. What is the energy stored in the inductor?
Q: How much current is drawn to the 12-V source? What is the voltage on each resistor?
A:
Q: Given two vectors Y = -ax + 7ay - 7az and S = -4ax - 8ay + 8az, find the angle between Y and S using…
A:
Q: A spectrum analyzer is used to measure the magnitude of a certain signal with respect to its…
A: The modulation depth is also known as Modulation scheme. Which can be expressed as the extent of…
Q: Part II. In the given circuit below, determine the current flowing through each resistors using;…
A:
Q: the POS and SOP of F(A, B, C, D) = Σ(4, 12, 7, 2, 10): d(0, 6, 8).
A: We need to find out POS and SOP for given Boolean function
Q: With a maximum frequency deviation of 75 kHz, what is the maximum phase deviation that can be…
A: Given: maximum frequency deviation, δ=75 kHz
Q: DISCUSSION The subject is foundations and communications 1. For the pass-band filter of Fig. (6) R2…
A: The circuit diagram for the pass band filter is shown below,
Q: Consider the angle modulated signal: v(t) = 10 cos [2πx108t + 3 cos(2πx103t)] Assume that the…
A:
Q: 1. What is the minimum conductor ampacity, overload protection, and dual-element fuse rating for a…
A: Determine the minimum current ampacity of conductor is, Iminimum=Ifl125100=115125100=143.75 mA
Q: How much current is flowing thru a lamp having a 60 ohm resistance when connected across a 110 volt…
A:
Q: Homework 1 An initially uncharged 1-mF capacitor has the current shown below across it. Calculate…
A: This question belongs to circuit theory . It is based on the concept of voltage across the capacitor…
Q: Repeat problem 54 if a 22- resistor is added between VE2 and ground.
A: The required parameters can be calculated by using the DC analysis and AC analysis of the Darlington…
Q: Calculate the equivalent capacitance, the equivalent charge, V1234, V67, and Q6.
A:
Q: I need handwritten otherwise i will dislike and want explanation with zero plag please in your own…
A: Given, We have two questions a and b. Please find the below attachments for the clear explanation.
Q: Y Compute the admittance in millisiemens if R = 18 ohms XL = 23 ohms %3D Xc = 29 ohms all
A: This question belongs to circuit theory . It is based on the concept of calculation of admittance of…
Q: How long does it take for the conductors to reach the threshold temperature in a short circuit?…
A: The maximum operating temperature for the given conductor is, T1=70 oC. The cross-sectional area of…
Q: All answers should be written in complete sentences. Calculations should be shown in detail, and…
A: FIND: which NEC table is used to determine the full
Q: 5. Determine lc and VCE in the pnp emitter bias circuit. Assume 6pc = 150 VEE +10 V RE 470 N RB 10…
A:
Q: When a fault occurs, Select one: O A. the generator terminal voltage does not change immediately O…
A:
Q: 2z° + 6z + 5z + 1 2(2z + 1)
A:
Q: TABLE OF RESISTIVITY: Fill out the table and compare the resistance of the following:
A:
Q: 27. Determine the capacitance required to establish a capaci- tive reactance that will match that of…
A: This question belongs to circuit theory . It is based on the concept of capacitive reactance and…
Q: In stepper motor, the number of digital pulses required to obtain half of one complete revolution…
A: Given data: Step angle= 1.50 Total angle in one revolution = 3600
Q: Maximum power capacity 15 kVa, rated voltage 2300 (primary) / 230 (secondary) volts. The respective…
A:
Q: What is the major difference between a bipolar and a unipolar device
A: Bipolar Device: It is a device that uses both electrons and holes as a charge carrier. It is made…
Q: Determine the value of the capacitor to be connected in parallel with ZL (load) in order to correct…
A: In this question, We need to determine the value of the capacitor to be connected in parallel with…
Q: Determine the overall noise factor and noise figure for the cascaded amplifier: A1=3 dB, A2= 13DB,…
A:
Q: B = 60 10 uF 10 uF Vo 2.4 kQ 1.2 kQ 10 V 4 V wwH-
A:
Q: In case of PD-control, a. the derivative term looks at the past of the error. b. the effect of…
A: Any control system is defined by the transfer function. The system is desired to produce desired…
Q: * Given the circuit Figure 3, using Thevenin's theorem, determine the current through the 4-2…
A:
Q: *6.66 For the circuit shown in Fig. P6.66, find the labeled node voltages for (a) ß= ∞ (b) B= 100
A: aTaking the value of β=∞Writing expression of ββ=IcIB∞=IcIBIB=Ic∞ =0 AFor a transistor the…
Q: Electronic circuits Show the neat solution and explain. Thank you
A: Resistors, inductors and capacitors are the main components of any electrical circuit. A source,…
Q: R7 Os tovo Quo The circuit in Figure 3 shows a simple multi-stage BJT op-amp, consisting of three…
A: Given: The circuit the figure below shows a simple multi-stage BJT op-amp, consisting of three…
Q: Sketch the electronic symbol (schematic) for the following components/ devices. Briefly describe the…
A: For the following components, The electronic symbol and the function of the electronic component is…
Q: The largest current source of renewable energy is which of the following: geothermal wind…
A: Geothermal: The geothermal energy is the energy that is obtained from the heat of the water that is…
Q: All answers should be written in complete sentences. Calculations should be shown in detail, and…
A: Givensupply voltage=230 vname plate full lod current=185 Apower=75 hppower factor=80%
Q: system with 16 bits address bus can access 2^16 memory space. Estimate the size of each memory IC…
A: In this question we will find size of memory....
Q: Determine Rout (in kl2) for the figure. Ipss= 10 mA Vp=-4 V 4.7 kM 10 V o M Mw0-2.5 V 2 ΜΩ
A: We need to find out output impedance of given circuit
Q: 3. Determine the nodal voltages for the networks in Figure? 1,- 3AZ0 anee 40 20 I-SAZ 30
A:
Q: 30. Find the average power loss and power factor for each of the circuits whose input current and…
A:
Q: Two wattmeters indicate 15 kW and 6 kW, respectively, when connected to measure the input power to…
A:
Q: Vos impact on 2 ampOps For the above circuit, determine the LITERAL equation of the output voltage…
A: The given circuit is as shown below,
Q: How many NAND gates is needed for this boolean function? F=A+AB’+AB’C
A:
Q: An input voltage of 2 Vrms (measured from base to ground) is applied to the circuit of the figure.…
A: The following circuit diagram is given:
Q: D6.3. A conducting cylinder with a radius of 1 cm and at a potential of 20 V is parallel to a…
A: It is given that:r=1cm=0.01m V=20V h=5cm=0.05mεr=4.5
Q: Convert each of the following transfer function into its lifference equation z? – 1 z2 + 1.3z+0.36…
A:
Q: 12. Consider a battery having Ví = 300V. We measure V1 known resistance Ro = 150kN on the…
A: Given information: A battery has a value of EMF Vb=300 Volts. Since nothing is mentioned we are…
Q: s? – o? 1) f(t)=tcos(ot) Ans. F(s)= (s² + w* }
A:
Q: Show your solutions. Coded Resistors Resistance and Tolerance Red, yellow, orange, and gold 24 x 10³…
A:
Q: Directional Overcurrent Relay
A: Power system has loads and sources present. They can be balanced and unbalanced. The fuse and the…
Step by step
Solved in 2 steps with 2 images
- Incandescent lighting of 500 W is connected in parallel with an inductive load. A clamp-on ammeter reveals a total circuit current of 7 A. What is the inductance of the load connected in parallel with the incandescent lights? Assume a voltage of 120 V and a frequency of 60 Hz.You find that a 25-F capacitor connected to 480 VAC is defective. The storeroom has no capacitors with a 480-VAC rating. However, you find two capacitors rated at 50 F and 370 VAC. Can these two capacitors be connected in such a manner that they can replace the defective capacitor? If yes, explain how they are connected and why the capacitors will not be damaged by the lower voltage rating. If no, explain why they cannot be used without damaging the capacitor.A 15-F AC capacitor is connected in series with a 50 resistor. The capacitor has a voltage rating of 600 WVDC. The capacitor and resistor are connected to a 480-V, 60-Hz circuit. Is the voltage rating of the capacitor sufficient for this connection?
- Two capacitors having values of 80 F and 60 F are connected in series. What is the total capacitance?What is the equivalent inductance for the series and parallel combinationsAn inductor of 230 milli Henry, a capacitor of 15 micro farad and a 200 ohm resistor are in series across a 36 V and 60 Hz voltage source. Find the total current a. 150 mA b. 0.164 A c. 0.2 A d. 170 mA
- What is the equivalent resistance ?? and what is the total inductance ??Determine the equivalent inductance and equivalent current of the inductive circuit in Figure Q4. If L5 is replaced with a capacitor of 0.5 mF, how would it affect the branch current? The alternating Voltage source has an amplitude of 20 Vm. Vm Sine 50 Hz L1 5 mH L2 3 mH cele rele Figure Q4 rele celer L3 6.6 mH L4 2.8 mH reler L5 7 mHA 100mH pure inductance is connected in a parallel with a 40ohms resistor. What is the power drawn if the voltage is 220volts and 60hz?
- Two identical coupled inductors are connected in series. The measured inductances for the two possible series connections are 380 microH and 240 microH. Their mutual inductance in microH is ?An inductor and resistor are connected in parallel to a 120-V, 60-Hz line. The resistor has a resistance of 50 ohms, and the inductor has an inductance of 0.2 H. What is the impedence through the circuit?1. Find the equivalent inductance. Assume all inductors are 10mH. Lea vle elll ell rell