Bicyclic Lactone Lab Report

The objective of this lab was to create a ketone through an oxidation reaction using a using a secondary alcohol and oxidizing agent in order to use that ketone in a reduction reaction with a specific reducing agent to determine the affect of that reducing agent on the diastereoselectivity of the product. In the first part of this experiment, 4-tert-butylcyclohexanol was reacted with NaOCl, an oxidizing agent, and acetic acid to form 4-tert-butylcyclohexanone. In the second part of this experiment, 4-tert-butylcyclohexanone was reacted with a reducing agent, either NaBH4 in EtOH or Al(OiPr)3 in iPrOH, to form the product 4-tert-butylcyclohexanol. 1H NMR spectroscopy was used to determine the cis:trans ratio of the OH relative to the tert-butyl group in the product formed from the reduction reaction with each reducing agent. Thin-layer chromatography was used in both the oxidation and reduction steps to ensure that each reaction ran to completion.

Diels-Alder Reaction Objective: The objective of this experiment is to demonstrate a typical Diels-Alder reaction by reacting anthracene (diene) with maleic anhydride (dienophile) to produce 9,10-dihydroanthracene-9,10-α,β-succinc acid anhydride, the product. Scheme 1. Cycloaddition through the Diels-Alder Reaction1 Experimental: Anthracene (1.00 g, 5.61 x 10-3 mol), maleic anhydride, (0.75 g, 7.65 x 10-3 mol), and xylene (5.0 mL) were combined in a 10 mL long-necked, round-bottomed flask. A stir bar was added and an empty distillation column was attached to the flask to function as an air condenser. The mixture was refluxed for 40 minutes over a sand bath, ensuring the temperature was monitored to prevent the reflux ring from surpassing the

Enzymes are types of proteins that work as a substance to help speed up a chemical reaction (Madar & Windelspecht, 104). There are three factors that help enzyme activity increase in speed. The three factors that speed up the activity of enzymes are concentration, an increase in temperature, and a preferred pH environment. Whether or not the reaction continues to move forward is not up to the enzyme, instead the reaction is dependent on a reaction’s free energy. These enzymatic reactions have reactants referred to as substrates. Enzymes do much more than create substrates; enzymes actually work with the substrate in a reaction (Madar &Windelspecht, 106). For reactions in a cell it is

The goal of this experiment was to synthesize aspirin. In this experiment aspirin, also known as acetylsalicylic acid, was synthesized from salicylic acid and acetic anhydride. In the reaction the hydroxyl group on the benzene ring in salicylic acid reacted with acetic anhydride to form an ester functional group. This method of forming acetylsalicylic acid is an esterification reaction. Since this esterification reaction is not spontaneous, sulfuric acid was used as a catalyst to initiate the reaction. After the reaction was complete some unreacted acetic anhydride and salicylic acid was still be present in the solution as well as some sulfuric acid, aspirin, and acetic acid. Crystallization, which uses the principle of

Abstract: One mixture of two unknown liquid compounds and one mixture of two unknown solid compounds were separated, isolated, purified, and characterized by boiling point. Two liquid unknowns were separated, isolated, and purified via simple distillation. Then, the process of an acid-base extraction and washing were used to separate two unknown compounds into two crude compounds: an organic acid and a neutral organic compound. Each crude compound was purified by recrystallization, resulting in a carboxylic acid (RCO2H) and a pure organic compound (RZ). The resulting mass of the pure carboxylic acid was 1.688g with a percent recovery of 31.80%, the boiling range was 244-245 °C, and its density was 2.0879g/mL. The resulting mass of the pure organic solid was 2.4902g with a percent recovery of 46.91%, the boiling range was 52.0-53.4°C, and its density was 1.5956 g/mL.

Lactose is a sugar that can be put into smaller molecules, glucose and galactose. Lactose is when you are not able to digest milk and dairy meaning that the enzyme lactase that breaks down lactose is not functioning properly. ONPG was used as a substitute for lactase because even though it is colorless it helps show enzyme activity by turning yellow. This experiment measured the absorbance ONPG when exposed to lactase within an environment of different salinity’s. The enzyme, lactase, was obtained by crushing a lactaid pill and then was added into four cuvettes. ONPG and salt solution of different concentrations were added and their levels of absorption was measured by a spectrophotometer. The results showed that higher salt concentrations have a lower level of absorption. There were 4 cuvettes and within those cuvettes that solutions within them were being tested and the results showed the more salt solution added with the lactase the lower the absorbance. The less salt solution there was a higher rate of absorbance. The data supported the hypothesis that with increasing NaCl concentration there would be a decrease in enzyme activity.

Using SN1 reaction mechanism with hydrochloric acid, t-Pentyl alcohol was converted to t-Pentyl chloride in an acid catalyzed reaction. The reaction took place in a separatory funnel designed to separate immiscible liquids. The crude product was extracted by transferring a solute from one solvent to another. The process of washing the solutions by phase transfer was used in order to remove impurities from the main solvent layer. Finally, the crude product was dried with anhydrous Calcium chloride and purified once more by simple distillation technique.

1. Purpose: to clarify the mechanism for the cycloaddition reaction between benzonitrile oxide and an alkene, and to test the regiochemistry of the reaction between benzonitrile oxide and styrene.

In this experiment, the main objective was to synthesize a ketone from borneol via an oxidation reaction and secondly, to produce a secondary alcohol from camphor via a reduction reaction. Therefore, the hypothesis of this lab is that camphor will be produced in the oxidation reaction and isoborneol will be the product of the reduction reaction because of steric hindrance. For the oxidation step, a reflux will be done and then a microscale reflux for the reduction step. The products will be confirmed using Infrared spectroscopy, the chromic acid test, 2,4-DNP test and 13C NMR spectroscopy. The results of this

The dehydration of 2-methyl-2-butanol was performed using sulfuric acid and phosphoric acid in order to synthesize alkene products 2-methyl-1-butene and 2-methyl-2-butene. After carrying out steam distillation to isolate the organic alkenes from aqueous components within the reaction mixture, the purity and characterization of the products were then assessed through various analytical methods including Gas Chromatography (GC), Infrared Radiation (IR) Spectroscopy, and Nuclear Magnetic Resonance (NMR) Imaging. Through the characterization of the final products, it was found that little impurities remained in the final reaction solution and according to the GC, no alcohol remained in the vial after the reaction was complete. The actual yield

The reaction took place in a conical vial and .2mL of each of the reactant samples were added to it along with some 95% ethanol. Two drops of NaOH were added shortly after and stirred at room temperature for fifteen minutes. The vial was cooled in and ice bath and crystallized. Vacuum filtration was performed to filter the crude product. The crude product was recrystallized using methanol and filtered again. We made one change to the procedure and instead of using .7mL of ethanol we

“Enzymes are proteins that have catalytic functions” [1], “that speed up or slow down reactions”[2], “indispensable to maintenance and activity of life”[1]. They are each very specific, and will only work when a particular substrate fits in their active site. An active site is “a region on the surface of an enzyme where the substrate binds, and where the reaction occurs”[2].

An ester was synthesized during an organic reaction and identified by IR spectroscopy and boiling point. Acetic acid was added to 4-methyl-2-pentanol, which was catalyzed by sulfuric acid. This produced the desired ester and water. After the ester was isolated a percent yield of 55.1% was calculated from the 0.872 g of ester recovered. This quantitative error was most likely due to product getting stuck in the apparatus. The boiling point of the ester was 143° C, only one degree off from the theoretical boiling point of the ester 1,3-dimethylbutyl, 144 ° C. The values of the

In this experiment, a Fischer Esterification reaction was performed with two unknown compounds. The unknown compounds, Acid 2 and Alcohol D, were identified by using the knowledge of the reaction that took place, and the identity of the product that was synthesized. The identification of the product resulted from analysis of IR and NMR spectra.

Subsequently, 10mL of 3.5% H2O2 were added dropwise to the reaction mixture and was stirred for 20 minutes before heating to boiling at 80°C for 5 minutes. The reaction mixture was then taken off heat and allowed to cool undisturbed in an ice-bath for 30 minutes. Suction filtration was performed after to collect the crystals from the chilled solution The product was then washed with chilled 95% ethanol (2 x 15mL) and followed by diethyl ether (2 x 10mL). The crude product was then left to dry before recording the yield. 20mg of the crude product is then accurately weighed out and dissolved in deionized water in a 25mL volumetric flask. Deionized water was added to the volumetric flask to the mark and the UV-vis absorption spectrum of the crude product was recorded.