. What factors can affect a solute's Rf value in thin-layer chromatography? 2. Why is it necessary to follow these steps when conducting the experiment? -No contact with the TLC plate should be made with bare hands. -Spots should have a diameter of no more than 1 mm. -Allow sufficient solvent to saturate the chromatography chamber

Q: Examine the above reactions (RXN 1-6). Give the name for each Electrophilic Addition Reactions (AE)....

A: Given : structures of reactants and products. 

Q: What is the empirical formula for a compound containing 55.27% Tin 14.93% sulfur and the remainder o...

A:

Q: N°H HO -HN

A: We have to write the reaction if occurred.

Q: For the molecule seen below answer the following questions CH3 H. Provide the most stable chair conf...

A:

Q: Calculate the pH of a 7.51 M solution of HBrO. The K, of HBRO is 2.50 x 10.

A: pH = -log[H+]  Ka for an acid is the ratio of  product of concentration of products raised to their ...

Q: What do you call the layer that balances out the charge of the layer directly covering the core of t...

A:

Q: In the beginning of the procedure, you will combine 1g of 3-nitrophthalic acid along with 2 mL of 8%...

A:

Q: Copper(II)-ammonia system 1. Place 1 mL 0.1 M CUSO̟ into a test tube. Then, add 5 drops 1. 00 M NH,....

A: Here we have to write observation and net ionic reaction of Cu2+-ammonia system

Q: Chromate-dichromate system 1. Prepare a clean spot plate and label four wells. Place 5 drops of 0. 1...

A: To complete the table with observations:

Q: Indicate the oxidation state of the underlined element in the following species. Show all pertinent ...

A:

Q: Is the purpose of the reagent blank during spectroscopy to give the instrument time to “warm up” so ...

A: In spectrophotometry, the signal produced by the reagent blank plays an important role in increasing...

Q: Which of the following bonds is the most polar bond? A) C –C B) C –O C) C –H D) C –Cl E) C –N Which...

A: Given:-   Which of the following bonds is the most polar bond?A) C –C B) C –O C) C –H D) C –Cl E) ...

Q: Predict the two major organic products from the following reaction. (Select all apply, Points will b...

A: This reaction is electrophilic aromatic substitution reaction in which benzene ring acts as nucleoph...

Q: Calculate A E for the reaction below at 25 *c. Sio 2(8) + 4HF(aq) SIF al0) + 2H 20 (1) -010.0 -320.8...

A:

Q: A 25.00 mL sample of phosphoric acid (H3PO4) is titrated to the equivalence using 19.71 mL of 0.2056...

A: Answer: In acid-base reaction, neutralization takes place where hydrogen ions and hydroxide ions com...

Q: %23 H H CHs H-C-ć-H CH3 H-C-c-H HC=O НС—о н ОН Но H ČH,OH ČH,OH 2 CI CI CI H C = C C = C 6. нн H CI ...

A: Answer: When two molecules have same molecular formula but different structural formula or spatial o...

Q: 2/5 Liquid hexane (CH3(CH2)¸CH3) reacts with gaseous oxygen gas (0,) to produce gaseous carbon dioxi...

A:

Q: Question 4 A catalyst can the rate of a reaction by providing an alternative pathway with a activati...

A: Activation energy is the minimum amount of energy that is required for chemical reaction to occur.

Q: Define alkynes.

A: Answer: Different type of hydrocarbons are present in nature and we classify them on the basis their...

Q: i) Explain why polypropylene is mainly produced by the coordination polymerization, but not by the f...

A: Since you have asked multiple question, we will solve the first question for you. If you want any sp...

Q: 2. How to find what a materials crystal structure is? (FCC, BCC or neither FCC or BCC or others)

A: Please find your solution below : Crystal structure is an ordered arrangement of atoms, ions or mole...

Q: Given the following reaction at equilibrium, if Kc = 5.84 x 10° at 230.0 °C, Kp =. 2NO (9) + 02 (9) ...

A: Consider the given information is as follows; Temperature (T) = 230.0°C = 230.0 + 273.15 = 503.15 K ...

Q: 6. What is the edge length of a simple cubic unit cell made up of atoms having a radius of 158 pm?

A:

Q: EQUATION WRITING: Balance the following redox reactions. Use change in oxidation state method (oxida...

A: Oxidation means loss of electrons and reduction means gain of electrons.

Q: 4. Rhodium has an atomic radius of 0.1345 nm and density of 12.41 g/cm³. Determine whether it has an...

A:

Q: Relating Density to Crystal Structure 1. Show that the atomic packing factor for FCC is 0.74. 2. Sho...

A:

Q: Atomic emission spectra are caused by: O Electrons moving from lower energy levels to higher energy ...

A: Answer of this question :-  Atomic emission spectra :- A series of bright lines, separated from each...

Q: What reagent would you use to distinguish between the aldehydes and ketones and indicate what you wo...

A: Answer: Aldehyde and ketones can be distinguished on the basis of the difference in their chemical p...

Q: CHC13, acetic anhydride H Conc. H2SO4 HO

A:

Q: The empirical formula a compound is C 2H 40 and its molecular weight was determined to be approximat...

A: Empirical formula is the simplest ratio of atoms present in molecule. Therefore ratio of elements C:...

Q: Calculate the mass percent by volume of 41.6 g of glucose (C₆H₁₂O₆, MM = 180.2 g/mol) in 325 mL of s...

A: The mass of solute in gram present in 100 mL solution is known as the mass percent concentration of ...

Q: What mass of Cu(NO 3) 2 can be prepared from the reaction of 1.75 grams of copper with 5.00 grams of...

A:

Q: use the attached NMR spectrum to generate the structural formula of the compound .Unknown NMR # 8 wa...

A: H1-NMR  analysis of methyl ketone:

Q: Which of the following statements is correct about the formation of emulsion? O Soaps and detergents...

A:                                 Answer  Which statement is correct about the formation of emulsion E...

Q: If there are 35g Oxygen in a pure sample of Silicon Dioxide (SiO3), how many grams of Silicon are pr...

A: Mole can be defined as a standard unit for measuring large quantities of very small entities such as...

Q: Calculate the amount of heat needed to melt 147. g of solid benzene (C,H) and bring it to a temperat...

A:

Q: Write a balanced ionic equation for this acid-base reaction: 2CsOH(aq)+H2SO4(aq)→ write net ionic e...

A: Given, a)  acid base reaction 2CsOH(aq) + H2SO4(aq)→ Balanced ionic equation = ? Net ionic equation ...

Q: Indicate the oxidation state of the underlined element in the following species. Show all pertinent ...

A:

Q: Synthesis . Show how you would carry out the following transformations. You may use any solvents, or...

A: Here we have to synthesize the given amino acid phenyl alanine by thalimide synthesis from given sta...

Q: Which of the following will lower the activation energy for a reaction? O increasing the concentrati...

A: In a given chemical reaction, the minimum amount of energy required by the reactant molecules to att...

Q: The polyatomic ion NO3‒ exhibits resonance. What is the bond order of nitrogen oxygen bond in NO3‒ ...

A:

Q: If a cycloalkene has 12 hydrogen atoms with a single double bond, how many carbon are in the structu...

A: Given :- A cycloalkene has total 12 hydrogen atoms and contains a C=C (double bond)  To determine :-...

Q: Determine the chirality of molecules 1, 2, and 3. Describe the relationship between them. HO SH HO,....

A: Since you have asked multiple questions, we will solve the first question for you as per our guideli...

Q: 10% (w/w) aqueous potassium iodide has a density of 1.202 g/ml. Which of the following statements is...

A: Molarity of solution is defined as number of moles of solute dissolved per litre of solution.

Q: + НОCH3 + H20 HO OCH3 H3CO OCH3 This reaction is classified as: addition substitution elimination cy...

A:

Q: 10 3H 3H 2H

A: We have to determine the structure of the molecule by using the NMR spectrum. The molecular formula ...

Q: Calculate the amount of heat needed to boil 122. g of hexane (C,H4), beginning from a temperature of...

A:

Q: Answer 5 onl

A: The unit cell for tin has tetragonal symmetry, with a and b lattice parameters of 0.583 and 0.318 nm...

Q: Explain why butter is solid in room temperature, while vegetable oil is liquid?

A: Fatty  acids  are the building blocks of  fat in  our bodies and in the food .

Q: For Problem no. 21-22 At elevated temperatures, dinitrogen pentoxide decomposes to nitrogen dioxide ...

A: