1. A 30-kVA, 440-V, 50-Hz, 3-0, star-connected synchronous generator gave the following test data : Field current (A) 4. 6. 7 8. 10 12 14 Terminal volts 155 287 395 440 475 530 570 592 S.C. current 11 22 34 40 46 57 69 80 Resistance between any two terminals is 0.3 2 Find regulation at full-load 0.8 p.f. lagging by (a) synchronous impedance method and (b) Rothert's ampere-turn method. Take Z, corresponding to S.C. current of 80 A. |(a) 51% (b) 29,9%]

1. A 30-kVA, 440-V, 50-Hz, 3-0, star-connected synchronous generator gave the following test data : Field current (A) 4. 6. 7 8. 10 12 14 Terminal volts 155 287 395 440 475 530 570 592 S.C. current 11 22 34 40 46 57 69 80 Resistance between any two terminals is 0.3 2 Find regulation at full-load 0.8 p.f. lagging by (a) synchronous impedance method and (b) Rothert's ampere-turn method. Take Z, corresponding to S.C. current of 80 A. |(a) 51% (b) 29,9%]

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

A short shunt compound generator supplies 100A at 110V. Armature resistance is 0.050 and the shunt field resistance is 570 and the series field of resistance is 0.042. if the SPL is 852, determine a)Eg b)Copper lossesin b.1)armature b.2)series b.3)shunt c)n
Two 30 AC generators are such that one has twice the linear dimensions of the other. The field windings of each are excited to give identical sinusoidal air gap flux density waveform. Both have the same number of stator slots and identical winding patterns. The conductors per slot in big generator in K times that of the smaller one. The value of K to get equal no-load voltage at same frequency is (a)8 (b) 8 1 (d) 7 (c) 4
The series field winding of a 170 kW, 250 V, 1450 rpm compound generator has a resistance of 0.00306 ohm. What will be the required resistance (in Ohm) of a noninductive diverter that will bypass 27 percent of the total armature current? "
4. In a compound generator connected short-shunt, the induced emf in the armature is 236.4 volts when it delivers 150 amperes to the load. The shunt field current is 2.5 A and the armature resistance is 0.032 2. The series field resistance is 0.015 N and is being shunted with a diverter of resistance Ra. At this condition the electrical efficiency is 95.697%. Determine terminal voltage, diverter resistance Ra and electrical losses. (a) 230V, 0.031N & 1,550.45W (b) 232V, 0.031Q & 2,550.68W (c) 230V, 0.074N & 1,674.52W (d) 230V, 0.031Q & 1,850.42W
Q3/ A/ Compare between de series and shunt generator. Q3/ B/ Briefly explain the commutating process in dc machine.
A shunt DC generator has no load terminal voltage of 140V. Armature resistance is 1ohm and shunt field resistance is 50ohms. Calculate: (i) Induced voltage (ii) A load is now connected to the terminals that starts drawing 2A current and terminal voltage drops to 130V. Calculate the new value of the induced voltage Make sure to draw equivalent circuits for (i) and (ii)
The standard practice of synchronous generator construction now a days is to have Cylindrical field Rotating armature Either of the above Rotating field In an alternator, the armature reaction influences the magnitude of No load loss Wave form of generated voltage. Speed of the machine Flux Terminal voltage per phase
1- The compole is used to 2- A 4-pole wave winding machine has ------ magnetic circuit. 3- A commutator pitch for the duplex wave winding is equal to - 4- A 2-pole triplex lap winding will have parallel paths. 5- A 6-pole lap wound generator has 900 conductors. The e.mf induced per one turn being 3V. the generated voltage of the grnerator is ( 6-A 10kW, 250 V shunt generator has armature and field resistance of 0.2 and 502 respectively. Then the generated voltage is and
A short shunt compound DC generator supplies a load of 10A at a voltage of 10 volts. If the resistances of Armature, shunt field and series field windings are 0.01 ohm, 1 ohm and 0.00 ohm respectively. c) write down the factors to improve the generated voltage. Generated Voltage is 10.2 V
READ THE PROBLEM AND JUST DRAW CIRCUIT DIAGRAM. NO NEED TO SOLVE ANYTHING. A short shunt compound generator delivers 150A at a terminal voltage is 230V.The shunt field current is 2.5A. The resistances of the armature, series field and diverterare 0.032 ohm, 0.015 ohm and 0.03 ohm respectively. Calculate the electrical efficiencyof the generator at this load. Modify the circuit diagram on the picture based on the problem. Answer: 95.7%
In 2-pole machines: the wave winding have greater generated voltage than *.the lap winding armatures True False *.For high rotating speed machines the number of poles must be Little True False The reactance voltage is added in the coil undergoing commutation to * reduce the spark True False
SYNCHRONOUS GENERATOR A 13.8 kV, 50-MVA, 0.9 p.f., 60 Hz, four pole, Y-connected synchronous generator has a synchronous reactance of 2.5 ohms, and an armature resistance of 0.2 ohm. At 60 Hz, its friction and windage losses are 1 MW, and its core losses are 1.5 MW. The field circuit has a dc voltage of 120 V, and the maximum field current is 5A. The current of the field circuit is adjustable over the range from 0 to 10 A. The OCC of this generator is shown in the figure.