout value is too small or too large. c) IEEE defines two sublayers at Layer 2, discuss the purpose of each. d) How does a computer attached to a shared LAN decide whether to accept a packet? e) Expand the acronym CSMA/CD, explaining each part and why CSMA/CD uses a random delay? f) Explain why cllision is an issue in a random-access protocol but not in reservation or channel partitioning protocols. Page 2 of 5 Р. Т.О
Suppose you are hired to design a reliable byte-stream protocol that uses a sliding window (like TCP). This protocol will run over a 50-Mbps network, the RTT of the network is 80 ms and the maximum segment lifetime is 60 seconds. How many bits would you include in the Advertised Window and Sequence Num fields of your protocol header?
1. What is the difference between packet fragmentation (i.e., at network layer) and frame frag- mentation (i.e., at link layer) in terms of purpose? 2. Suppose that host A is connected to a router R1, R1 is connected to another router, R2, and R2 is connected to host B. Suppose that a TCP message that contains 800 bytes of data and 20 bytes of TCP header is passed to the IP function at host A for delivery to B. Show the Total length, DF, MF, and Fragment offset fields of the IP header in each packet transmitted over the three links. (Assume that link A-R1 can support a maximum frame size of 1024 bytes including a 14-byte frame header, link R1-R2 can support a maximum frame size of 512 bytes, including an 8-byte frame header, and link R2-B can support a maximum frame size of 432 bytes including a 12-byte frame header.) (*hint: the Fragment offset field is denominated by 8-bytes, not bytes) 3. What is the purpose of the path MTU discovery process (see textbook Figure 5-42) and why does…
(b) The Internet Protocol (IP) can sometimes surprise with its flexibility. Since the overall design is close enough to the principles of the OSI Protocol Model, IP is independent of the Data Link and Physical network layers. And some Norwegians indeed showed successful IP network transmission is possible with carrier pigeons. If we would want to attempt to use carrier pigeons to establish a TCP connection between Canterbury and London, how long would it take to successfully establish the transmission under perfect conditions? (Assume the pigeons are perfectly reliable.) Explain how you come to your result. (1)
Which issues with the router's layer 2 protocol have been found up to this point? In what ways does this new information have an impact? Why does the ICMP request of a PPP-encapsulated router continue to function after the subnet of the serial interface has been changed?
Consider the figure below. The IP and MAC addresses are shown for nodes A, B, C and D, as well as for the router's interfaces. Consider an IP datagram being sent from node D to node A. Give the source and destination Ethernet addresses, as well as the source and destination addresses of the IP datagram encapsulated within the Ethernet frame at points (5), (4), (2), and (1) in the figure above.
X.25 and Frame Relay are two protocols applied in packet switching data communication. Packet switching is a method of grouping data that is transmitted over a digital network into packets.Based on the description given above, ELABORATE your answer from the questions below:a) Briefly EXPLAIN X.25 and Frame Relay protocols, their protocol layers and equipment used. b) DISCUSS at least FIVE (5) differences between the TWO (2) protocols.
Compare GBN, SR, and TCP (no delayed ACK). Assume that the timeout values for all three protocols are sufficiently long such that 5 consecutive data segments and their corresponding ACKs can be received (if not lost in the channel) by the receiving host (Host B) and the sending host (Host A) respectively. Suppose Host A sends 5 data segments to Host B, and the 3rd segment (sent from A) is lost. In the end, all 5 data segments have been correctly received by Host B. How many segments has Host A sent in total and how many ACKs has Host B sent in total? What are their sequence numbers? Answer this question for all three protocols. The previous expert did the wrong question and the answer was incorrect. The 3rd packet is lost not the 2nd packet
Compare GBN, SR, and TCP (no delayed ACK). Assume that the timeout values for all three protocols are sufficiently long such that 5 consecutive data segments and their corresponding ACKs can be received (if not lost in the channel) by the receiving host (Host B) and the sending host (Host A) respectively. Suppose Host A sends 5 data segments to Host B, and the 3rd segment (sent from A) is lost. In the end, all 5 data segments have been correctly received by Host B. How many segments has Host A sent in total and how many ACKs has Host B sent in total? What are their sequence numbers? Answer this question for all three protocols.
The usage of layered protocols is motivated by two factors.